ignition BUICK REGAL 1998 Owner's Manual

0 Move the cruise switch from ON to WA. Hold it
there until you get up to the speed you want, and
then release the switch.
(To increase your speed in
very small amounts, move the switch to R/A for less
than half a second and then release it. Each time
you do this, your vehicle will go about
1 mph
(1.6 kmk) faster.)
The accelerate feature will
only work after you
set the cruise control speed by pushing the
SETKOAST button.
Reducing Speed While Using Cruise Control
There are two ways to reduce your speed while using
cruise control:
Push in the SETKOAST button until you reach the
lower speed you want,
then release it.
To slow down in very small amounts, push the SET
button for less than half a second. Each time you do
this, you’ll go
1 mph (1.6 km/h) slower.
Passing Another Vehicle While Using Cruise Control
Use the accelerator pedal to increase your speed. When
you take your foot off the pedal, your vehicle will slow
down
to the cruise control speed you set earlier.
Using Cruise Control on Hills
How well your cruise control will work on hills depends
upon your speed, load and the steepness of the hills.
When going up steep hills, you may have to step on the
accelerator pedal to maintain your speed. When going
downhill,
you may have to brake or shift to a lower gear
to keep your speed down. Of course, applying the brake
takes you out of cruise control. Many drivers find this to
be too much trouble and don’t use cruise control on
steep hills.
Ending Cruise Control
There are two ways to turn off the cruise control:
Step lightly on the brake pedal; OR
0 Move the cruise switch to OFF.
Erasing Cruise Speed Memory
When you turn off the cruise control or the ignition, or
shift into PARK (P)
or NEUTRAL (N), your cruise
control set speed memory is erased,
2-40
ProCarManuals.com

Exterior Lamps
The lamp controls are located on the instrument panel.
They control these systems:
0
0
0
a
0
0
0
0
0
Headlamps
Taillamps
Parking Lamps
License Lamps Sidemarker Lamps
Instrument Panel Lights
Courtesy Lamps
Fog Lamps
Cornering Lamps If
you pull the
knob out
halfway, it will turn on your
parking lamps and your
other operating lamps.
If
you pull the knob all the
way out, your headlamps
will then come on.
Push the
knob in all the way to turn off the lamps.
A warning chime will sound
if you open the driver’s
door when you turn the ignition switch to
OFF, LOCK
or ACCESSORY with the lamps on.
2-41
ProCarManuals.com

Daytime Running Lamps / Automatic
Headlamp Control
Daytime Running Lamps (DRL) can make it easier for
others to see the front of your vehicle during the day.
DRL can be helpful in many different driving
conditions, but they can be especially helpful in the
short periods after dawn and before sunset.
A light sensor on top of the instrument panel makes the
DRL work,
so be sure it isn’t covered.
The DRL system will make your front turn signal lamps
come on when:
The ignition is on,
The headlamp switch is off and
The parking brake is released. When
the DRL are on, only your front turn signal lamps
will be
on. The headlamps, taillamps, sidemarker and
other lamps
won’t be on. Your instrument panel won’t
be lit up either.
When it’s dark enough outside, your front turn signal
lamps
will turn off and your vehicle’s headlamps and
parking lamps will turn on.
The other lamps that come
on with your headlamps will also come on.
When it’s bright enough outside, your headlamps will
go
off and your front turn signal lamps will come on.
To idle your vehicle with the DRL off, set the parking
brake while the ignition
is in OFF or LOCK. Then start
your vehicle. The
DRL, headlamps and parking lamps
will stay
off until you release the parking brake.
As with any vehicle, you should turn on the regular
headlamp system when you need it.
ProCarManuals.com

Twilight Sentinel
Twilight Sentinel provides a period of exterior
illumination
as you leave the vicinity of your vehicle.
The feature is activated when your vehicle’s headlamps
are on due to the automatic headlamp control feature
described previously
in this section, and when your
vehicle’s ignition is turned off. Your headlamps will
then remain on until the headlamp switch
is moved from
OFF to the parking lamp position or until a 90 second
illumination period has elapsed.
If you turn off the ignition with the headlamp switch in
the parking lamp or headlamp position, the Twilight
Sentinel cycle will not occur.
You can customize the vehicle to activate the Twilight
Sentinel when your vehicle’s ignition is turned off under
the conditions described above, or you may choose
not
to activate this feature under any conditions. The
enabled/disabled
state of this feature will be toggled
when
you perform the following sequence with the
doors closed and the ignition key
in RUN:
1.
2.
3.
Press and hold the power door lock switch. While
holding the door lock switch, cycle the headlamp
switch
on and then off two times.
Release
the power door lock switch. These
operations must be carried out
in a time period of
less than 10 seconds, followed by a delay period of
no more than 10 seconds.
Then, press and hold
the power door unlock switch.
While holding the door unlock switch, cycle the
headlamp switch
on and then off two times. Release
the courtesy door unlock switch. These operations
must be carried out
in a time period of less than
IO seconds.
After releasing the door unlock switch, a single chime
will be heard if the Twilight Sentinel function has been
disabled; two chimes will be heard if the feature
has
been enabled. Disconnecting the vehicle’s battery for up
to a year will not change the programmed operation of
this feature.
2-43
ProCarManuals.com

dim after the delay time until they go out. The delay
time
is canceled if you turn the ignition key to RUN or
START,
so the lamps will dim right away.
When the ignition is on, Illuminated Entry
is inactive,
which means the courtesy lamps won’t come on unless a
door is opened.
Delayed Entry Lighting
Delayed Entry Lighting illuminates your vehicle’s
interior for
a period of time after all the doors have
been closed.
The ignition must be off for Delayed Entry Lighting to
work. Just after all the doors have been closed, the
Delayed Entry Lighting feature will continue to
work until:
0 The ignition is in RUN.
o The doors are locked.
0 An illumination period of 25 seconds has elapsed.
If during the illumination period
a door is opened, the
timed illumination period will be canceled and the
interior lamps will remain on since
a door is open.
Delayed Exit Lighting
This feature illuminates your vehicle’s interior for a
period of time after the ignition key is removed from
the ignition.
The vehicle’s ignition must be off for Delayed Exit
Lighting to work. When the ignition key is removed,
interior illumination will activate and remain
on until:
0 The ignition is in RUN.
The power door locks are activated.
An illumination period of 25 seconds has elapsed.
If during the illumination period
a door is opened, the
timed illumination period will be canceled and the
interior lamps will remain on since
a door is open.
2-45
ProCarManuals.com

Rearview Mirror Reading Lamps
(If Equipped)
Use the switch next to each ].amp to turn them on
and off.
Dome Lamp
The dome lamp will come on when you open the doors.
Battery Rundown Protection
Your vehicle has a feature to help prevent you from
draining the battery in case you accidentally leave the
interior courtesy lamps, reading/map lamps, visor vanity
lamps, trunk lamp, underhood lamp or glove box lamps
on.
If you leave any of these lamps on, they will
automatically turn
off after 20 minutes, if the ignition is
in
OFF. The lamps won’t come back on again until you:
Turn the ignition on,
0 Turn the lamp switch off, then on; or
Open a door.
Note that if your vehicle has less than
15 miles (25 km)
on the odometer,
the battery saver will turn off the lamps
after only three minutes.
Retained Accessory Power
With retained accessory power, your power windows,
audio system and sunroof will continue to work up to
10
minutes after the ignition key is turned to OFF and none
of the doors are opened.
2-46
ProCarManuals.com

Auxiliary Power Connection (Power Drop) service manual, see “Service Publications, Ordering” in
the Index.
Your vehicle is equipped
with an auxiliary
power connection.
I NOTICE:
Adding some electrical equipment to your vehicle
can damage
it or keep other things from working
as they should. This wouldn’t be covered by your
warranty. Check with your dealer before adding
electrical equipment and never use anything that
exceeds the fuse rating.
This feature provides power, ground and accessory
wires which can be accessed to add aftermarket
electrical equipment to your vehicle. It
is located on the
passenger’s side
of the vehicle, under the glove box,
and is labeled with a wire function and fuse rating.
For
information on accessing the connection and electrical
hookup, please refer
to your service manual. To order a
Astroroof (If Equipped)
Your vehicle may be equipped with an express-open
astroroof. It includes a sliding glass panel and a
one-piece sunshade. The control switch works only
when the ignition or
RAP is on. See “Retained
Accessory Power” in the Index. The control switch is
located overhead
on the headliner.
2-53
ProCarManuals.com

Air Bag Readiness Light
There is an air bag readiness light on the instrument
panel, which shows the air bag symbol. The system
checks the air bag’s electrical system for malfunctions.
The light tells you if there is an electrical problem. The
system check includes the air bag modules, the wiring
and the crash sensing and diagnostic module. For more
information on the air bag system, see “Air Bag” in
the Index.
This light will come
on
when you start your engine,
and it will flash for
a few
seconds. Then
the light
should
go out. This means
the system is ready.
If the air bag readiness light stays on after you start the
engine or comes on when
you are driving, your air bag
system may not work properly. Have your vehicle
serviced right away.
The air bag readiness light should flash for a few
seconds when you turn the ignition key to
RUN. If the
light doesn’t come on then, have it fixed
so it will be
ready
to warn you if there is a problem.
Charging System Light
4
+I
The charging system light
will come on briefly when
you turn on the ignition, as
a check to show you it’s
working. Then it should
go out.
If it stays
on, or comes on while you are driving, you
may have a problem with the charging system. It could
indicate that you have a loose drive belt or another
electrical problem. Have it checked right away. Driving
while
this light is on could drain your battery.
If you must drive a short distance with the light on, be
certain to turn
off all your accessories, such as the radio
and air conditioner.
2-60
ProCarManuals.com

Brake System Warning Light
Your vehicle’s hydraulic brake system is divided into
two parts. If one part isn’t working, the other
part can
still work and stop you. For good braking, though, you
need both parts working well.
If the warning light comes on, there is a brake problem.
Have your brake system inspected right away.
BRAKE
This light should come on
briefly when you turn the
ignition key to
RUN. If it
doesn’t come on then,
have it fixed
so it will be
ready to warn
you if there’s
a problem.
If the light comes on while you are driving, pull off the
road and stop carefully. You may notice that
the pedal is
harder
to push. Or, the pedal may go closer to the floor.
It may take longer to stop. If the light is still on, or if the
anti-lock brake system warning light is flashing, have
the vehicle towed for service. (See “Anti-Lock Brake
System Warning Light” and “Towing Your Vehicle” in
the Index.)
Your brake system may not be working properly
if the brake system warning light is on. Driving
with the brake system warning light
on can lead
to an accident. If the light
is still on or if the
anti-lock brake system warning light is flashing
after you’ve pulled off the road and stopped
carefully, have the vehicle towed for service.
When the ignition is on, the brake system warning light
will also come on when you set your parking brake. The
light will stay on if your parking brake doesn’t release
fully. If it stays on after your parking brake is fully
released, it means you have
a brake problem.
2-61
ProCarManuals.com

If the anti-lock brake system warning light stays on
longer than normal after you’ve started your engine, turn
the ignition off.
Or, if the light comes on and stays on
when you’re driving, stop as
soon as possible and turn
the ignition off. Then start the engine again to reset the
system. If the light still stays
on, or comes on again
while you’re driving, your vehicle needs service.
If the
light is on but not flashing and the regular brake system
warning light isn’t on,
you still have brakes, but you
don’t have anti-lock brakes.
The anti-lock brake system warning light should come
on briefly when you turn the ignition key to RUN. If the
light doesn’t come on then, have it fixed
so it will be
ready to warn you if there
is a problem.
Anti-Lock Brake System Active Light
LOW TRAC
When your anti-lock system
is adjusting brake pressure
to help avoid
a braking skid,
the anti-lock brake system
active light will come on.
Slippery road conditions may exist if this light comes
on,
so adjust your driving accordingly. The light will
stay
on for a few seconds after the system stops
adjusting brake pressure.
The anti-lock brake system active light also comes on
briefly when you turn the ignition key to
RUN. If the
light doesn’t come on then, have it fixed so it will be
there to tell you when the system is active.
2-63
ProCarManuals.com