headlamp CADILLAC SEVILLE 1997 4.G User Guide

Downloaded from www.Manualslib.com manuals search engine from an overheated engine. See ”Engine Overheating”
in the Index.
ENGINE MISFIRE -- EASE OFF GAS
PEDAL - 114: An engine misfire has occurred. You’ll
need to
ease off the gas pedal.
FUEL LEVEL LOW - 11: This message serves as a
waming that the fuel level in the tank is critically low.
Stop for fuel soon.
HEADLAMPS SUGGESTED - 23: If it’s dark enough
outside and the twilight sentinel control is
off, a
€EADLAMPS SUGGESTED message will display on the
DIC.
This message info~lns the driver that turning on the
exterior lamps
is recommended even though the DRL are
still illuminated (it’s become dark enough outside
to
require the headlamps andor other exterior lamps).
ICE POSSIBLE - 13: This message appears when the
outside air temperature is cold enough to create icy road
conditions.
&iONITORED SYSTEhIS OK - 1: This message only
appears in the “recall” mode by pressing the RESET
button.
It lets you know that no other messages are
stored
or cumently active.
PASS KEY NOT PROGRAMMED - 31: This
warning message displays when the PASS-Key pellet information
has not
been programmed into your vehicle.
See your Cadillac dealership for service.
PCM FAULT - 110: The circuit in the Powertrain
Control Module
(PCM) has shorted or is loose when this
message appears. Have your Cadillac serviced by your
dealership at once.
REDUCED ENGINE POWER - 41: This message
informs the driver, that due to wheel slippage, your vehicle
is reducing engine power to compensate for the loss of
traction. Accelerating too fast, causing the tires to spin, is
an example of when this message would display.
REMOVE KEY - 70: This message will appear when
the Personalized Automotive Security System
(PASS-Key
11) is unable to read the pellet on the
ignition key or an improper key pellet
has bee.n inserted.
Wait for
the DIC to display STARTING DISABLED
DUE TO THEFT SYSTEM REMOVE IGNITION
KEY. The instrument panel cluster will then run a timer
and change the messages to WAIT
3 MINUTES, WAIT
2 MINUTES, WAIT 1 MINUTE and then START CAR.
When the REMOVE
KEY message is displayed, remove
the ignition key. Check the ignition key
for damage. If it
is damaged, it may need to be replaced. If you see no
damage, clean the pellet contacts with a soft cloth or
napkin before inserting the key back into the ignition.
Have your vehicle serviced if
the message still appears.
c

Downloaded from www.Manualslib.com manuals search engine Night driving is more dangerous than day driving. One
reason is that some drivers are likely
to be impaired -- by
alcohol or drugs, with night vision problems,
or by fatigue.
Here are some tips on night driving.
0 Drive defensively.
Don’t drink and drive.
0 Since you can’t see as well, you may need to
slow down and keep more space between you and
other vehicles.
Slow down, especially on higher speed roads. E’our
headlamps can light up only
so much road ahead.
0 In remote areas, watch for animals.
0 If you’re tired, pull off the road in a safe place
and rest.

Downloaded from www.Manualslib.com manuals search engine c
No one can see as well at night as in the daytime. But as
we get older these differences increase.
A 50-year-old
driver may require at least twice as much light
to see the
same thing at night as a 20-year-old.
What
you do in the daytime can also affect your night
vision. For example, if you spend the day in bright
sunshine you are wise
to wear sunglasses. Your eyes will
have less trouble adjusting
to night. But if you’re
driving. don’t wear sunglasses at night. They may
cut
down on glare from headlamps. but they also nuke a lot
of things invisible.
You can be temporarily blinded by approaching
headlamps. It can take
a second or two, or even several
seconds. for your eyes
to readjust to the dark. When you
are faced with severe glare (as from a driver who
doesn’t lower the high beams,
or a vehicle with
misaimed headlamps), slow down a little. Avoid staring
directly
into the approaching headlamps. Keep your
windshield and all the glass
on your vehicle
clean
-- inside and out. Glare at night is made much
worse by dirt on the glass. Even the inside
of the glass
can build up a film caused by dust. Dirty glass makes
lights dazzle and flash more than clean glass would,
making the pupils of your eyes contract repeatedly.
Remember that your headlamps
light up far less of a
roadway when
you are in a turn or curve. Keep your
eyes moving; that way. it’s easier
to pick out dimly
lighted objects. Just as your headlamps should be
checked regularly for proper aim.
so should your eyes
be examined regularly. Some drivers sufkr from night
blindness
-- the inability to see in dim light -- and
aren’t even aware of it.

Downloaded from www.Manualslib.com manuals search engine Run your engine only as long as you must. This saves
fuel. When you
run the engine, make it go a little faster
than just idle. That is, push the accelerator slightly. This
uses less fuel ’for the heat that
you get and it keeps the
battery charged.
You will need a well-charged battery to
restart the vehicle, and possibly for signaling later on
with your headlamps. Let the heater
run for awhile.
-*- _--
Then, shut the engine off and close the window almost
all the way to preserve the heat. Start the engine again
and repeat this only when you feel really uncomfortable
from the cold. But do it as little as possible. Preserve the
fuel as long as you can.
To help keep warm, you can get
out of the vehicle and do some fairly vigorous exercises
every half hour or
so until help comes.
TIRE-LOADING INFORMATION
VEHICLE CAP. WT.
FRT.
CTR. RR. TOTAL LBS.
MAX. LOADING & GVWR SAME AS VEHICLE
CAPACITY WEIGHT
XXX COLD TIRE
TIRE SIZE SPEED PRESSURE
RTG
PSIiKPa
FRT.
RR.
SPA.
IF TIRES ARE HOT, ADD 4PSIi28KPa
SEE OWNER’S MANUAL FOR ADDITIONAL
INFORMATION
Two labels on your vehicle show how much weight it
may properly carry.
The Tire-Loading Information label
found on the driver’s door tells you the proper size,
speed rating and recommended inflation pressures for
the tires on your vehicle. It also gives you important
information about the number
of people that can be in
your vehicle and the total weight that you can carry.
This weight is called the Vehicle Capacity Weight and
includes the weight
of all occupants, cargo and all
options not installed in the factory.
I
-3

Downloaded from www.Manualslib.com manuals search engine c
c For any bulb changing procedure not listed in this
section, contact your Cadillac dealer service department.
A CAUTION:
c
c
I
- ~~~~ ~
Halogen bulbs have pressurized gas inside and
can burst
if you drop or scratch the bulb. You or
others could be injured. Be sure to read and
follow the instructions on the bulb package.
1. To access the headlamps, lift the cover off as shown.

Downloaded from www.Manualslib.com manuals search engine 2. Turn the headlamp housing socket counterclockwise
to unlock the socket from the lamp housing.
3. Remove the headlamp housing socket.
-32

Downloaded from www.Manualslib.com manuals search engine F I
r
r
r
I
r
4. After removing the wiring harness from the
headlamp housing socket, replace the bulb and
socket. Reconn-ect it to the wiring harness and
reinstall the headlamp housing socket back into the
headlamp assembly.
1. The turn signal lamps are located on the outboard
side
of the headlamps. To access, lift off the
headlamp cover
(see Step 1 under "Headlamps").
2. Turn the housing socket clockwise to unlock the
socket from the lamp housing.

Downloaded from www.Manualslib.com manuals search engine Each new wheel should have the same load-carrying
capacity, diameter, width, offset and be mounted
the
same way as the one it replaces.
If
you need to replace any of your wheels, wheel bolts
or wheel nuts, replace them only with new GM original
equipment parts. This way,
you will be sure to have the
right wheel, wheel bolts and wheel nuts
for your
Cadillac model.
I A CAUTION:
Using the wrong replacement wheels, wheel bolts
or wheel nuts on your vehicle can be dangerous.
It could affect the braking and handling
of your
vehicle, make your tires lose air and make
you
Iose control. You could have a collision in which
you or others could be injured.
Always use the
correct wheel, wheel bolts and wheel nuts for
replacement.
NOTICE:
The wrong wheel can also cause problems with
bearing life, brake cooling, speedometer
or
odometer calibration, headlamp aim, bumper
height, vehicle ground clearance and tire or tire
chain clearance to the body and chassis.
See “Changing a Flat Tire” in the Index for
more information.
A CAUTION:
Putting a used wheel on your vehicle is
dangerous.
You can’t know how it’s been used or
how far it’s been driven. It could fail suddenly
and cause an accident.
If you have to replace a
wheel, use
a new GM original equipment wheel.
I
6-44

Downloaded from www.Manualslib.com manuals search engine NOTICE:
Don't add anything electrical to your Cadillac
unless you check with your dealer first. Some
electrical equipment can damage your vehicle
and
the damage wouldn't be covered by your warranty.
Some add-on electrical equipment can keep other
components from working
as they should.
Your vehicle has an air bag system. Before attempting to
add anything electrical to your Cadillac, see "Servicing
Your Air Bag-Equipped Cadillac"
in the Index.
irin
The headlamp wiring has an individual fuse which is
powered by a MaxiFuse@. An electrical overload will
cause the
lamps to go on and off. or in some cases to
remain off. If this happens, have the headlamp wiring
checked right away.
MaxiFuse is a registered trademark
of Little Fuse
Incorporated.
iper Falses
The windshield wiper motor is powered by a MaxiFuse.
If the motor overheats due to heavy snow, etc., the
wipers will stop until the motor cools.
If the overload is
caused by some electrical problem, be sure to have it
fixed.
Circuit breakers protect the power windows and other
power accessories. When
the current load is too heavy,
the circuit breaker opens and closes, protecting the
circuit
until the problem is fixed or goes away.
.clay center
The MaxiFuses and relays are located next to the engine
compartment fuse block on the driver's side
of the
engine. If a MaxiFuse should blow, have your vehicle
serviced
by your Cadillac dealer immediately.

Downloaded from www.Manualslib.com manuals search engine c
LAMPS
IGN 1
WINDOWS
SEATS
Usage
Headlamp Wash Relay (Export).
Headlamps Fuse/Relay, HighLow
Beam Control Relay, Fog
Lamp/DRL Fuse, Hazard Fuse,
Mirror Fuse, Inadvertent Power
Relay, Right
and I.,eft High Beam
Fuse, Right and Left
Low Beam
Fuse, Stop Fuse, Fog Lamp Relay
(STS Only), DRL Relay
Rear Ignition-
1 Relay. Wiper
Fuse. Relay Ignition- 1 Fuse,
Supplemental Inflatable Restraint
(SIR) Fuse, Accessory Relay
Delayed Accessory
Bus (DAB) Relay
Horn Relay, Driver and Passenger
Lumbar In/Out Relays, Driver
and
Passenger Up/Down Relays
I Fuse Usage
Steering Column Ignition Switch
Steering Column Ignition Switch
Front and Rear Ignition- 1 Relay,
Oxygen Sensor
I and 2 Fuse. Fuel
Fuse. Cruise Fuse, DRL Relay,
Front and Rear Fog Lamp Relay,
Control Power Back-Up Relay,
Ignition-
1 Fuse
Starter Relay
and Solenoid.
Park/Rev Fuse. Park Relay, PCM
Fuse,
AC Compressor Fuse and
Relay, Fan Relay
ABS Brake Modulator
Cooling Fan Relays
1 and 3
‘I: Do not alter OBD I1 related fuses or circuit breakers.