clock CADILLAC ESCALADE ESV 2004 2.G Owner's Manual

{CAUTION:
Rust or dirt on the wheel, or on the parts to
which it is fastened, can make the wheel nuts
become loose after a time. The wheel could
come off and cause an accident. When you
change a wheel, remove any rust or dirt from
the places where the wheel attaches to the
vehicle. In an emergency, you can use a cloth
or a paper towel to do this; but be sure to use
a scraper or wire brush later, if you need to, to
get all the rust or dirt off.
{CAUTION:
Never use oil or grease on studs or nuts. If
you do, the nuts might come loose. Your wheel
could fall off, causing a serious accident.6. After mounting the
spare, put the wheel
nuts back on with
the rounded end of the
nuts toward the
wheel. Tighten each
wheel nut by hand.
Then use the wheel wrench to tighten the nuts until
the wheel is held against the hub.
7. Turn the wheel wrench counterclockwise to lower
the vehicle. Lower the jack completely.
5-95

8. Tighten the nuts rmly
in a crisscross
sequence as shown by
turning the wheel
wrench clockwise.
{CAUTION:
Incorrect wheel nuts or improperly tightened
wheel nuts can cause the wheel to come loose
and even come off. This could lead to an
accident. Be sure to use the correct wheel
nuts. If you have to replace them, be sure to
get new GM original equipment wheel nuts.
Stop somewhere as soon as you can and have
the nuts tightened with a torque wrench to the
proper torque specication. See “Capacities
and Specications” in the Index for wheel nut
torque specication.Notice:Improperly tightened wheel nuts can lead to
brake pulsation and rotor damage. To avoid
expensive brake repairs, evenly tighten the wheel
nuts in the proper sequence and to the proper torque
specication. See “Capacities and Specications” in
the index for the wheel nut torque specication.
When you reinstall the regular wheel and tire, you must
also reinstall the center cap. Place the cap on the wheel
and tap it into place until it seats ush with the wheel. The
cap only goes on one way. Be sure to line up the tab on
the center cap with the indentation on the wheel.
5-96

1. Put the tire on the ground at the rear of the vehicle
with the valve stem pointed down and to the rear of
the vehicle.
2. Tilt the retainer (D)
downward and through
the wheel opening.
Make sure the retainer
is fully seated across
the underside of
the wheel.
3. Attach the wheel wrench (H) and extensions (I)
together.4. Insert the hoist end (F)
through the hole (G) in
the rear bumper and
into the hoist shaft.
5. Raise the tire part way upward. Make sure the
retainer is seated in the wheel opening.
6. Raise the tire fully against the underside of the
vehicle by turning the wheel wrench clockwise
until you hear two clicks or feel it skip twice. You
cannot overtighten the cable.
5-98

7. Make sure the tire is stored securely. Push, pull
and then try to rotate or turn the tire. If the tire
moves, use the wheel wrench to tighten the cable.
Reinstall the spare tire lock (if equipped).
To store the tools, follow these procedures:For Escalade, do the following:
1. Put the tool kit and the jack tools in the tool bag
and place in the retaining clip above the jack.
2. Tighten down with the wing nut.
3. Then, assemble wheel blocks and jack together
with the wing nut and retaining hook.
4. Position behind the jack storage cover in the left
rear side panel and tighten, adjusting clockwise
until the jack is secured tight in the mounting
bracket. Be sure to position the holes in the base of
the jack onto the pin in the mounting bracket.
For Escalade ESV, do the following:
1. Return the tool kit and jack tools to the tool bag.
2. Assemble wheel blocks and jack together with the
wing nut and retaining hook.
3. Position under the jack storage tray in the left rear
side panel below the wheelbase and tighten,
adjusting clockwise until the jack is secured tight in
the mounting bracket. Be sure to position the
holes in the base of the jack onto the pin in the
mounting bracket.
4. Use the retaining clip to fasten the tool kit on the stud
in the storage compartment in the rear left trim panel
and turn the wing nut clockwise to secure.
5. Return the storage tray. (A) Push and Pull (B) Rotate or Turn
5-99

Secondary Latch System
Your vehicle has an underbody mounted tire hoist
assembly equipped with a secondary latch system. It’s
designed to stop the spare tire from suddenly falling
off your vehicle. For the secondary latch to work,
the spare must be installed with the valve stem pointing
down. See “Storing a Flat or Spare Tire, Jack and
Tools” earlier in this section.
{CAUTION:
Before beginning this procedure read all the
instructions. Failure to read and follow the
instructions could damage the hoist assembly
and you and others could get hurt. Read and
follow the instructions listed below.To release the spare tire from the secondary latch do
the following:
1. Check under the vehicle to see if the cable end is
visible.
2. If the cable is not visible proceed to Step 6.
If it is visible, rst try to tighten the cable by turning
the wheel wrench clockwise until you hear two
clicks or feel it skip twice. You cannot overtighten
the cable.
3. Loosen the cable by turning the wrench
counterclockwise three or four turns.
5-101

4. Repeat this procedure at least two times. If the
spare tire lowers to the ground, continue with
Step 5 of “Removing the Spare Tire and Tools”
earlier in this section.
5. Turn the wrench counterclockwise until
approximately six inches (15 cm) of cable is
exposed.
6. Stand the wheel blocks
on their shortest ends,
with the backs
facing each other.7. Place the bottom edge of the jack on the wheel
blocks, separating them so that the jack is
balanced securely.
5-102

8. Attach the jack handle, extension, and wheel
wrench to the jack and place it (with the wheel
blocks) under the vehicle towards the front of the
rear bumper. Position the center lift point of the jack
under the center of the spare tire.
9. Turn the wrench clockwise to raise the jack until it
lifts the end tting.
10. Continue raising the jack until the spare tire stops
moving upward and is held rmly in place. The
secondary latch has released and the spare tire is
balancing on the jack.11. Lower the jack by turning the wheel wrench
counterclockwise. Keep lowering the jack until the
spare tire slides off the jack or is hanging by
the cable.
{CAUTION:
Someone standing too close during the
procedure could be injured by the jack. If the
spare tire does not slide off the jack
completely, make sure no one is behind you or
on either side of you as you pull the jack out
from the spare.
12. Disconnect the jack handle from the jack and
carefully remove the jack. Use one hand to push
against the spare while rmly pulling the jack out
from under the spare tire with the other hand.
If the spare tire is hanging from the cable, insert the
hoist handle, extension and wheel wrench into
the hoist shaft hole in the bumper and turn
the wheel wrench counterclockwise to lower the
spare the rest of the way.
5-103

13. Tilt the retainer at the
end of the cable and
pull it through the
wheel opening. Pull the
tire out from under
the vehicle.
14. If the cable is hanging under the vehicle, turn the
wheel wrench clockwise to raise the cable back up.
Have the hoist assembly inspected as soon as you can.
You will not be able to store a spare or at tire using
the hoist assembly until it has been replaced.
To continue changing the at tire, see “Removing the
Flat Tire and Installing the Spare Tire” earlier in
this section.Spare Tire
Your vehicle, when new, had a fully inated spare tire.
A spare tire may lose air over time, so check its ination
pressure regularly. SeeInation - Tire Pressure on
page 5-74andLoading Your Vehicle on page 4-50for
information regarding proper tire ination and loading
your vehicle. For instruction on how to remove, install or
store a spare tire, seeChanging a Flat Tire on page 5-86.
After installing the spare tire on your vehicle, you should
stop as soon as possible and make sure the spare is
correctly inated. Have the damaged or at road
tire repaired or replaced as soon as you can and
installed back onto your vehicle. This way, a spare tire
will be available in case you need it again.
Your vehicle may have a different size spare tire than
the road tires— those originally installed on your vehicle.
This spare tires was developed for use on your
vehicle, so it’s all right to drive on it.
If your vehicle has a spare tire that does not match your
vehicle’s original road tires and wheels in size and
type, do not include the spare in the tire rotation.
5-104

A
Accessory Power Outlets.................................3-22
Adding Washer Fluid.......................................5-38
Additional Program Information.........................7-10
Additives, Fuel................................................. 5-7
Add-On Electrical Equipment...........................5-114
Add-On Equipment..........................................4-55
Adjustable Throttle and Brake Pedal..................2-20
Adjusting the Speakers (Balance/Fade)..............3-74
After Off-Road Driving.....................................4-31
Air Bag
Passenger Status Indicator...........................3-38
Readiness Light..........................................3-36
Air Bag Systems.............................................1-79
Adding Equipment to Your Air Bag-Equipped
Vehicle...................................................1-94
How Does an Air Bag Restrain?....................1-86
Passenger Sensing System...........................1-88
Servicing Your Air Bag-Equipped Vehicle.........1-94
What Makes an Air Bag Inate?....................1-86
What Will You See After an Air
Bag Inates?...........................................1-87
When Should an Air Bag Inate?...................1-85
Where Are the Air Bags?..............................1-82
Air Cleaner/Filter, Engine.................................5-19
Air Conditioning..............................................3-27
Airbag Sensing and Diagnostic Module (SDM).......7-10
All-Wheel Drive...............................................5-49All-Wheel Drive (AWD) System.........................2-25
AM .............................................................3-104
Analog Clock..................................................3-23
Antenna, Diversity Antenna System..................3-106
Antenna, XM™ Satellite Radio Antenna
System.....................................................3-106
Anti-lock Brake System..................................... 4-7
Anti-Lock Brake, System Warning Light..............3-42
Appearance Care..........................................5-105
Care of Safety Belts...................................5-108
Chemical Paint Spotting..............................5-112
Cleaning the Inside of Your Vehicle..............5-106
Cleaning the Outside of Your Vehicle............5-108
Finish Damage..........................................5-111
Sheet Metal Damage..................................5-111
Underbody Maintenance.............................5-111
Vehicle Care/Appearance Materials...............5-112
Weatherstrips............................................5-108
Approaching a Hill..........................................4-23
Ashtrays........................................................3-22
Audio Output..................................................3-88
Audio System(s).............................................3-69
Audio Steering Wheel Controls....................3-103
Care of Your Cassette Tape Player...............3-104
Care of Your CD and DVD Player................3-105
Care of Your CD Player..............................3-105
Care of Your CDs and DVDs.......................3-105
CD Changer...............................................3-99
Chime Level Adjustment.............................3-106
1

Chime Level Adjustment.................................3-106
Cigarette Lighter.............................................3-22
Cleaning
Inside of Your Vehicle.................................5-106
Outside of Your Vehicle..............................5-108
Underbody Maintenance.............................5-111
Weatherstrips............................................5-108
Cleaning Aluminum or Chrome-Plated Wheels.....5-110
Cleaning Exterior Lamps/Lenses......................5-109
Cleaning Fabric/Carpet...................................5-106
Cleaning Glass Surfaces................................5-107
Cleaning Interior Plastic Components...............5-107
Cleaning Leather...........................................5-106
Cleaning the Mirror.........................................2-34
Cleaning the Speaker Covers..........................5-107
Cleaning the Top of the Instrument Panel.........5-107
Cleaning the Video Screen...............................3-97
Cleaning the Windshield, Backglass and
Wiper Blades............................................5-110
Cleaning Tires..............................................5-111
Cleaning Vinyl..............................................5-106
Cleaning Wood Panels...................................5-107
Climate Control System
Automatic...................................................3-23
Climate Controls Personalization....................3-33
Outlet Adjustment........................................3-30
Rear..........................................................3-30
Clock............................................................3-23
Compass Calibration.......................................2-34Compass Variance..........................................2-33
Content Theft-Deterrent....................................2-16
Control of a Vehicle.......................................... 4-6
Convenience Net............................................2-45
Coolant
Engine Temperature Gage............................3-43
Heater, Engine............................................2-21
Surge Tank Pressure Cap.............................5-27
Cooled Seats...........................................1-6, 1-11
Cooling System..............................................5-30
Cruise Control................................................3-11
Cruise Control Light........................................3-49
Cupholder(s)..................................................2-43
Current and Past Model Order Forms................7-14
Customer Assistance Information
Courtesy Transportation.................................. 7-8
Customer Assistance for Text Telephone (TTY)
Users....................................................... 7-4
Customer Assistance Offices........................... 7-4
Customer Satisfaction Procedure..................... 7-2
GM Mobility Program for Persons with
Disabilities................................................ 7-6
Reporting Safety Defects to General Motors.......7-12
Reporting Safety Defects to the Canadian
Government............................................7-12
Reporting Safety Defects to the United States
Government............................................7-12
Roadside Service.......................................... 7-6
Service Publications Ordering Information........7-13
4