change key battery CADILLAC SEVILLE 1997 4.G Owners Manual
[x] Cancel search | Manufacturer: CADILLAC, Model Year: 1997, Model line: SEVILLE, Model: CADILLAC SEVILLE 1997 4.GPages: 370, PDF Size: 20.52 MB
Page 69 of 370
Downloaded from www.Manualslib.com manuals search engine This device, complies with Part 15 of the FCC Rules.
Operation
is subject to the following two conditions:
( 1) this device may not cause harmful interference.
and
(2) this device must accept any interference
received, including interference that may cause
undesired operation.
This device complies with
RSS-210 of Industry and
Science Canada. Operation
is subject to the following
two conditions:
( 1 ) this device may not cause
interference, and
(2) this device must accept any
interference received, including interference that may
cause undesired operation
of the device.
Changes or modifications
to this system by other than
an authorized service facility could void authorization
to use this equipment.
r_l Ihe range of this system is about 10 feet (3 m). At times
you may notice
a decrease in range. This is normal for
any remote keyless entry system. If the transmitter does
not work or if you have to stand closer to your vehicle
for the transmitter to work, try this:
e Check to determine if battery replacement is
necessary. See the instructions that
follow.
Check the distance. You may be too far from your
vehicle. You may need to stand closer during rainy
or snowy wsather.
a
a
Check the location. Other vehicles or objects may
be blocking the
signal. Take a few steps to the left
or right, hold the transmitter higher, and try again.
If you‘re still having trouble, see your Cadillac
dealer or
a qualified technician for service.
& When you press this symbol to unlock the
driver’s door, the parking lamps on your vehicle will
blink twice.
(You can progmm your vehicle so the
parking lamps will
not flash. For more information,
see “Remote Confirmation” later in this section.)
Pressing
it again within five seconds will unlock the
other doors. Pressing this button will also disarm the
optional theft-deterrent system and turn on the interior
lamps at night.
When you press this symbol
to lock the doors,
the parking
lamps will blink once. (You can program
your vehicle
so the parking lamps will not flash. For
more information, see “Remote Confirmation” later
in this section.) This also arms the optional
theft-deterrent system when the ignition
is off.
-4
Page 72 of 370
Downloaded from www.Manualslib.com manuals search engine If a no response was made, the KEY IN RECALL
MEMORY prompt will show next. This choice recalls
memory settings when the key is placed in your
vehicle's ignition.
A yes or no response is required.
For
a list of the other personalization features available,
see "Memory and Personalization Features" later
in
this section.
Each remote keyless entry transmitter is coded to
prevent another transmitter from unlocking your vehicle.
If a transmitter is lost or stolen. a replacement can be
purchased through your dealer. Once your dealer has
coded the new transmitter, the lost transmitter will not
unlock
your vehicle. Each vehicle can have only two
transmitters matched to
it.
Under normal use, the battery in your remote keyless
entry transmitter should last about
four years.
You can tell the battery is weak if the transmitter won't
work at the normal range in any location. If you have to
get close
to your vehicle before the transmitter works.
it's probably time to change the battery.
I NOTICE: I
When replacing the battery, use care not to touch
any
of the circuitry. Static from your body
transferred
to these surfaces may damage
the transmitter.
I. Use the round end of the door key or a coin to pry
open the transmitter.
Page 83 of 370
Downloaded from www.Manualslib.com manuals search engine I NOTICE:
~
Holding your key in START for longer than
15 seconds at a time will cause your battery to
be drained much sooner. And the excessive heat
can damage your starter motor.
2. If it doesn’t start right away, hold your key in
START for about three seconds at a time until your
engine starts. Wait about
15 seconds between each
try to help avoid draining your battery.
3. If your engine still won’t start (or starts but then
stops), it could be flooded with too much gasoline.
Try pushing your accelerator pedal all the way
to the
floor and holding
it there as you hold the key in
START for about three seconds.
If the vehicle starts
briefly but then
stops again, do the same thing.
I NOTICE:
Your engine is designed to work with the
electronics in your vehicle.
If you add electrical
parts
or accessories, you could change the way
the engine operates. Before adding electrical
equipment, check with your dealer.
If you don’t,
your engine might
not perform properly.
If you ever have to have your vehicle towed, see
the part
of this manual that tells how to do it
without damaging your vehicle. See “Towing
Your Vehicle”
in the Index.
Page 146 of 370
Downloaded from www.Manualslib.com manuals search engine IC-
Press the AVG button to display the average
mile-per-gallon (AVG MPG). You can also display it in
metric units by pressing the
ENGMET button.
When AVG MPG
is selected, the total distance is
divided by the total fuel used.
When the INST button (Instantaneous Fuel Economy) is
selected. you will see what the fuel economy is at that
instant. The computer takes
a new reading twice every
second.
It will show economy up to 70 miles-per-gallon
(or 2 L per- 100 ltm).
To reset the average fuel economy, press the
INFORMATION button until the AVG MPG is
displayed on the DIC. Press and hold the
RESET button
until both the fuel data center and DIC display reads
0.0.
The RANGE display shows how far the computer thinks
you can travel with the fuel that is in the tank. The
computer does
not know what driving conditions will be
like for the rest of your trip,
so the range is estimated
based on
the recent fuel economy. Therefore, the range
reading may change
as your driving habits change.
Going from city
to highway driving may increase the
range reading.
If the range display shows
LO, you should stop for fuel
as soon
as possible. Your computer needs enough data
for the RANGE reading to work. The
DIC display gives you the
status of many of your
vehicle’s systems. The DIC is also used to display driver
personalization features and warninghtatus messages.
Your vehicle may be equipped with the following
features that can be individually customized for up
to two drivers.
0
0
0
0
0
0
0
0
Programmable Automatic Door Locks
Remote Confirmation (for
RKE)
Exterior Lighting (at Unlock)
Remote Recall Memory (for RKE or Key
in
the Ignition)
Battery Guard Storage
Climate Control Personalization
Memory Seat and Mirrors
Radio Personalization
For detailed information, see each feature in the Index.