differential BUICK ROADMASTER 1993 Owners Manual

How to Add Fluid:
Refer to the Maintenance Schedule to determine what
kind
of transmission fluid to use. See “Recommended
Fluids and.lLubricants” in the Index.
If the fluid level is low, add only enough of the proper
fluid to bring the level up to the COLD area for a cold
check or the
HOT area fora hot check. It doesn’t take
much fluid, generally less than a pint. Don’t overfill.
we
recommend you use only fluid labeled DEXRONBIIE,
because fluids with that label are made-especially for
you automatic transmission. Damage caused by fluid
other than DEXRON@IIE
is not covered by your new
vehicle warranty.
0 After adding fluid, recheck the fluid level as
described under “How to Check.77
0 When the correct-fluid level is obtained, push the
dipstick back in all the way.
Rear Axle
When to Check and Change Lubricant:
Refer to the Maintenance Schedule to determine how
often to check the lubricant and when to change it. See
“Periodic Maintenance Inspections” in the Index.
How to Check Lubricant:
If the level is below the bottom of the filler plug hole,
you’ll need to add some lubricant. Add enough lubricant
to raise the level to the bottom
of the filler plug hole.
What
to Use:
Standard Differential
Use Axle Lubricant (GM Part
No. 1052271) or SAE
80W-90 GL-5 gear lubricant.
Limited-Slip Differential
To add lubricant when the level is low, use Axle
Lubricant (GM Part
No. 1052271) or SAE 8OW-90
GL-5 gear lubricant.
To completely refill after draining,
add
4 ounces (1 18 ml) of Limited-Slip Differential
Lubricant Additive (GM Part
No. 1052358). Then fill to
the bottom of the filler plug hole with Axle Lubricant
(GM Part
No. 1052271) or SAE 80W-90 GL-5 gear
lubricant.

I USAGE
Chassis
Lubrication
Front Wheel Bearings
USAGE
Rear Axle (Standard
Differential)
FLUID/LUBRICANT
Chassis lubricant meeting
requirements of NLGI Grade
2,
Category LB. or GC-LB (GM Part
No. 1052497 or equivalent).
Wheel bearing lubricant meeting
requirements of NLGI Grade
2,
Category GC or GC-LB (GM Part
No. 1051344 or equivalent).
Axle Lubricant
(GM Part No.
1052271) or SAE 8OW-90 %L-5
Gear Lubricant.
Axle Lubricant (GM Part
No.
1052271) or SAE 80W-90 GL-5
Gear Lubricant, and Limited-Slip
DifferentialLubricant Additive (GM
Part
No. 1052358) or equivalent
where required. See “Rear Axle” in
the .Index.
GM Optikleen@ Washer Solvent
(GM Part No. 10515.15) or
equivalent.
FLUIDlLUBRICANT
Rear Axle (Limited-Slip
Differential)
Windshield
Washer Solvent Hood Latch
Assembly
a. Pivots and Spring
Anchor
b. Release Pawl
Hood and Door
Hinges
Fuel Filler Door Hinge, Rear
.Compartment
Lid Hinges,
Wagon Tailgate
Hinge, Rear Folding Seat
~~
Weatherstrips a. Engine oil.
b. Chassis lubricant meeting
requirements
of NLGI Grade 2,
Category LB ‘or GC-LB (GM Part
No.
12346003 or equivalent).
Engine oil or Lubriplate Lubricant
(GM Part No.
1050109).
Engine oil ox: Lubriplate Lubricatn
(GM’Part No.
1050109).
Dielectric Silicone Grease (GM Part
No. 12345579 or equivalent).
See “Specifications Chart” in the Index for
recommended replacement filters, valves and spark
plugs.
315