lock CADILLAC DEVILLE 1997 7.G Manual PDF
[x] Cancel search | Manufacturer: CADILLAC, Model Year: 1997, Model line: DEVILLE, Model: CADILLAC DEVILLE 1997 7.GPages: 386, PDF Size: 21.61 MB
Page 237 of 386

Downloaded from www.Manualslib.com manuals search engine Hitches Safety Char I 
You should  always  attach  chains  between  your  vehicle 
and  your  trailer.  Cross  the  safety  chains  under  the  tongue 
of  the  trailer 
so that  the tongue  will  not  drop  to the  road 
if  it becomes  separated  from  the hitch.  Instructions 
about  safety  chains  may be  provided  by  the  hitch 
manufacturer  or by  the  trailer  manufacturer.  Follow  the 
manufacturer’s  recommendation  for attaching  safety 
chains  and  do  not  attach  them  to the  bumper.  Always 
leave  just enough  slack 
so you can turn  with  your  rig. 
And,  never  allow  safety  chains  to drag  on  the  ground. 
It’s  important  to  have  the  correct  hitch  equipment. 
Crosswinds,  large  trucks  going  by and  rough  roads  are  a 
few  reasons  why you’ll  need  the  right  hitch.  Here 
are 
some  rules  to  follow: 
e 
e 
e 
The  bumpers  on  your  vehicle  are not  intended  for 
hitches. 
Do not  attach  rental  hitches  or  other 
bumper-type  hitches  to  them.  Use  only  a 
frame-mounted  hitch  that  does  not  attach  to 
the  bumper. 
If you’ll  be  pulling a trailer  that,  when  loaded,  will 
weigh  more  than 
2,000 lbs. (900 kg),  be  sure  to  use  a 
properly  mounted,  weight-distributing  hitch  and  sway  control  of the  proper  size.  This  equipment 
is 
very  important  for proper  vehicle  loading  and  good 
handling  when  you’re  driving. 
Will  you  have  to  make  any  holes  in  the  body  of  your  vehicle  when  you install 
a trailer  hitch?  If  you do, 
then  be  sure  to  seal  the  holes  later  when  you  remove 
the  hitch.  If  you don’t  seal  them,  deadly  carbon 
monoxide 
(CO) from  your  exhaust  can  get  into your 
vehicle  (see  “Carbon  Monoxide”  in  the  Index).  Dirt 
and  water  can,  too. 
Trailer  Brakes 
Because  you  have  anti-lock  brakes,  don’t  try  to tap  into 
your  vehicle’s  hydraulic  brake  system. 
If you  do,  both 
brake  systems  won’t  work  well, 
or at  all. 
Be  sure  to read  and  follow  the  instructions  for  the trailer 
brakes 
so you’ll  be  able  to  maintain  them  properly.   
Page 254 of 386

Downloaded from www.Manualslib.com manuals search engine When your  vehicle  is being towed,  have the ignition  key 
turned  to  the 
OFF position. The steering  wheel  should 
be clamped  in a  straight-ahead  position,  with  a clamping 
device designed for towing  service.  Do  not  use the 
vehicle’s  steering  column lock 
for this. The transaxle 
should be 
in NEUTRAL (N) and  the parking 
brake  released. 
Don’t  have your  vehicle  towed  on  the drive  wheels 
unless  you  must. 
If the  vehicle  must  be towed  on  the 
drive  wheels,  be sure  to follow  the speed  and  distance 
restrictions  later  in 
this section or your  transaxle  will  be 
damaged. 
If these  limitations  must  be exceeded, then the 
drive  wheels  have to be supported on  a  dolly. 
Front Towing 
Tow Limits -- 35 mph (56 kph), 25 miles (40 km) 
5-11   
Page 265 of 386

Downloaded from www.Manualslib.com manuals search engine NOTICE: 
In cold  weather,  water  can  freeze and  crack  the 
engine,  radiator,  heater  core  and  other  parts. 
So 
use the  recommended  coolant. 
I 
You can  be burned if you  spill  coolant  on  hot 
engine  parts.  Coolant  contains  ethylene  glycol 
and  it  will burn 
if the  engine  parts  are  hot 
enough.  Don’t spill  coolant  on 
a hot engine. 
1. You  can remove  the  coolant  surge  tank  pressure  cap 
when  the  cooling  system,  including  the  coolant  surge 
tank  pressure  cap  and  upper  radiator  hose,  is  no 
longer  hot.  Turn  the  pressure  cap  slowly 
counterclockwise 
until it  first  stops.  (Don’t  press 
down  while  turning  the  pressure  cap.) 
If you  hear a hiss,  wait  for that  to  ston A hiss means 
there  is still  some  pressure  left. 
5-22   
Page 268 of 386

Downloaded from www.Manualslib.com manuals search engine If a Tire Goes Flat 
It’s unusual for a  tire  to  “blow  out”  while you’re driving, 
especially  if  you  maintain your  tires  properly. 
If air  goes 
out 
of a  tire,  it’s  much  more  likely  to  leak  out  slowly. 
But  if  you  should  ever have a “blowout,”  here  are a few 
tips  about  what  to  expect and  what  to  do: 
If  a front  tire fails,  the flat  tire  will  create a drag  that 
pulls  the vehicle  toward  that  side.  Take  your foot off  the 
accelerator  pedal  and  grip  the  steering  wheel  firmly. 
Steer  to maintain lane  position,  and then gently  brake  to 
a stop  well out of the  traffic  lane. 
A rear  blowout,  particularly  on  a curve,  acts  much  like a 
skid  and  may  require  the  same correction  you’d  use  in  a 
skid. In  any  rear blowout, remove  your  foot  from the 
accelerator  pedal.  Get the  vehicle  under  control  by 
steering  the way  you  want  the  vehicle  to  go. It  may  be 
very  bumpy  and noisy,  but  you  can  still steer.  Gently 
brake  to a stop 
-- well  off the  road if possible. 
If  a tire  goes flat, the  next  part shows how  to  use  your 
jacking equipment  to change a flat  tire  safely. 
Changing a Flat Tire 
If a tire  goes  flat, avoid  further  tire  and  wheel  damage 
by  driving  slowly 
to a level  place.  Turn  on  your  hazard 
Wi * 
; flashers. 
I- 
Changing  a  tire  can  cause  an  injury.  The  vehicle 
can  slip 
off the  jack  and  roll  over you or  other 
people.  You and  they  could be badly  injured. 
Find 
a level  place  to  change  your  tire. To help 
prevent  the  vehicle from moving: 
1. Put  the  shift  lever  in PARK (P). 
2. Set  the  parking  brake  firmly. 
3. Turn off the  engine. 
To  be even  more  certain  the  vehicle won’t move, 
you  can  put  blocks at the  front  and  rear  of the 
tire  farthest  away from  the  one  being  changed. 
That  would  be  the  tire  on  the  other  side  of the 
vehicle,  at the  opposite  end.   
Page 269 of 386

Downloaded from www.Manualslib.com manuals search engine The following  steps  will  tell you  how  to  use  the  jack and 
change  a  tire. 
Removing  the  Spare  Tire  and  Tools 
The  equipment  you’ll  need  is in the  trunk.  Pull  the 
carpeting  from  the  floor of the  trunk.  Turn  the  retainer 
(center  dial)  on  the  compact  spare cover 
counterclockwise  to  remove  it. Lift  and  remove  the 
cover.  (See  “Compact  Spare  Tire”  later  in  this  section 
for  more  information  about  the  compact 
spare.) 
5-26   
Page 270 of 386

Downloaded from www.Manualslib.com manuals search engine Turn  the  nut  holding the jack  and  wheel  wrench 
counterclockwise  and  remove it. Then  remove  the  jack 
and  wrench. 
Lift 
up the  tire  to remove it from  the  trunk.   
Page 272 of 386

Downloaded from www.Manualslib.com manuals search engine Removing the  Flat  Tire  and  Installing  the 
Spare  Tire 
1. Using  the  wheel  wrench,  loosen  all  the  wheel  nuts. 
Don’t  remove  them  yet. 
2. Turn the jack  handle  clockwise  to  raise  the jack  lift 
head  a  few inches.  Getting  under  a 
vehicle when it 
is jacked  up  is 
dangerous. 
If the  vehicle  slips off the  jack,  you 
could  be  badly  injured  or killed. Never  get  under 
a vehicle when it is  supported  only by a  jack. 
NOTICE: 
Raising  your  vehicle with the  jack  improperly 
positioned  can  cause  damage  to  the  vehicle and 
even  make  the  vehicle fall. 
To help  avoid  personal 
injury  and  vehicle damage,  be sure  to 
fit the  jack 
lift head  into  the  proper  location  before  raising 
your  vehicle. 
5-29   
Page 273 of 386

Downloaded from www.Manualslib.com manuals search engine 10.5 INCHES 5.8 INCHES 
(270 mm) (150 mm) 
3. Position  the jack under  the  vehicle  and  raise  the  jack 
lift  head  until  it  fits firmly  into  the  notch  in  the 
vehicle's  frame nearest  the  flat  tire. 
Put  the  compact  spare  tire  near 
you. 
clockwise.  Raise the  vehicle  far enough  off  the 
ground  for the  spare  tire  to  fit under  the  vehicle. 
4. Raise  the  vehicle by turning  the jack  handle 
5. Remove  all  wheel  nuts  and  take off the  flat  tire. 
6. Remove any rust or dirt 
from  the  wheel  bolts, 
mounting  surfaces  and  spare  wheel.   
Page 275 of 386

Downloaded from www.Manualslib.com manuals search engine 8. Lower  the  vehicle by turning  the jack handle 
counterclockwise.  Lower  the  jack completely. 
9. Tighten  the  wheel  nuts 
firmly  in  a  criss-cross 
sequence  as  shown. 
I A CAUTION: 
Incorrect  wheel nuts or  improperly  tightenea 
wheel  nuts  can  cause  the  wheel to become  loose 
and  even  come 
off. This  could  lead  to  an accident. 
Be  sure  to  use the  correct  wheel nuts. 
If you have 
to  replace  them,  be sure to get  new 
GM original 
equipment  wheel nuts. 
Stop  somewhere  as  soon 
as you can  and  have  the 
nuts  tightened  with a  torque  wrench  to 
100 lb-ft 
(140 Nom). 
I I   
Page 289 of 386

Downloaded from www.Manualslib.com manuals search engine An  alternate fuel door 
release 
is located  inside  of 
the  trunk  on  the  left  hand 
side.  Pull  it 
to release  the 
fuel  door. 
To take  off the  cap,  turn it slowly  to  the  left 
(counterclockwise). 
If you  get gasoline  on  yourself  and  then 
something  ignites  it,  you could  be  badly  burned. 
Gasoline  can  spray  out  on you 
if you  open  the 
fuel  filler  cap too quickly.  This  spray  can  happen 
if  your  tank 
is nearly  full, and is more  likely  in 
hot  weather.  Open  the  fuel  filler  cap  slowly and 
wait  for  any  “hiss” noise to  stop.  Then  unscrew 
the  cap  all  the  way. 
Be  careful  not  to  spill  gasoline.  Clean  gasoline  from 
painted  surfaces  as  soon  as  possible.  See  “Cleaning  the  Outside  of  Your Cadillac”  in the  Index. 
Hang  the  cap inside  the  fuel  door  while  refueling. 
6-6