steering CADILLAC ELDORADO 1994 10.G Owner's Manual

Downloaded from www.Manualslib.com manuals search engine When the towing service arrives, let the tow operator know that this
manual-contains detailed towing instructions and illustrations. The
operator may want to see them.
When your vehicle
is being towed, have the ignition key off. The steering
wheel should be clamped in a straight-ahead position, with
a clamping device
designed for towing service.
Do not use the vehicle’s steering column lock for
this. The transaxle should be in Neutral and the parking brake relea\
sed.
218
-.

Downloaded from www.Manualslib.com manuals search engine !r
r
r
r L
I-
‘.. c ..e
IF A TIRE GOES FLAT
It’s unusual for a: tire to “blow out” while you’re driving, especially if you
maintain your tires properly. If air goes out of a. tire, it’s much more ‘likely
to leak out slowly.
But if you should ever have a “blowout,” here are a
few tips about what to expect and what to do:
If a front tire fails, the flat tire will create a drag that pulls the vehicle
toward that side. Take your
foot, off .the accelerator pedal and grip- the
steering wheel
firmly. Steer to maintain lane position, then-gently brake
to a stop well out of the traffic lane.
A rear blowout, particularly on a curve, acts much like a skid and may
require the same correction you’d use in a skid. In .any rear blowout,
remove your foot from the accelexator pedal. Get the vehicle under
control by steering the way
you want the vehicle to go. It may be very
bumpy and noisy, but you can still steer. Gently brake to a stop, well
off
the. road.if possible.
If a tire goes flat, the next section shows how to use your jacking
equipment to change a flat tire safely.
. . ._ .. . .
229

Downloaded from www.Manualslib.com manuals search engine I
’
. NOTICE:
Spinningyour.wheels-can destroy par€s of your vehicle as well
as the tires. If you spin the wheels too transaxle back and
forth, you ,can destroy your transaxle.
Rocking yourvehicle
to get it out:
First, tumyour steering wheel left and right. That will clear ,the area
around your front wheels. Then
shift back and forth. between “.R”
(Reverse) and, a forward gear, spinning the wheels.as-!itt€e.as possible.
Release-the accelerator pedal while you shift, and press lightly on the
accelerator pedal when
.the transde.is.in gear. If that doesn’t get you out
after .a
few txie-s,. you-may need to-be 6owed:out. If you do need to Be
towed out, see “Tiwing Your Vehicle’’ in .the Index.
1
I 240
I
1‘
i E

Downloaded from www.Manualslib.com manuals search engine THERMOSTAT
Engine coolant temperature is controlled by a thermostat in the engine
coolant system. The thermostat stops the flow
of coolant through the
radiator until the coolant reaches
a preset temperature.
When
you replace your thermostat, an AC@ thermostat is recommended.
POWER STEERING FLUID
How To Check Power Steering Fluid
Unscrew the cap and wipe the dipstick with a clean rag. Replace the cap
and completely tighten
it. Then remove the cap again and look at the
fluid level
on the dipstick.
266

Downloaded from www.Manualslib.com manuals search engine . I ,.-
r
r
r
r
.. .
What to Add
Refer to the Maintenance Schedule to determine what kind of fluid to
use. See “Recommended Fluids and Lubricants” in the Index.
NOTICE:
When adding power steering fluid or making a complete fluid
change, always use the proper fluid. Failure to use the proper
fluid
can cause leaks and damage hoses and seals.
r
I

Downloaded from www.Manualslib.com manuals search engine Y
r
r I
i
r
!r:
i E
,r
i 'E
L HDLP LO R HDLP LO L HDLP HI R HDLP HI ION 3 COOL'FAN TRANS
I FUSE CENTER IDENTIFICATION I
ENGINE COMPARTMENT FUSE BLOCK
DlSTR 20A
SIR 20A - IGNITION CONTROL MODULE
- DIAGNOSTIC/ENERGY RESERVE
MODULE (DERM)
- DUAL POLE ARMING SENSOR PCM (ION 1OA
- PASS-Key@ DECODER MODULE INJ 10A
- POWERTRAIN CONTROL MODULE (PCM)
- 1,4,6, AND 7 FUEL INJECTORS
- 2.3.5. AND 8 FUEL INJECTORS INJ 1OA
ION
1 iOA - A/C REFRIGERANT PRESSURE SWITCH - TRANSAXLE RANGE SWITCH - STOP/BTSI/CRUISE BRAKE SWITCH - INSTRUMENT PANEL'CLUSTER - KEYLESS ENTRY MODULE - DIAGNOSTlCfENERGY RESERVE MODULE
- PERM2 ORN RING LIGHTS - TURN/HAZARD SWITCH ASSY. - CHIME MODULE - HEADLIGHT SWITCH - TWILIGHT SENTINEUDRL MODULE
- FUELPUMP - OIL PRESSURE SWITCH - POWERTRAIN CONTROL MODULE IPCMI
FUEL PUMP 20A
PCM (BAT) 1OA
RTD
, AT) 20A - RgAD SENSING SUSPENSION (RSS) MODUL A/C COMP 1OA
- POWERTRAIN CONTROL MODULE (PCM)
- A/C COMPRESSOR CLUTCH HDLPS 3OA
.~
- HEADLIGHT DIMMER SWITCH - HEADLIGHT RELAY "D (ENGINE COMF!
- DRL HEADLIGHT RELAY "E" (WITH DAYTIME
- POWERS C13 MICRO RELAY CENTER)
RUNNING LIGHTS)
E
STOP LP 2OA - STOP/BTSI/CRUISE SWITCH - STOPUGHT SWITCH CAPACITOR TURNIHAZ 20A - HAZARD FLASHER - TURN FLASHER RELAY - TURN FLASHER MODULE DRL 1 OA (CANADA) - DAV~ME RUNNI'NG LIGHTS (CANADA) ~ ~~
DRL 1 OA (CANADA)
HTD
W/S 1OA
L HDLP LO 1OA
- LEFT AND RIGHT LO BEAM HEADLAMP
- HEATED WINDSHIELD CONTROL MODULE
- LEFT LO BEAM HEADLAMP R HDLP LO 10A
L HDLP HI 1OA - RIGHT LO BEAM HEADLAMP
- LEFT HI BEAM HEADLAMP R HDLP HI 1OA
IGN
3 10A - RIGHT HI BEAM HEADLAMP
- REAR DEFOGGERRELAY - ELECTRONIC LEVEL CONTROL IELCI - HEATED WINDSHIELD - HEATER AND A/C PROGRAMMER - CRUISE CONTROL
..
COOLING FAN 1OA - MENDED TRAVEL BRAKE SWITCH - POWERTRAIN CONTROL MO'DULE (PCM) - COOLING FAN RELAYS 1,2, AND 3 - FRONT AND REAR HEATED OXYGEN SENSOR TRANSIECS 1 OA - OVERSPEED ALERT MODULE (=PORT) - POWER STEERING PRESSURE SWITCH - EXHAUST GAS REClRCULAilON (EGR) VALVE - TRANSAXLE SHIFT SOLENOIDS A & B - EVAPORATIVE EMISSION CONTROL
SOLENOID ~~
- POWERTRAIN CONTROL MODULE (PCM) - TORQUE CONVERTER CLUTCH SOLENOID - TCC BRAKESWlTCH
313

Downloaded from www.Manualslib.com manuals search engine -
Spirited performance with very efficient cruising operation are provided
by the combination
of 4 speed overdrive gearing, a torque clutch, with a -
3.71:l final drive on the ETC and a viscous torque converter clutch with a a
3.1 1:l final drive ratio on the Eldorado.
Front Suspension
..
Your fully independent front suspension is a combination strut and spring
design. The frame is isolated from the body with
six rubber mounts.
Rubber bushings are used at the lower control arm pivots. The upper end
of the strut is isolated by a rubber mount which contains a bearing to
allow for wheel turning. The Road Sensing Suspension will automatically
controls the damping rate
of the struts.
The lower end
of the steering knuckle pivots on a ball joint riveted to the
control arm. The ball joint is connected to the steering knuckle with a
castellated nut and cotter pin.
c-
322

Downloaded from www.Manualslib.com manuals search engine The suspension system also incorporates a new damping system known as
Road Sensing Suspension. This system control the damping forces in the
shock absorbers and struts,
in response to various road and driving
conditions. The systems are capable of making these damping changes
extremely fast.
A computer receives inputs from vertical acceleration sensors, wheel to
body position sensors, vehicle speed sensor,
lift and dive signals. This
computer evaluates the inputs from these sensors,
to control the damping
of each of the struts and shocks independently
to provide varied levels of
suspension control.
The system also has the capability of providing Speed Sensitive Ste\
ering
control. This system changes your steering effort based
on your vehicle speed.
This system varies the amount of steering effort proportionate to your
vehicle speed. Steering
is easier at a lower speed for increased
maneuverability and parking ease.
As your vehicle speed increases, the
steering effort
is also increased to provide a manual like steering feel for
maximum control and enhanced vehicle stability.
324

Downloaded from www.Manualslib.com manuals search engine r
r
r
I
Ir
r
Iil
r
r
r!
The power rack and pinion..stee&g .gstem--h,w, a ,rotaq- spool valve which
directs hydraulic fluid coming from the power steering pump .to one side or
the other
side of the rack piston. The integral rack.piston is attached to the
rack. The rack piston converts hydraulic pressure to a linear force which
moves the rack4eft or right.
The force is then transmitted through the
inner and outer tie rods to the steering
.. knuckles, , which turn the wheels
If hydraulic assist is not available, manual conirol, is ‘maintained. However
under these, conditions. more steering effort is required.
4.6 LITER NORTHSTAR ENGINE
Displacement ............................... .4.6L (279 cu.in.)
No. of Cylinders
................ 32-valve DOHC 8 - 90 Degree V
Power (ACC. to
SAE 51349) ................ 270 (b,hp) @ 5600 rpm
Torque (ACC. to
SAE 51349) ............ 300 (lbs. ft.) @? 4000 rpm
ELDORADO
...................................... 204 (kW) @ 5600 rprn
...................................... 407(N*m) @ 4OOOrpm
ETC
Power (ACC. to SAE 51349) ................ 295’(bhp) @ 6000 rpm
Torque (ACC. to
SAE 51349) ............ 290 (lbs. ft.) @? 440.0 rpm
Bore
........................................ 93mm.(3.66.in.)
Stroke
...................................... .84mm (331in.)
Compression Ratio
.................................... 10.3: 1
Cylinder Block ...... Die Cast Aluminum with Iron Cylinder Bores
Cylinder Heads
................................. Cast Aluminum
Intake Manifold-
............ Die Cast Magnesium / Thermoplastic
.......................................... Air Induction Tubes
........................................ 220 (kW) @ 6000 rpm
...................................... 393 (Nom) @ 4400 rpm
Valve. System ................... Direct Acting Hydraulic Tappets
Intake Valve
.................................. 33mm (1.29 in.).
Fkhaust Valve,. ................................ 29mm (1.14.h.)
Pktons
...................................... Cast Aluminum
Firing Order
.................................. 1-2-7-3-4-5-6-8
Left Bank ........................................... 2-4-6-8
325

Downloaded from www.Manualslib.com manuals search engine Fuel Tank .................................. 20 gallons (76 L)
Power Steering
.............................. 1.3 quarts (1.2 L)
Windshield Washer Reservoir .................. 4.2 quarts (4.1 L)
TIGHTEN TORQUE
Spark Plugs (4.6 L) ......................... 15 N-m (11 lbs. ft.)
Oil Pan Drain Plug (4.6
L) ................... 20 N*m (15 lbs. ft.)
VEHICLE DIMENSIONS
Eldorado/ETC
Shipping Weight .......................... 3516 lbs. (1594.7 kg)
Shipping Weight
(ETC) ..................... .3695 lbs. (1679 kg)
Wheel Base
................................ 108 in. (2743 mm)
Length .................................. .202.2 in. (5135 mm)
Height ................................... .54.0 in. (1371 mm)
Width .................................... .74.3 in. (1887 mm)
Front Tread ............................... .60.9 in. (1547 mm)
Rear Tread ............................... .60.9 in. (1547 mm)
328