lock CHEVROLET BLAZER 1995 2.G User Guide

Downloaded from www.Manualslib.com manuals search engine Lapshoulder Belt
The positions next to the windows have lap-shoulder belts. Here’s how to
wear one properly.
1. Pick up the latch plate and pull the belt across you. Don’\
t let it get
twisted. On four-door models, the shoulder belt may lock if you pull
the belt across you very quickly. If this happens, let the belt go back
slightly to unlock it. Then pull the belt across you more slowly.
2. Push the latch plate into the buckle until it clicks.
Pull up on the latch plate to make sure it is secure.
When the shoulder belt
is pulled out all the way, it will lock. If it doesr
let it go back all the way and start again.
If the belt
is not long enough, see “Safety Belt Extender’’ at the end of
this section.
Make sure the release button on the buckle is positioned
so you would
be able
to unbuckle the safety belt quickly if you ever had to.
3. To make the lap part tight, pull down on the buckle end of the belt as
you pull up on the shoulder part.
1-25

Downloaded from www.Manualslib.com manuals search engine I I It
The lap part of the belt should be worn low and snug on the hips, just
touching the thighs. In a crash, this applies force to the strong pelvic bones.
And you’d be less likely to slide under the lap belt.
If you slid under it, the
belt would apply force at your abdomen. This could cause serious or even
fatal injuries. The shoulder belt should
go over the shoulder and across the
chest. These parts of the body are best able to take belt restraining forces.
The safety belt locks
if there’s a sudden stop or a crash.
On four-door models, the safety belt also locks
if you pull the belt very
quickly out
of the retractor.

Downloaded from www.Manualslib.com manuals search engine 5. Pull the rest of the shoulder belt all the way out of the retractor to set
the lock.
Lsi
II
11
-, -
1
I
i
6. To tighten the belt, feed the shoulder belt back into the retractor while
you push down on the child restraint.
7. Push and pull the child restraint in different directions to be sure it is
secure. If you're using a bucket seat, adjust the seat forward until the
lap portion
of the safety belt holds the restraint firmly. But don't move
it any more than needed to tighten the lap belt.
To remove the child restraint, just unbuckle the vehicle's safety belt and let
it
go back all the way.
The safety belt will move freely again and be ready to work for an adult or
larger child passenger.
1-37

Downloaded from www.Manualslib.com manuals search engine This vehicle has one
double-sided key for
the ignition, endgate,
spare tire lock
(two-door vehicles)
and door locks. It will
fit with either side up.
0
* 0000 *
provides the owner
with a pair
of identical
keys and a bar-coded
tag.
The bar-coded tag has a code on it that tells your dealer or a qualified
locksmith
how to make extra keys. Keep this tag in a safe place. If you lose
your keys, you’ll be able to have new ones made easily using this tag.
2-2

Downloaded from www.Manualslib.com manuals search engine I NOTICE:
Your vehicle has a number of new features that can help prevent
theft. But you can have a lot of trouble getting into your v\
ehicle
if you ever lock your keys inside. You may even have to damage
your vehicle to get in.
So be sure you have extra keys.
Your Doors And How They Work
Side Doors
To open the door from
the inside, pull the
lever toward you and
push the door open.
2-3

Downloaded from www.Manualslib.com manuals search engine Door Locks
There are several ways to lock and unlock your vehicle:
1
1
i.
3 I
1
1
From the outside: Use
your key.
2-4

Downloaded from www.Manualslib.com manuals search engine Power Door Locks
If your vehicle has
power door locks,
push
LOCK on the
power door lock
switch on the door
armrest. This switch
will lock all the doors
at once.
To unlock the doors,
push on the raised
area next to the key symbol.
On four-door models, the lever on each rear door works only that door's
lock.
2-5

Downloaded from www.Manualslib.com manuals search engine Child Security Locks
7
With this feature, you
can lock the rear doors
so they can’t be
opened from the
inside by passengers.
Move the lock up to
lock the doors and
down to release the
door locks.
Leaving Your Vehicle
If you are leaving the vehicle, take your key, open your door and set th\
e
locks from inside. Then get out and close the door.
Keyless Entry System
If your vehicle has this option, you can lock and unlock your doors or
unlock your rear endgate from up to
30 feet (9 m) away using the key chain
transmitter supplied with your vehicle.
Your Keyless Entry System operates on a radio frequency subject to Federal
Communications Commission (FCC) Rules.
This device complies with Part
15 of the FCC Rules. Operation is subject to
the following
two conditions: (1) This device may not cause harmful
interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
Should interference
to this system occur, try this:
0 Check to determine if battery replacement is necessary. See the
Check the distance. You may be too far from your vehicle. This product
instructions on battery replacement.
has a maximum range.
0 Check the location. Other vehicles or objects may be blocking the
signal.
See your GM dealer or a qualified technician for service.
Changes
or modifications to this system by other than an authorized service
facility could void authorization to use this equipment.
2-6

Downloaded from www.Manualslib.com manuals search engine Operation
When you press UNLOCK, the driver’s door will unlock automatically. If
you press UNLOCK again within five seconds, all doors will unlock. All
doors will lock when LOCK is pressed.
The endgate glass will unlock when the REAR button is pressed. Vehicles
with automatic transmissions must have the transmission in PARK
(P).
Vehicles with manual transmission must have the parking brake engaged.
Matching Transmitter(s) To Your Vehicle
Each key chain transmitter is coded to prevent another transmitter from
unlocking your vehicle.
If a transmitter is lost or stolen, a replacement can
be purchased through your dealer. Remember
to bring any remaining
transmitters with you when you go to your dealer. When the dealer matches
the replacement transmitter to your vehicle, the remaining transmitters must
also be matched. Once the
new transmitter is coded, the lost transmitter will
not unlock your vehicle.
You can match a transmitter to as many different vehicles as you own,
provided they are equipped with
exactly the same model system. (General
Motors offers several different models of these systems on their vehicles.)
Each vehicle can have only two transmitters matched to it.
See your dealer to match transmitters to another vehicle.
Battery Replacement
Under normal use, the batteries in your key chain transmitter should last
about two years.
You can tell the batteries are weak if the transmitter won’t work at the
normal range in any location.
If you have to get close to your vehicle before
the transmitter works, it’s probably time to change the batteries.
2-7

Downloaded from www.Manualslib.com manuals search engine Your transmitter housing snaps apart for ease in battery replacement. To
open the housing:
I 1. Insert a dime
between two halves
of the
transmitter
housing near the key ring hole.
2. Remove the
bottom by
twisting the dime.
3. Remove and replace the batteries with two Duracell @-type batte\
ries
(DL2016 or equivalent), positive side down.
4. Align and snap together the back and top transmitter housings. \
Endgate (Hatch) Release
To open a mechanical
lock system from the
outside, insert the key in the lock and turn to
the left to unlock the
glass.
If your vehicle
has an
endgate-mounted spare tire carrier, you
must move the carrier
arm out of the way to
open the glass.
2-8