lumbar support CADILLAC DTS PROFESSIONAL 2007 1.G Owners Manual

Power Lumbar
The power lumbar
controls are located on
the outboard side of
the front seats behind
the power seat controls.
Press the lumbar control forward to increase
support and rearward to decrease support. Press
the top or bottom of the control to raise or
lower the support mechanism.
The ignition does not need to be on for the power
lumbar feature to work.
Keep in mind that as your seating position
changes, as it may during long trips, so should the
position of your lumbar support. Adjust the seat
as needed.
Massaging Lumbar
If your vehicle has this
feature, the switch is
located on the outboard
side of the front
seats behind the lumbar
switch. Press the
switch to turn the
massaging lumbar
feature on. The ignition
must be on.
The massage cycle will run for up to 10 minutes.
To stop massage, press the massaging lumbar
switch again, or press the power lumbar switch.
10

Press a button to turn on the desired feature. A
light on that button will display to show which
feature is on.
There are three temperature settings for each
feature. A column of three lights next to the
buttons will display which setting the feature is in:
high, medium or low. Three lights indicate the
highest setting, two lights for medium and one light
for the lowest setting.
When you press a button, the feature will turn on
at the highest setting. Each time you press the
button, the feature will go down one temperature
setting.
To turn the feature off, keep pressing the button
until the display lights turn off.
Rear Seat Pass-Through Door
Your vehicle has a pass-through door that provides
access to the trunk from the rear seats. See
“Rear Seat Pass-Through Door” underTrunk on
page 106.
Power Lumbar
Your vehicle may be equipped with four-way
lumbar support, without the massage feature, for
the outboard rear seat positions.
The rear lumbar support
controls are located on
the rear doors in
front of the heated seat
buttons.
To turn on the lumbar support feature, press the
front of the control to increase support or rearward
to decrease support. The lumbar control can
also be moved up and down to adjust the location
of the support.
The ignition does not need to be on for the power
lumbar feature to work.
18