ESP CHEVROLET CAMARO 1993 Owner's Manual
[x] Cancel search | Manufacturer: CHEVROLET, Model Year: 1993, Model line: CAMARO, Model: CHEVROLET CAMARO 1993Pages: 358, PDF Size: 15.6 MB
Page 262 of 358

Service & Appearance Care
9 9 9 258
When to Check: Check your tires once a
month
or more. Don’t forget your
compact spare tire. It should be at
60 psi
(420 kPa).
How to Check: Use a good quality
pocket-type gage to check tire pressure.
Simply looking at the tires will not tell
you the pressure, especially if you have
radial tires
- which may look properly
inflated even if they’re underinflated.
If your tires have valve caps, be sure to
put them back on. They help prevent
leaks by keeping out
dirt and moisture.
L
’
Tire Inspection and Rotation
To make your tires last longer, have them
inspected and rotated at the mileages
recommended
in the Maintenance
Schedule. See “Scheduled Maintenance
Services”
in the Index.
If you don’t have
P245/50ZR 16 size tires,
use the rotation pattern shown above for
your size tires. If
you have P245/50ZR16 size tires, they
must roll
in a certain direction for the best
overall performance. The direction is
shown by an arrow on both sidewalls.
Because these tires are directional, they
should
be rotated as shown in the
example above. These tires should only
be moved from front to rear and rear to
front on the same side of the vehicle.
After the tires have been rotated, adjust
the front and rear inflation pressure as
shown on the Tire-Loading Information
label. Make certain that all wheel nuts are
properly tightened. See “Wheel
Nut
Torque” in the Index.
ProCarManuals.com
Page 265 of 358

Treadwear
The treadwear grade is a comparative
rating based on the wear rate of the tire
when tested under controlled conditions
on a specified government test course. For
example, a tire graded
150 would wear
one and a half
(1 1/2) times as well on the
government course as a tire graded
100.
The relative performance of tires depends
upon the actual conditions of their use,
however, and may depart significantly
from the norm due
to variations in driving
habits, service practices and differences
in
road characteristics and climate.
Traction - A, B, C
The traction grades, from highest to
lowest are:
A, B, and C. They represent
the tire’s ability
to stop on wet pavement
as measured under controlled conditions
on specified government test surfaces of
asphalt and concrete.
A tire marked C
may have poor traction performance.
Warning: The traction grade assigned
to
this tire is based on braking
(straight-ahead) traction tests and does
no1 include cornering (turning) traction.
Temperature - A, B, C
The temperature grades are A (the
highest),
B, and C, representing the tire’s
resistance to the generation of heat and
its
ability to dissipate heat when tested under
controlled conditions on a specified
indoor laboratory test wheel. Sustained
high temperature can cause the material
of the tire to degenerate and reduce tire
life, and excessive temperature can lead to
sudden tire failure. The grade
C
corresponds to a level of performance
which all passenger car tires must meet
under the Federal Motor Vehicle Safety
Standard
No. 109. Grades B and A
261
ProCarManuals.com
Page 266 of 358

Service & Appearance Care
represent higher levels of performance on
the laboratory test wheel than the
minimum required by law.
Warning: The temperature grade for this
tire is established for a tire that is properly
inflated and not overloaded. Excessive
speed, underinflation, or excessive
loading, either separately or
in
combination, can cause heat buildup and
possible tire failure. Those grades
are molded on the sidewalls
of passenger car tires.
While the tires available as standard or
optional equipment on General Motors
vehicles may vary with respect to these
grades, all such tires meet General Motors
performance standards and have been
approved for use
on General Motors
vehicles.
All passenger type (P Metric)
tires must conform
to Federal safety
requirements
in addition to these grades.
Wheel Alignment and Tire Balance
The wheels on your vehicle were aligned
and balanced carefully at the factory to
give you the longest tire life and best
overall performance.
In most cases, you will not need to have
your wheels aligned again. However,
if
you notice unusual tire wear or your
vehicle pulling one way or the other, the
alignment may need to be reset.
If you
notice your vehicle vibrating when
driving on a smooth road, your wheels
may need to be rebalanced.
... 262
ProCarManuals.com
Page 312 of 358

Maintenance Schedule
Section E: Maintenance Record
After the scheduled services are performed, record the date, or Schedule I1 maintenance charts which correspond to the
odometer reading and who performed the service in the
maintenance performed. Also,
you should retain all
columns indicated. When completing the Maintenance maintenance receipts.
Your owner information portfolio is a
Performed column, insert the numbers from the Schedule
I convenient place to store them.
... 308
DATE ODOMETER
READING SERVICED BY MAINTENANCE PERFORMED
ProCarManuals.com
Page 318 of 358

Customer Assistance Information
Customer Satisfaction
Procedure
Your satisfaction and goodwill are
important to your dealer and Chevrolet.
Normally, any concerns
with the sales
transaction or the operation
of your
vehicle
will be resolved by your dealer’s
Sales or Service Departments.
Sometimes, however, despite
the best
intentions of all concerned,
misunderstandings can occur. If your
concern has not been resolved to your
satisfaction, the following steps should be
taken:
STEP ONE: Discuss your concern with a
member of dealership management.
Complaints can often be quickly resolved
at that level. If the matter has already
been reviewed
with the Sales, Service, or
Parts Manager, contact the owner
of the
dealership or the General Manager.
STEP TWO: If after contacting a
member
of Dealership Management, it
appears your concern cannot be resolved
by the dealership without further help,
contact the Chevrolet Customer
Assistance Center by calling
1-800-222- 1020. In Canada, contact
GM of Canada Customer Assistance
Center in Oshawa by calling
1-800-263-3777 (English) or
1-800-263-7854 (French). In Mexico, call
(525) 254-3777. In
Puerto Rico or
U.S. Virgin Islands, call 1-809-763- 13 15.
In all other overseas locations, contact
GM International Export Sales in
Canada by calling 1-4 16-644-4 1 12.
For prompt assistance, please have the
following information available to give
the Customer Assistance Representative:
Your name, address, telephone
number
Vehicle Identification Number (This is
available from the vehicle registration
or title, or the plate attached to the left
top of
the instrument panel and visible
through the windshield.)
Dealership name and location
ProCarManuals.com