CADILLAC ESCALADE EXT 2009 3.G Workshop Manual
ESCALADE EXT 2009 3.G
CADILLAC
CADILLAC
https://www.carmanualsonline.info/img/23/7931/w960_7931-0.png
CADILLAC ESCALADE EXT 2009 3.G Workshop Manual
Page 148 of 546
4. Tighten all straps by pulling on the free end of
each strap.5. Close both cross locks at the center of the strap
system to secure tightly.
2-72
Page 149 of 546
Reinstalling the Cargo Cover Panels
The strap system can remain attached to the side of the
cargo area while it is not in use, or it can be stored
inside the top box storage compartment. SeeTop-Box
Storage on page 2-81for more information.
To reinstall a cargo panel:
1. Starting with cargo panel 1, place the latches in the
unlocked position. Place cargo panel 1 on the cargo
area rails while holding the back of the cargo
panel up. Panels 3, 2, 1 Loaded
2-73
Page 150 of 546
Place the cover on the cargo box within 4 inches of
the Midgate®and lower the rear of the panel
within 2 to 3 inches from the top of the cargo box.
Push the cover forward making sure that the
guide block engages the retainer bracket opening.
Continue to push forward until the panel is fully
seated against the Midgate. Then lower the rear of
the cover to engage the striker pegs (A) to align
with the striker assembly (B).2. The driver side cargo cover panel latch must lock in
place before the passenger side latch can be
locked. If this procedure is not followed exactly, the
cargo cover panels might not correctly lock in
place. Push the driver side latch toward the front of
the vehicle to lock the cover in position. A click
sounds when each latch locks. Lock the remaining
passenger side latch on panel 1. Driver Side Shown, Passenger Side Similar
2-74
Page 151 of 546
3. Install cargo cover 2 followed by 3 next. Place the
latches in the unlocked position. Place the cargo
cover panel on the cargo area rails while holding the
back of the cargo panel up.
Push the panel forward until it is snug against the
other panel and then let the back of the panel down
making sure that the pegs (A) align with the
receivers (B).4. Push the latches toward the front of the vehicle,
starting with the driver side latch, to lock the
panel in place. A click sounds when each latch
locks correctly.
Folding and Storage of Straps
Fold the straps for storing inside the top box storage
compartment:
1. Extend the six strap ends on a at surface.
Driver Side Shown, Passenger Side Similar
2-75
Page 154 of 546
Maintenance and Cleaning
To ensure that the water management system performs
properly, be sure that the Midgate®, tailgate and cover
system are fully closed and that all parts are clean and
not blocked with debris. Follow the instructions for the
proper procedures on cleaning each item.
Top Drain Grates – Removal and
Cleaning
The top drain grates are located near the rear window
on both sides of the vehicle. Clean the grates and drains
if there is a blockage.To remove each drain grate:
1. Remove the cargo panels. SeeCargo Cover Panels
on page 2-68for more information.
2. Grasp the edges of the grate and pull it out from
the vehicle. Flush the drain with clean water.
2-78
Page 157 of 546