CADILLAC ESCALADE ESV 2010 User Guide

Black plate (5,1)Cadillac Escalade/Escalade ESV Owner Manual - 2010
The engine will continue to run for 10 minutes. Repeat
the steps for a 10-minute time extension. Remote start
can be extended only once.
Canceling a Remote Start To cancel a remote start: .
Aim the RKE transmitter at the vehicle and press
and hold
/ until the parking lamps turn off..
Turn on the hazard warning flashers. .
Turn the ignition on and then back off.
See Remote Vehicle Start on page 3 ‑ 7 .
Door Locks There are several ways to lock and unlock the vehicle.
From outside, use the Remote Keyless Entry (RKE)
transmitter or the key in the driver door. From inside,
use the power door locks or the manual door locks. To
lock or unlock the door with the manual locks, push
down or pull up on the manual lock knob. Power Door Locks If available, these switches are located on the front
doors.
K : Press to unlock the doors.
Q : Remove the key from the ignition and press to lock
the doors.
For more information, see: .
Programmable Automatic Door Locks on
page 3 ‑ 11 . .
Rear Door Security Locks on page 3 ‑ 11 .
1-5

Black plate (6,1)Cadillac Escalade/Escalade ESV Owner Manual - 2010
Liftgate Power Liftgate
Use the Remote Keyless Entry (RKE) transmitter or the
power door lock switches to unlock the liftgate. There are several ways to open and close the power
liftgate: .
Press and hold
& on the RKE transmitter until
the liftgate starts moving. .
Press
& on the overhead console inside the
vehicle. .
Press the touchpad switch (B) on the outside
liftgate handle to open. .
Press the
l button next to the liftgate latch to
close.
To disable the power liftgate function, press OFF on the
overhead console.
Liftglass There are two ways to unlatch the liftglass: .
Press the button on the underside of the underside
of the license plate applique (A). .
Press
m on the RKE transmitter.
1-6

Black plate (7,1)Cadillac Escalade/Escalade ESV Owner Manual - 2010
Windows The power window
switches are located on
the driver door. In
addition, each passenger
door has a switch for its
own window.
Press the switch to lower the window. Pull the switch up
to raise it.
For more information, see: .
Windows on page 3 ‑ 18 ..
Power Windows on page 3 ‑ 19 . Seat Adjustment Front Seats Power Seats
The power seat controls are located on the outboard
side of the front seats.
Move the seat forward or rearward by sliding the control
forward or rearward.
Raise or lower the front or rear part of the cushion by
moving the front or rear part of the control up or down.
1-7

Black plate (8,1)Cadillac Escalade/Escalade ESV Owner Manual - 2010
Raise or lower the entire seat by moving the entire
control up or down.
See Power Seats on page 2 ‑ 4 .
Power Lumbar
To increase lumbar support, press and hold the front of
the control. To decrease, press and hold the rear of the
control.
To raise the height of the support, press and hold the
top of the control. To lower, press and hold the bottom
of the control.
See Power Lumbar on page 2 ‑ 5 . Power Reclining Seatbacks
To recline the seatback, tilt the top of the control
rearward.
To bring the seatback forward, tilt the top of the control
forward.
See Power Reclining Seatbacks on page 2 ‑ 8 .
1-8

Black plate (9,1)Cadillac Escalade/Escalade ESV Owner Manual - 2010
Memory Features The controls for this
feature are located on the
driver door, and are used
to program and recall
memory settings for the
driver seat, outside
mirrors, steering wheel
position, and the
adjustable throttle and
brake pedal feature, if the
vehicle has it.
For more information, see Memory Features
on
page 2 ‑ 6 . Second Row Seats If the vehicle has a 60/40 split bench or buckets seats,
the seat(s) can be folded for additional cargo space or
folded and tumbled for easy entry and exit to the third
row seats, if the vehicle has them. If the vehicle has
bucket seats, the seatbacks can be also be reclined.
These seats will have either the manual fold and tumble
feature or the automatic seat release fold and tumble
feature.
For more information, see 60/40 Split Bench Seat
on
page 2 ‑ 10 or Bucket Seats on page 2 ‑ 15 .
Third Row Seats If the vehicle has a third row seat, the seatback(s) can
be folded and the entire seat can be tumbled,
or removed from the vehicle.
For detailed instructions, see Third Row Seat on
page 2 ‑ 21 .
1-9

Black plate (10,1)Cadillac Escalade/Escalade ESV Owner Manual - 2010
Heated Seats Front Seats On vehicles with heated
and cooled front seats,
the controls are located
on the climate control
panel.
{ (Cooled Seat): Press to cool the entire seat.
+ (Heated Seatback): Press to heat the
seatback only.
z (Heated Seat and Seatback): Press to heat the seat
and seatback.
Continue to press the desired button to cycle through
the temperature settings: high (three indicator lights),
medium (two indicator lights), low (one indicator light),
and off (no lights).
See Heated and Cooled Seats on page 2 ‑ 5 .Rear Seats The heated rear seat
controls are located on
the Rear Sear Audio
(RSA) panel.
M (Heated Seat): Press to heat the seat cushion and to
cycle through the three temperature settings.
See Heated Seats on page 2 ‑ 10 .
Head Restraint Adjustment Do not drive until the head restraints for all occupants
are installed and adjusted properly.
For more information see Head Restraints on
page 2 ‑ 2
.
1-10

Black plate (11,1)Cadillac Escalade/Escalade ESV Owner Manual - 2010
Safety Belt
Refer to the following sections for important information
on how to use safety belts properly. .
Safety Belts: They Are for Everyone on page 2 ‑ 26 ..
How to Wear Safety Belts Properly on page 2 ‑ 30 ..
Lap-Shoulder Belt on page 2 ‑ 39 ..
Lower Anchors and Tethers for Children (LATCH)
on page 2 ‑ 59 . Sensing System for Passenger
Airbag The passenger sensing system, if equipped, will turn off
the right front passenger frontal airbag under certain
conditions. The driver airbags, seat ‐ mounted side
impact airbags, if equipped, and roof ‐ rail airbags are not
affected by this.
If the vehicle has one of the indicators pictured in the
following illustrations, then the vehicle has a passenger
sensing system for the right front passenger position.
The passenger airbag status indicator, if equipped, will
be visible on the overhead console when the vehicle is
started.
United States Canada
See Passenger Sensing System
on page 2 ‑ 84 for
important information.
1-11

Black plate (12,1)Cadillac Escalade/Escalade ESV Owner Manual - 2010
Mirror Adjustment Exterior Mirrors Vehicles with outside
power mirrors and
foldaway mirrors have
controls located on the
driver door.
1. Press (A) or (B) to select the driver or passenger
side mirror.
2. Press one of the four arrows located on the control
pad to adjust the mirror.
3. Press the opposite side to get the control pad to a
neutral position. Power Foldaway Mirrors To fold the mirrors:
1. Press (C) to fold the mirrors out to the driving
position.
2. Press (D) to fold the mirrors in to the folded
position.
The dimming feature automatically adjusts the driver
outside mirror for the glare of the headlamps behind
your vehicle. See Automatic Dimming Rearview Mirror
on page 3 ‑ 43 for more information.
Interior Mirror Vehicles with a manual rearview mirror can be adjusted
to see clearly behind the vehicle. Hold the mirror in the
center to move it up or down and side to side. To
reduce headlamp glare during nighttime use, move the
lever at the bottom of the mirror to the right. Move it to
the left for daytime use.
Vehicles with an automatic dimming rearview mirror.
The dimming feature reduces the glare of lights from
behind the vehicle. The dimming feature comes on and
the indicator light illuminates each time the vehicle is
started.
See Automatic Dimming Rearview Mirror on page 3 ‑ 43
for more information.
1-12

Black plate (13,1)Cadillac Escalade/Escalade ESV Owner Manual - 2010
Steering Wheel Adjustment
The power tilt wheel control is located on the left side of
the steering column.
Push the control up or down to tilt the steering wheel up
or down.
See Tilt Wheel on page 4 ‑ 3 . Interior Lighting Dome Lamps The dome lamps come on when any door is opened.
They turn off after all the doors are closed.
The dome lamps can also be turned on by turning the
instrument panel brightness knob, located on the
instrument panel to the left of the steering column,
clockwise to the farthest position. In this position, the
dome lamps remain on whether a door is opened or
closed.
k : The dome lamp override button is located next to
the exterior lamps control.
Press the button in and the dome lamps remain off
when a door is opened. Press the button again to return
it to the extended position so that the dome lamps come
on when a door is opened.
Reading Lamps For vehicles with reading lamps in the overhead
console, press the button located next to the lamp to
turn it on or off.
The vehicle may also have reading lamps in other
locations. The lamps cannot be adjusted.
1-13

Black plate (14,1)Cadillac Escalade/Escalade ESV Owner Manual - 2010
For more information about interior lamps, see: .
Dome Lamps on page 4 ‑ 17 ..
Reading Lamps on page 4 ‑ 17 ..
Instrument Panel Brightness on page 4 ‑ 16 .
Exterior Lighting The exterior lamps
control is located on the
instrument panel to the
left of the steering wheel.
9 : Turns off the automatic headlamps and daytime
running lamps (DRL). Turning the headlamp control to
the off position again will turn the automatic headlamps
or DRL back on.
For vehicles first sold in Canada, the off position only
works when the vehicle is shifted into the P (Park)
position. AUTO: Automatically turns on the headlamps at normal
brightness, along with the parking lamps and taillamps.
; : Turns on the parking lamps and taillamps.
2 : Turns on the headlamps, parking lamps, and
taillamps.
For more information, see: .
Exterior Lamps on page 4 ‑ 11 . .
Daytime Running Lamps (DRL) on page 4 ‑ 15 ..
Fog Lamps on page 4 ‑ 16 .
1-14