garage door opener CHEVROLET ASTRO 1997 2.G Owners Manual
[x] Cancel search | Manufacturer: CHEVROLET, Model Year: 1997, Model line: ASTRO, Model: CHEVROLET ASTRO 1997 2.GPages: 404, PDF Size: 20.63 MB
Page 119 of 404
Downloaded from www.Manualslib.com manuals search engine Reading Lamps
Press the button near each
lamp to turn the reading
lamps on and off.
The lamps can
also be swiveled to point in the direction
you want.
Installing a Garage Door Opener
If you have a garage door opener, the front
overhead compartment can be used
to conveniently
store the opener.
To install the garage door opener, first open the
compartment door
by pressing the latch forward.
Peel the protective
backing from the
hook
and loop patch.
Press
it firmly to the back of your garage door opener,
as close to the center of the opener as possible.
Center the garage door opener activation button over
the console door button and press the opener firmly
into place.
2-45
Page 120 of 404
Downloaded from www.Manualslib.com manuals search engine The pegs inside the
compartment door are used
to make sure the button
on
the compartment door will
contact
the control button
on the garage door opener.
Add one peg at a time
until the garage door opener
operates with the compartment
door closed when you
press the button. Now, with
the compartment
door closed, press the
button again
to make sure
the garage door opener
operates properly.
With the garage door opener positioned properly and
the right number
of pegs in place, you should only
have to press the button slightly to operate the opener.
Adjust
the position of the garage door opener and
add or remove pegs, as needed, until the opener
operates properly. Refer
to “Universal Transmitter
(Option)”
text in this section.
2-46
Page 127 of 404
Downloaded from www.Manualslib.com manuals search engine Universal Transmitter (Option)
This transmitter allows you to consolidate the functions
of up to three individual hand-held transmitters.
It
will operate garage doors and gates, or with the
accessory package, other devices controlled by
radio frequency such as home/office lighting systems
and security systems.
The transmitter will learn and transmit the frequencies
of most current transmitters and is powered by your
vehicle’s battery and charging system. This device
complies with Part
15 of the FCC Rules.
Operation is subject to the following two conditions:
( 1) this device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
This device complies with RSS-2
10 of Industry and
Science Canada. Operation is subject
to the following
two conditions:
(1) this device may not cause
interference, and
(2) this device must accept any
interference received, including interference that may
cause undesired operation
of the device.
Changes or modifications to this system by other than an
authorized service facility could void authorization
to
use this equipment.
Programming the Transmitter
Do not use the transmitter with any garage door opener
that does not have the “stop and reverse” feature. This
includes any garage door opener model manufactured
before April
1, 1982.
Be sure tkat people and objects are clear of the garage
door
you are programming.
2-53
Page 128 of 404
Downloaded from www.Manualslib.com manuals search engine Your vehicle’s engine should be turned off while
programming the transmitter. Follow these steps to
program up to three channels:
1.
2.
3.
4.
If you have previously programmed a universal
channel, proceed
to Step 2. Otherwise, hold down
the two outside buttons
on the universal transmitter
until the red light begins
to flash rapidly
(approximately
20 seconds). Then release the
buttons. This procedure initializes the memory and
erases any previous settings for all three channels.
Hold the end
of the hand-held transmitter against the
bottom surface of the universal transmitter
so that
you can still see the red light.
Decide which one of the three channels
you want to
program. Using both hands, press the hand-held
transmitter button and the desired button on
the
universal transmitter. Continue to hold both buttons
through Step
4.
Hold down both buttons until you see the red light
on the universal transmitter flash rapidly. The rapid
flashing, which could take up
to 90 seconds,
indicates that
the universal transmitter has been
programmed. Release both buttons once
the light
starts
to flash rapidly. If
you have trouble programming the universal
transmitter, make sure that
you have followed the
directions exactly as described and that the battery in
the hand-held transmitter is not dead. If
you still
cannot program
it, rotate the hand-held transmitter
end over end and try again. The universal transmitter
may
not work with older garage door openers that do
not meet current Federal Consumer Safety Standards.
If you cannot program the transmitter after repeated
attempts, consult your
GM dealer.
Be sure to keep the original hand-held transmitter
in case you need to erase and reprogram the
universal transmitter.
Operating the Transmitter
Press and hold the appropriate button on the universal
transmitter. The red light comes
on while the signal is
being transmitted.
Note that the effective transmission range
of the
universal transmitter may differ from the hand-held
transmitter and from one channel to another.
2-54
Page 129 of 404
Downloaded from www.Manualslib.com manuals search engine Erasing Channels
To erase all three programmed channels, hold down the
two outside buttons
until the red light begins to flash.
Individual channels cannot be erased, but can be
reprogrammed using the procedure for programming the
transmitter explained earlier.
Training a Garage Opener with a “Rolling
Code” Feature
If you programmed the universal transmitter, but the
garage door will
not open, and if your garage door opener
was manufactured after 1995, your garage door may have
a security feature that changes
the “code” of your garage
door opener every time it is opened or closed.
To determine if your garage door opener has this
“rolling code” feature, press the appropriate button on
the universal transmitter that was programmed. If the
red light flashes rapidly for
one to two seconds, then
turns solid, your garage door opener has this feature.
To program a garage door opener with the rolling code
feature, do
the following:
1. Program your hand-held transmitter to the universal
transmitter by following the steps provided under
“Programming
the Transmitter” earlier in this section.
2.
3.
4.
5.
6.
Remove the cover panel from the garage door opener
receiver.
It is located near the garage door opener motor.
Locate the training button
on the garage door opener
receiver. The exact location and color will vary
among brands.
Press the training button
on the garage door opener
receiver for one to two seconds.
Return to your vehicle and press the programmed
button on the universal transmitter until the red light
flashes rapidly (about two seconds).
Release the button, then press it again
to confirm it
was programmed
to the garage door opener receiver.
You may now use either the universal transmitter or the
hand-held transmitter to open your garage door.
If you
still have difficulty in programming and require
assistance, please call
1-800-355-35 15.
Accessories
Accessories for the universal transmitter are available
from
the manufacturer of the unit. If you would like
additional information, please call
1-800-355-35 15.
2-55
Page 394 of 404
Downloaded from www.Manualslib.com manuals search engine Engineoil .................................... 6-11
Adding ..................................... 6-12
Additives
................................... 6- 14
Checking
................................... 6-11
Pressure Gage ................................ 2-68
Used
....................................... 6-14
Whentochange
.............................. 6-14
Exhaust, Engine
....... 2-27,2-28,2-30,4-27,4-34, 4-35
Express-Down Window
.......................... 2-29
Fabric Cleaning
............................... 6-52
FillingYourTank
6-5
Fi 1 ter
.
................................
Air Cleaner Replacement ....................... 6-68
Engine Oil Replacement
....................... 6-68
Finish Care
.................................... 6-56
Finish Damage
................................. 6-58
FirstGear ..................................... 2-22
Flashers, Hazard Warning
......................... 5-2
Flat Tire. Changing
............................. 5-23
Fluid Capacities
........................... 6.66. 6.67
Foreign Countries. Fuel
........................... 6-4
Fluids and Lubricants ............................ 7-49
French Language Manual
11
Front
Axle
....................................... 6-24
Towing
................................. 5-9. 5.10
Turn Signal Lamp Bulb Replacement ............. 6-40
.. ...........................
Storage Area ................................. 2-42
Fuel .......................................... 6-3
Filling Your Tank
.............................. 6-5
Gage
....................................... 2-69
In Foreign Countries ........................... 6-4
Regulator
................................... 2-18
Fuses and Circuit Breakers
....................... 6-61
Gages Engine Coolant Temperature
.................... 2-64
Fuel ....................................... 2-69
Engine Oil Pressure
........................... 2-67
Garage Door Opener
............................ 2-45
GAWR
....................................... 4-28
Gear Positions. Automatic Transmission
............. 2-19
GloveBox
.................................... 2-42
Gross Axle Weight Rating
........................ 4-28
Gross Vehicle Weight Rating
...................... 4-28
Guide en Franpis 11
GVWR ....................................... 4-28
.. .................................
Halogen Bulbs ................................ 6-36
Hatch Release
.................................. 2-12
Hazard Warning Flashers
.......................... 5-2
Head Restraints
................................. 1-5
Headlamps .................................... 2-38
Bulb Replacement
............................ 6-37
High/Low Beam Changer ...................... 2-32
Wiring
..................................... 6-61
OnReminder ................................ 2-38
9-4
Page 396 of 404
Downloaded from www.Manualslib.com manuals search engine Loading Your Vehicle ........................... 4-28
Cylinders
................................... 7-44
Door
........................................ 2-6
Ignition Transmission Lock Check
............... 7-46
Key Lock Cylinder Service
..................... 7-44
PowerDoor
.................................. 2-7
Sliding Door Child Security
..................... 2- I I
Lubricants and Fluids ............................ 7-49
Lubrication Service. Body
........................ 7-44
Luggagecarrier
................................ 2-49
Lumbar Controls
................................ 1-3
Locks
Maintenance. Normal Replacement Parts
........... 6-68
Maintenance Record
............................ 7-5 1
Maintenance Schedule ............................ 7- I
Long Trip/Highway Definition ................... 7-6
Long Tripmighway Intervals ..................... 7-6
Owner Checks and Services
..................... 7-43
Periodic Maintenance Inspections
................ 7-47
Recommended Fluids and Lubricants
............. 7-49
Scheduled Maintenance Services
.................. 7-4
Short TripKity Definition
....................... 7-5
Short TripKity Intervals ........................ 7-5
Maintenance When Trailer Towing
................. 4-38
Malfunction Indicator Lamp
...................... 2-65
ManualFrontSeat
............................... 1-2
Methanol
...................................... 6-3
Maintenance. Underbody
......................... 6-58
Manual Lumbar Support
.......................... 1-3 Mirrors
....................................... 2-41
Convex Outside
.............................. 2-42
Inside Day/Night Rearview
..................... 2-41
Outside
..................................... 2-41
Visorvanity
................................. 2-52
MMT
......................................... 6-3
Model Reference
................................. vi
MountainRoads ................................ 4-22
Net. Convenience
.............................. 2-49
Neutral
....................................... 2-21
New Vehicle Break-In
........................... 2-15
Nightvision
................................... 4-15
odometer
.................................... 2-59
Odometer. Trip
................................. 2-59
Off-Road Recovery
............................. 4-11
Oil. Engine
.................................... 6-11
Opener. Garage Door ............................ 2-45
Outside Mirror
................................. 2-41
Overhead Console
.............................. 2-44
Overheating Engine
............................. 5-13
Owner Checks and Services
....................... 7-43
Owner Publications. Ordering
................ 8- 1 I. 8- 12
Paint Spotting. Chemical
........................ 6-58
Park(P)
...................................... 2-19
Shifting Into ................................. 2-24
Shifting Out of
............................... 2-26