Black plate (70,1)Cadillac Escalade/Escalade ESV Owner Manual - 2010
TPMS Sensor Matching Process Each TPMS sensor has a unique identification code.
Any time you rotate your vehicle's tires or replace one
or more of the TPMS sensors, the identification codes
will need to be matched to the new tire/wheel position.
The sensors are matched to the tire/wheel positions in
the following order: driver side front tire, passenger side
front tire, passenger side rear tire, and driver side rear
tire using a TPMS diagnostic tool. See your dealer for
service.
The TPMS sensors can also be matched to each tire/
wheel position by increasing or decreasing the tire's air
pressure. If increasing the tire's air pressure, do not
exceed the maximum inflation pressure indicated on the
tire's sidewall.
To decrease air-pressure out of a tire you can use the
pointed end of the valve cap, a pencil-style air pressure
gauge, or a key. You have two minutes to match the first tire/wheel
position, and five minutes overall to match all four tire/
wheel positions. If it takes longer than two minutes, to
match the first tire and wheel, or more than five minutes
to match all four tire and wheel positions the matching
process stops and you need to start over.
The TPMS sensor matching process is outlined below:
1. Set the parking brake.
2. Turn the ignition switch to ON/RUN with the
engine off.
3. Press
Q and
K on the Remote Keyless
Entry (RKE) transmitter at the same time for
approximately five seconds. The horn sounds
twice to signal the receiver is in relearn mode and
TIRE LEARNING ACTIVE message displays on
the DIC screen.
4. Start with the driver side front tire.
7-70
Black plate (5,1)Cadillac Escalade/Escalade ESV Owner Manual - 2010
Additional Required Services At Each Fuel Stop .
Engine oil level check. See Engine Oil on
page 7 ‑ 17
..
Engine coolant level check. See Engine Coolant
on page 7 ‑ 29 ..
Windshield washer fluid level check. See
Windshield Washer Fluid on page 7 ‑ 39 .
Once a Month .
Tire inflation check. See Inflation - Tire Pressure
on page 7 ‑ 65 ..
Tire wear inspection. See Tire Inspection and
Rotation on page 7 ‑ 71 .
Once a Year .
Starter switch check. See Owner Checks and
Services on page 8 ‑ 8 ..
Parking brake and automatic transmission P (Park)
mechanism check. See Owner Checks and
Services on page 8 ‑ 8 . .
Automatic transmission shiftlock control system
check. See Owner Checks and Services on
page 8 ‑ 8 . .
Ignition transmission lock check. See Owner
Checks and Services on page 8 ‑ 8 . .
Engine cooling system and pressure cap pressure
check. Radiator and air conditioning condenser
outside cleaning. See Cooling System
on
page 7 ‑ 27 . .
Exhaust system and nearby heat shields
inspection for loose or damaged components. .
Accelerator pedal check for damage, high effort,
or binding. Replace if needed. .
Hood and liftgate support gas strut inspection for
signs of wear, corrosion, cracks, loss of lubricant,
or other damage. Check the hold open ability of
the gas strut. If necessary, replace with genuine
parts from your dealer.
8-5
