CADILLAC CTS V 2007 1.G Owners Manual

From the inside, use the
manual lock levers
located on the door
panels near the
windows.
Push down on the manual lock lever to lock the
door. To unlock the door, pull up on the lever.
Central Door Unlocking System
Your vehicle has a central door unlocking feature.
When unlocking the driver’s door, you can
unlock the other doors by holding the key in the
turned position for a few seconds or by quickly
turning the key twice in the lock cylinder.
Power Door Locks
The power door lock
switches are located
on the front doors.
Press the bottom part of the power door lock
switch to lock or the top of the switch to unlock all
the doors at once.
The rear doors do not have power door lock
switches. You must use the manual levers to
lock and unlock the rear doors when riding in
the rear seat.
101

Delayed Locking
With this feature, you can delay the actual locking
of the doors.
When the power door lock switch or the lock
button on the Remote Keyless Entry (RKE)
transmitter is pressed when the key is not in the
ignition and the driver’s door is opened, a
chime will sound three times indicating that
delayed locking is active.
When all the doors are closed, the doors will lock
automatically after ve seconds. If a door is
reopened before ve seconds have elapsed, the
ve second timer will reset itself once all the doors
are closed again.
You can press the door lock switch or the lock
button on the RKE transmitter again to override
this feature and lock the doors immediately.
You can turn this feature off using the Driver
Information Center (DIC). When delayed locking is
off, the doors will lock immediately when you
press the power door lock switch or the lock button
on the RKE transmitter. SeeDIC Vehicle
Personalization on page 242for more information.
Programmable Automatic Door Locks
If your vehicle has an automatic transmission,
the vehicle is programmed so that the doors will
lock automatically when all doors are closed,
the ignition is on, and the shift lever is moved out
of PARK (P). The doors will automatically
unlock when you stop the vehicle and move the
shift lever back into PARK (P).
If your vehicle has a manual transmission, the
vehicle is programmed so that the doors will lock
automatically after the vehicle speed reaches
5 mph (8 km). The doors will automatically unlock
when the ignition is turned off and the key is
removed from the ignition.
If someone needs to exit the vehicle once the
doors are locked, have that person use the manual
lever or power door lock switch. When the door
is closed again, it will not lock automatically.
Use the manual lever or the power door lock
switch to lock the door.
The power door locks can be programmed
through prompts displayed on the Driver
Information Center (DIC). These prompts allow
you to choose various lock and unlock settings.
For more information on programming, see
DIC Vehicle Personalization on page 242.
102

Rear Door Security Locks
Your vehicle has rear door security locks that
prevent passengers from opening the rear doors
on your vehicle from the inside.
The rear door security
locks are located on the
inside edge of each
rear door. You must
open the rear doors to
access them.
To use these locks, do the following:
1. Insert your key into the slot next to the rear
door security lock label and turn it to engage
the lock.
2. Close the door.
3. Repeat the steps for the other rear door.The rear doors on your vehicle cannot be opened
from the inside when this feature is in use.
When you want to open a rear door when the
security lock is on, do the following:
1. Unlock the door using the Remote Keyless
Entry (RKE) transmitter, the front door power
lock switch or by lifting the rear door
manual lock.
2. Then open the door from the outside.
To cancel the rear door security lock, do the
following:
1. Unlock the door and open it from the outside.
2. Insert your key into the slot next to the
rear door security lock label and turn it
to disengage the lock.
3. Repeat the steps for the other lock.
The rear door locks will now work normally.
103

Lockout Protection
If you press the power door lock switch when the
key is in the ignition and any door is open, all
the doors will lock and only the driver’s door will
unlock. If you close the doors, you can lock
them using the remote keyless entry transmitter.
Be sure to remove the key from the ignition
when locking your vehicle.
This feature can be overridden by pressing
the lock button on the remote keyless entry
transmitter or by pressing the power lock switch
a second time.
Trunk
{CAUTION:
It can be dangerous to drive with the
trunk lid open because carbon monoxide
(CO) gas can come into your vehicle.
You cannot see or smell CO. It can cause
unconsciousness and even death. If you
must drive with the trunk lid open or
if electrical wiring or other cable
connections must pass through the seal
between the body and the trunk lid:
Make sure all other windows are shut.
Turn the fan on your heating or
cooling system to its highest speed
and select the control setting that will
force outside air into your vehicle.
See Climate Control System.
If you have air outlets on or under
the instrument panel, open them all
the way.
SeeEngine Exhaust on page 134.
104

Trunk Lock Release
The remote trunk
release button is located
on the lower portion
of the driver’s door.
To use the remote trunk release, the shift lever
must be in PARK (P) or NEUTRAL (N) for a
vehicle with an automatic transmission. The shift
lever must be in NEUTRAL, with the parking brake
set for a vehicle with a manual transmission.
Press the button to open the trunk. You can also
press the button with the trunk symbol on the
Remote Keyless Entry (RKE) transmitter to open
the trunk.
If your vehicle is ever without power, you can still
access the trunk area. Use one of the following
procedures to manually open the trunk.If your vehicle has the rear seat pass-through
door, do the following:
1. Fold the rear armrest down and open the
pass-through door. See “Rear-Seat Pass
Through” following for more information.
2. Reach upward through the opening to locate
the emergency trunk release handle.
See “Emergency Trunk Release Handle” for
more information.
3. Pull forward on the trunk release handle to
open the trunk lid.
If your vehicle has the split folding rear seat,
do the following:
1. Fold down the rear seatback. SeeSplit
Folding Rear Seat on page 18for more
information.
2. Reach upward through the opening to locate
the trunk release handle.
3. Pull forward on the trunk release handle to
open the trunk lid.
105

Rear-Seat Pass Through
If your vehicle has the rear seat-pass through
door, you can access the trunk without opening
the trunk lid. This is especially useful when
transporting long items.
To open the door, pull down the rear seat armrest.
Then pull the lever all the way down to release
the door.
To close the door, push it up and back into place.
Then try to open the door without pulling up on
the lever to make sure it is locked into place.
Emergency Trunk Release Handle
Notice:Do not use the emergency trunk
release handle as a tie-down or anchor point
when securing items in the trunk as it
could damage the handle. The emergency
trunk release handle is only intended to aid a
person trapped in a latched trunk, enabling
them to open the trunk from the inside.
There is a glow-in-the-dark emergency trunk
release handle located on the back wall of the
trunk. This handle will glow following exposure to
light. Pull the release handle toward the front
of the vehicle to open the trunk from the inside.
106

Windows
{CAUTION:
Leaving children, helpless adults, or pets
in a vehicle with the windows closed is
dangerous. They can be overcome by the
extreme heat and suffer permanent
injuries or even death from heat stroke.
Never leave a child, a helpless adult, or a
pet alone in a vehicle, especially with the
windows closed in warm or hot weather.
107

Power Windows
{CAUTION:
Leaving children, helpless adults, or pets
in a vehicle with the windows closed is
dangerous. They can be overcome from
extreme heat in warm or hot weather and
suffer permanent injuries or even death
from heat stroke.
Leaving children in a vehicle with the
ignition key is dangerous for many
reasons, children or others could be badly
injured or even killed. They could operate
the power windows or other controls or
even make the vehicle move. The windows
will function with the keys in the ignition
and they could be seriously injured or
killed if caught in the path of a closing
window. Do not leave keys in a vehicle
with children.
CAUTION: (Continued)
CAUTION: (Continued)
When there are children in the rear seat use
the window lockout button to prevent
unintentional operation of the windows.
The power window
switches are located on
the armrest near
each window.
Press the up or down arrows on the switches to
raise or lower the windows.
108

Your vehicle has Retained Accessory Power (RAP)
that allows you to use the power windows for
up to 10 minutes once the ignition has been turned
off. For more information, seeRetained Accessory
Power (RAP) on page 119.
Express-Down Window
Press the down arrow on the switch to the second
position to activate the express-down feature.
To stop the window as it is lowering, press
the down arrow on the switch again.
Express-Up Window
This feature is only on front power windows. Press
the up arrow on the switch to the second position
to activate the express-up feature. To stop the
window as it is raising, press the up arrow again.
Programming the Power Windows
If the battery on your vehicle has been recharged,
disconnected, or is not working, you will need to
reprogram each front power window for the
express-up feature to work. Before reprogramming,
replace or recharge your vehicle’s battery.To program each window, follow these steps:
1. With the ignition in ACCESSORY, ON or when
Retained Accessory Power (RAP) is active,
press and hold the down arrow on the
power window switch until the window has
fully opened.
2. Press the up arrow on the power window
switch until the window is fully closed.
3. Continue holding the up arrow on the switch
for approximately two seconds after the
window is completely closed.
The window is now reprogrammed. Repeat the
process for the other front window.
Express Window Anti-Pinch Feature
If any object is in the path of the window when the
express-up is active, the window will stop at the
obstruction and automatically reverse to a preset
factory position. Weather conditions such as
severe icing may also cause the window to
automatically reverse. The window will return to
normal operation once the obstruction or condition
is removed.
109

Express Window Anti-Pinch Override
{CAUTION:
If express override is activated, the
window will not reverse automatically.
You or others could be injured and the
window could be damaged. Before you
use express override, make sure that all
people and obstructions are clear of the
window path.
In an emergency, the anti-pinch feature can be
overridden in a supervised mode. Hold the window
switch all the way down in the express position.
The window will rise for as long as the switch
is held. Once the switch is released, the express
mode is re-activated.
In this mode, the window can still close on an
object in its path. Use care when using the
override mode.
Window Lockout
This feature allows you to disable the passenger
window switches.
The passenger window
lockout button is located
below the power window
switches on the driver’s
door armrest.
Press the button to disable the passenger window
controls. The light on the button will illuminate,
indicating that the feature is in use. The passenger
windows still can be raised or lowered using the
driver’s window switches when the lockout feature
is active.
To restore power to the passenger windows, press
the button again. The light on the button will go out.
You can program this feature to disable all
passenger windows or only the rear passenger
windows. SeeDIC Vehicle Personalization
on page 242for more information.
110