boot CHEVROLET BLAZER 1998 2.G Owners Manual

Downloaded from www.Manualslib.com manuals search engine When your vehicle is being towed, have the ignition key
turned to the OFF position. The steering wheel should
be clamped in a straight-ahead position with
a clamping
device designed for towing service.
Do not use the
vehicle’s steering column lock for this. The transmission
should be in
NEUTRAL (N) and the transfer case, if you
have one, should be in 2HI. The parking brake should
be released.
If your vehicle has a floor-mounted shifter and no
electrical power, the electrical solenoid lock must be
overridden to shift from PARK
(P) to NEUTRAL (N).
Follow these steps:
1. Push the base of the shift lever boot forward with
your thumb.
2. Lift the boot and find the white solenoid lever.
3. Move the solenoid lever
toward the driver’s side
to unlock
it.
4. While holding the solenoid lever in the unlock
position, press
the shift lever button and shift into
NEUTRAL
(N).
5. Release the solenoid lever and snap the boot back
into place.
Don’t have your vehicle towed on the drive wheels
unless you must. If the vehicle must be towed on the
drive wheels, be sure to follow the speed and distance
restrictions later
in this section or your transmission will
be damaged. If these limitations must be exceeded, then
the drive wheels have to be supported on a dolly.
5-9

Downloaded from www.Manualslib.com manuals search engine Part C: Periodic Maintenance
Inspections
Listed below are inspections and services which should
be performed at least twice a year (for instance, each
spring and fall).
You should let your dealer’s service
department
or other qualified service center do these
jobs. Make sure any necessary repairs are completed
at once.
Proper procedures to perform these services may be
found in a service manual. See “Service and Owner
Publications” in the Index.
Steering, Suspension and Front Drive Axle
Boot and Seal Inspection
Inspect the front and rear suspension and steering
system for damaged,
loose or missing parts, signs of
wear or lack of lubrication. Inspect the power steering
lines and hoses for proper hook-up, binding, leaks,
cracks, chafing, etc. Clean and then inspect the drive
axle boot seals for damage, tears or leakage. Replace
seals if necessary.
Exhaust System Inspection
Inspect the complete exhaust system. Inspect the body
near the exhaust system. Look for broken, damaged,
missing or out-of-position parts as well as open seams,
holes,
loose connections or other conditions which could
cause a heat build-up in the
floor pan or could let
exhaust fumes into the vehicle. See “Engine Exhaust” in
the Index.
Engine Cooling System Inspection
Inspect the hoses and have them replaced if they are
cracked, swollen or deteriorated. Inspect all pipes, fittings
and clamps; replace as needed. Clean the outside of the
radiator and air conditioning condenser.
To help ensure
proper operation, a pressure test of the cooling system and
pressure cap is recommended at least once a year.
Throttle System Inspection
Inspect the throttle system for interference or binding,
and for damaged or missing parts. Replace parts as
needed. Replace any components that have high effort
or excessive wear.
Do not lubricate accelerator and
cruise control cables.
7-43

Downloaded from www.Manualslib.com manuals search engine Bulb Replacement ............................ 6-34
OnReminder
................................ 2-41
Wiring
..................................... 6-59
Hearing Impaired. Customer Assistance
.............. 8-4
Heated Front Seats
............................... 1-5
Heated Outside Mirrors
.......................... 2-46
Heating
........................................ 3-7
Highway Hypnosis
.............................. 4-34
Hill and Mountain Roads
......................... 4-34
Hitches. Trailer
................................. 4-45
Hood
.......................................... 6-8
Horn
......................................... 2-33
Hydraulic Clutch
............................... 6-20
Check
...................................... 7-40
Hydroplaning
.................................. 4-30
HighLow
Beam Changer
...................... 2-35
Ignition Positions
.................................... 2-14
Transmission Lock Check
...................... 7-42
Illuminated Entry
............................... 2-43
Inflation. Tire
............................. 6.41. 7.39
Inside Daymight Rearview Mirror
................. 2-44
Inspections Brakesystem
................................ 7-44
Engine Cooling System
........................ 7-43
Exhaust Systems
............................. 7-43
Front Drive Axle Boot Seal
..................... 7-43
Steering
.................................... 7-43
Suspension
.................................. 7-43
Throttle System
.............................. 7-43
Transfer Case
................................ 7-44
Ignition Transmission Lock Check
................. 7-42 Instrument Panel
............................... 2-64
Cleaning
.................................... 6-52
Cluster
................................ 2.65. 2.66
Fuse Block
.................................. 6-60
Interior Lamps
................................. 2-43
Jacking Equipment
............................. 5-22
Jump Starting
................................... 5-3
Key in the Ignition
............................. 2-12
Key Lock Cylinders Service
...................... 7-40
Key Release Button
............................. 2-15
Keyless Entry System
............................ 2-6
Labels Keys
.......................................... 2-2
Certificatioflire
............................. 4-40
Fuse
.................................. 6.60. 6.62
Safety Belt
.................................. 1-57
Service Parts Identification ..................... 6-58
Vehicle Identification Number
................... 6-58
Lamps
........................................ 2-40
Dome
...................................... 2-43
FrontMap
................................... 2-43
Front Reading
........................... 2.43. 2.47
Interior
..................................... 2-43
OnReminder
................................ 2-41
Latches. Seatback
................................ 1-7
Leaving Your Vehicle
............................. 2-5
Leaving Your Vehicle
with the Engine Running ....... 2-25
Lighter
....................................... 2-57
Lights Air Bag Readiness
....................... 1.25. 2.69
Anti-Lock Brake System Warning ............ 2.72. 4.7