traction control CADILLAC CT6 2018 1.G Warranty Guide

Cadillac Limited Warranty and Owner Assistance Information (GMNA-
Localizing-U.S.-11348300) - 2018 - crc - 2/6/17
12 NEW VEHICLE LIMITED WARRANTY
Repair
If possible, components will be
repaired or replaced, and the original
battery will be returned to the vehicle.
Replace (If Necessary)
Under warranty, the high voltage
battery will be replaced with either a
new or factory reconditioned high
voltage battery with an energy
capacity (kWh storage) level at or
above that of the original battery prior
to the failure.
Your CT6 PLUG-IN battery warranty
replacement may not return your
vehicle as an“as new”condition, but
it will make your CT6 PLUG-IN fully
operational appropriate to its age and
mileage.
Electric Propulsion Components
High Voltage Wiring, Hybrid
Powertrain and Battery Control
Modules, E-Compressor, Traction
Power Inverter Module (TPIM),
Accessory Power Module (APM), and
Electric Propulsion On-Board Charger.
Brakes
Brake Modulator Assembly Electric Drive Unit
Electric drive unit assembly and
internal components, including the
transmission fluid pump, transmission
fluid pump controller, electric motor,
and 3-phase cables.
What Is Not Covered
In addition to the
”What is Not
Covered“ section previously, the CT6
PLUG-IN warranty does not cover the
following items:
Wear Items
Wear items, such as brake linings, are
not covered in the CT6 PLUG-IN
warranty.
Improper Storage
High voltage battery replacement due
to improper vehicle storage. Refer to
the owner manual for the proper ways
your vehicle’s battery must be
maintained if the vehicle is not driven,
or if it is stored for an extended
period of time.

Cadillac Limited Warranty and Owner Assistance Information (GMNA-
Localizing-U.S.-11348300) - 2018 - crc - 2/6/17
24 EMISSION WARRANTY PARTS LIST
Fuel Tank(s) *
Fuel Tank Filler Pipe (with restrictor)
Fuel Tank Vacuum or Pressure Sensor
Start/Stop System
Auxiliary Battery or Ultra Capacitor
Battery Isolator
Battery Control Module
Multifunction Power Supply Converter
Transmission Fluid Accumulator and
Solenoid
Hybrid
ACCM Hood Switch
Auxiliary Transmission Fluid Pump
Battery Control Module **
Battery Cooling Circuit
Battery Pack Current Sensor
Brake Pedal Travel Sensor
Charge Port
Charge Port Switches and Sensors
Drive Motor/Generator Control
Module **
Drive Motors and Resolvers *Eboost Brake Control Module **
Electro-Hydraulic Brake Control
Module **
Energy Storage Control Module **
Exhaust Heat Exchanger
Fuel Fill Door Sensors
High Voltage Battery Contactor
Hybrid Batteries *
Hybrid Battery Temperature and
Voltage Sensors
Hybrid EVAP Canister Assembly
Hybrid RESS Thermal Management:
Air and Coolant Sensors
Battery Coolant Pumps and
Cooling Fans
Battery High Voltage Heater
Battery Temperature Sensors
E-compressor * **
Power Electronics Coolant Pump
Port Valves
Rfg. Temperature and Pressure
Sensors
Internal Mode Switch (IMS)
Onboard Charger * ** SGCM Coolant Circuit (fan,
relay, pump)
Starter Generator *
Starter Generator Control Module **
Starter Generator Drive Belt
Traction Power Inverter
Module (TPIM) **
Vehicle Interface Control Module **
Wheel Speed Sensor
Miscellaneous Items Used with
Above Components and Certain
Tires are Covered
Belts
Boots
Clamps
Connectors
Ducts
Fittings
Gaskets
Grommets
Hoses
Housings
Mounting Hardware