battery replacement CADILLAC XLR 2007 1.G Owners Manual
[x] Cancel search | Manufacturer: CADILLAC, Model Year: 2007, Model line: XLR, Model: CADILLAC XLR 2007 1.GPages: 512, PDF Size: 3.84 MB
Page 68 of 512

If you ever notice a decrease in the keyless
access transmitter range, try doing one of the
following:
Check the distance. You may be too far from
your vehicle. You may need to stand closer
during rainy or snowy weather.
Check the location. Other vehicles or objects
may be blocking the signal. Take a few steps
to the left or right, hold the transmitter
higher, and try again.
Check to determine if battery replacement is
necessary. See “Battery Replacement”
underKeyless Access System Operation on
page 68.
Check to make sure that an electronic device
such as a cellular phone or lap top computer
is not causing interference.
If you are still having trouble, see your dealer
or a quali ed technician for service.
Keyless Access System Operation
Your vehicle has a Keyless Access System
that allows you to lock and unlock your doors,
unlock your trunk lid and disarm or arm your
theft-deterrent system. The range distance is as
much as 100 feet (30 m) away.
Your vehicle comes with
two transmitters, and up
to four can be matched
to your vehicle. See
“Matching Transmitter(s)
to Your Vehicle” later
in this section.
Q(Lock):Press this button to lock the doors.
The indicator light on the door will ash once.
If this button is pressed twice, the doors will
lock, the light will ash once and the horn will
sound once.
68
Page 72 of 512

Battery Replacement
Under normal use, the battery in your keyless
access transmitter should last about three years.
You can tell the battery is weak if the transmitter
will not work at the normal range in any location. If
you have to get close to your vehicle before the
transmitter works, it is probably time to change the
battery.
A weak battery may also cause the DIC to display
NO FOB DETECTED when you try to start the
vehicle. If this happens, place the transmitter in the
glove box transmitter pocket with the buttons facing
to the right. Then, with the vehicle in PARK (P) or
NEUTRAL (N), press the brake pedal and the
START button. Although this will start the vehicle, it
is recommended that you replace the transmitter
battery as soon as possible. The DIC may display
FOB BATTERY LOW.
Notice:When replacing the battery, use care
not to touch any of the circuitry. Static
from your body transferred to these surfaces
may damage the transmitter.1. Insert a at object with a thin edge into the
slot on the side of the transmitter and
separate the bottom half from the top half.
2. Gently pull the battery out of the transmitter.
3. Put the new battery in the transmitter,
positive (+) side up. Use a battery, type
CR2032, or equivalent.
4. Reassemble the transmitter. Make sure to put
it together so water will not get in.
5. Test the transmitter.
72
Page 82 of 512

Power Windows
The power window
switches are located on
each door near the
armrest.
Press the up or down arrows on the switches to
raise or lower the windows.
Your vehicle has Retained Accessory Power
(RAP) that allows you to use the power windows
once the ignition has been turned off. For
more information, seeRetained Accessory Power
(RAP) on page 89.
Power Window Initialize
After a power reconnect such as battery
replacement, the express-up and index-up features
will not function until the system is initialized.
Once power is restored, do the following:
1. Close the door.
2. Raise the window by holding the up arrow on
the power window switch.
3. Hold the up arrow for three seconds after the
window is closed. Release the switch. Then
hold the up arrow again for three seconds.
The express-up system must be initialized to
operate the windows with the door open.
Express-Down Window
This feature is on both power windows. Press the
down arrow on the switch to the second position
to activate the express-down feature. If you want to
stop the window as it is lowering, press the
switch again.
82
Page 90 of 512

To start you vehicle, do the following:
1. With your foot on the brake pedal, press the
START button located on the instrument
panel.
If there is not a keyless access transmitter in
the vehicle or if there is something causing
interference with it, the DIC will display
NO FOB DETECTED. SeeDIC Warnings and
Messages on page 206for more information.
2. When the engine begins cranking, let go of
the button and the engine cranks automatically
until it starts. If the battery in the keyless
access transmitter is weak, the DIC displays
FOB BATTERY LOW. You can still drive
the vehicle.
See “Battery Replacement” underKeyless
Access System Operation on page 68for more
information. If the fob battery is dead, you
need to insert the fob into the fob slot to enable
engine starting. See″No Fobs Detected″
underDIC Warnings and Messages on
page 206.3. Do not race the engine immediately after
starting it. Operate the engine and
transmission gently until the oil warms up and
lubricates all moving parts.
4. If the engine does not start and no DIC
message is displayed, wait 15 seconds
before trying again to let the cranking motor
cool down.
If the engine does not start after 5-10 seconds,
especially in very cold weather (below 0°F
or−18°C), it could be ooded with too much
gasoline. Try pushing the accelerator pedal all
the way to the oor while cranking for up to
15 seconds maximum. Wait at least
15 seconds between each try, to allow the
cranking motor to cool down. When the engine
starts, let go of the accelerator. If the vehicle
starts brie y but then stops again, do the same
thing. This clears the extra gasoline from the
engine.
90