lumbar support CADILLAC ESCALADE EXT 2002 2.G Owners Manual

1-2
Seats and Seat Controls
This section tells you about the seats -- how to adjust
them, and fold them up and down. It also tells you about
reclining front seatbacks and head restraints.
Power Seats
Horizontal Control: Raise or lower the front of the seat
cushion by raising or lowering the forward edge of the
control. Move the seat forward or rearward by moving
the whole control toward the front or rear of the vehicle.
Raise or lower the rear of the seat cushion by raising or
lowering the rear edge of the control.Moving the whole control up or down raises or lowers
the entire seat cushion.
To learn how to adjust the vertical control for the
seatback angle, see ªReclining Front Seatbacksº
later in this section
Power Lumbar Control
Your vehicle's power
lumbar controls are
located near the power
seat controls.
You can increase or decrease lumbar support in an area
of the lower seatback with the lumber controls.
You can also reshape the side wing area of the lower
seatback for more lateral support.
To increase support, press and hold the top of the
control. To decrease support, press and hold the
bottom of the control. Let go of the control when
the lower seatback reaches the desired level of support.

1-3 Memory Seat and Memory Mirrors
The memory function controls are located on the
driver's door trim panel.
For this function to work, it must be enabled/configured
in the Secondary Information Center (SIC).
See ªSecondary Information Centerº in the Index
for more information.These buttons are used to program and recall the
memory settings for the driver's seat and both
the driver's and the passenger's outside mirrors.
The seat and mirror positions can be personalized
for both driver 1 and driver 2. Driver 1 or driver 2
corresponds to the memory buttons labeled 1 and 2
on the control.
The memory function does not store the lumbar or
back support positions.
To set your memory seat and mirrors do the following:
1. Adjust the driver's seat and both outside mirrors to
the desired position.
2. Press and hold the 1 or 2 (driver 1 or 2) button of the
memory control for three seconds. When you hear a
chime ring two times, the memory position is stored.
To do the same thing for a second driver, follow the
preceding steps, but press the other number of the
memory control. The memory feature only works when
the transmission is in PARK (P).