ignition CHEVROLET CORVETTE 1993 4.G Owner's Manual

Downloaded from www.Manualslib.com manuals search engine Features & Controls
To Start Your LE €nghe (CODE J)
Shift your gear selector to N (Neutral)
and hold the. clutch pedal to the'fioor
while starting the-engine;
Your vehicle
won't start
if the clutch pedal is not all
the way down-that's a safety feature.
1 Don't push the accelerator pedal
before .starting
your engirie. In some
other vehicles you might need to do
this,
but because of your vehicle's
computer systems,
you don't.
2. Turn the ignition key to Start. When
the engine starts, let go of the--key.
The idle speed will go down as your
engine
gets warm.
1. If it doesn't start within three
seconds, push the accelerator pedal
about one-third
of the way down,
while you hold the ignition key in
Start. When the engine starts, let go
of the key and let up on the
accelerator pedal. Wait about
15
seconds between each try to help
avoid draining.
your battery.
I
When starting your engine. in very cold
weather (below
0°F or -18"c), do this:
1. With your foot off the accelerator
pedal, turn the ignition
key to Start
and hold it there. Mer two s.econds,
push the accelerator pedal down just
a little. When thmngine starts, let go
of the key. Use the accelerator pedal
to maintain engine. speed, -if you have-
to, until your engine has runfor a
while.
---

Downloaded from www.Manualslib.com manuals search engine c
Y 2- (Second Gear): Press the clutch
pedal as
you let up on t.he accelerator
pedal and
shift into 2. Then, slowly let
up on the clutch pedal .as you -press the
accelerator pedal.
3,4,!5 and 6 (Third, Fourth, E.i€th and
Sixth Gears): Shift ihto 3,4,5 and 6
the same way you do for 2. Slowly let
up on the clutch pedal as you press the
accelerator
pedal;
To stop
Let up an the acceleraTor pedal and
press the-brake pedal. Just before the
vehicle
stops, press the clutch pedal
:and.the brake pedal, and shift to
N (Neutral).
N (Neutral): Use this position when
you .startor idle your engine.
R (Reverse): To back up, press down
the clutch pedal-and shift into R (Reverse).
.Let up on the clutch pedal slowly while
pressing the, accelerator pedal.
I-f you shift €ram. RARevefse), the -shift lever must be first
placed
in the N (Neutral) position
centered between
2 and 5 prior to
shifting into .R (Reverse).
Your 6-speed
manual transmission has
a
feature that allows you to s-afely.shift
into-R (Reverse) while the vehicle is
rolling (at
less than 5 mph) . You will be
%clred-out” if you try to shift into
R (Reverse) while y0u.r vehicle is
moving faster than
5. rhph.
If you haveturned your ignition off and
wish to park your car iii R (Reverse),
you wlil have to move the shift leyer
quickly to the right, “crashing” through
the high load spring and then into gear.
71

Downloaded from www.Manualslib.com manuals search engine r i 1
1 I-
i
p" i
r"
lnsert the Engine Power Key into the
slot and turn claclnvise to FULL. An
indicat0r"light
will come on when FULL
power performance is operating. To
return to-NORMAL power, turn key
countercloclnvise. The indicator
light
should stop glowing. The key returns to
the center position when released. The
key can be removed when the engine is
in PULL or NORMAL power and only
from the center position.
The
FULL power setting provides
additional
power for highway touring
and off-road sports use as well as
reserve power for passing. Both primary
and secondary fuel intake runners and
injectors can operate when the
FULL
setting is chosen. I
When the ignition is shut off, the engine
reverts
to NORMAL power.
Your ZR-1 is capable of operating at
FULL power when the indicator light is
on and u.nder the following conditions:
The engine coolant and oil
temperatures are greater than 68°F
(200Cc) but less than 3OFF (150°C),
and
-The system voltage is greater than 10
volts, and
There is no SERVICE ENGINE
SOON light indicated on the Driver
Infomation Center. Switching
from the NORMAL to
the
FULL setting and from the FULL to
the NORMAL setting may be done at
engine speeds up to 4,000 rpm.
ZR-1 Toll-Free Number:
If you have any questions or concerns
about your
ZR-1 Special Performance
Coupe, call the following toll-free
telephone number
for ,assistance:
1-800-222-1020
(U.S. only).
75

Downloaded from www.Manualslib.com manuals search engine , ,
Y216i
Parking Brake
To Set the Parking Brake:
Hold the brake pedal down. PuIl the
pdking brake lever up, then move it
back down. This sets your parking
brake-even though the lever is down.
If the ignition is on, the bxake system
warning light will come on.
Y 2132
To Release the Parking Brake:
Hold the brde pedal down. Pull the
parking brake lever up until you can
push in the release button. Hold the
release button
in 'as you move the bt&e
lever ad the way dawn.
IfYoumeonaHill:
See the Indm under Parking 012 Hills.
That section shows how to tum.your
front wheeTs.

Downloaded from www.Manualslib.com manuals search engine Features & Controls
., ,.,.. -
:It can be, dangerous.iu.get: '
.. ..
:out- of .your vehicle'if the: shift
lever is nut fully in P (Park) with
the -parking .brake firmly set.
Your
vehicle can roll,
If you have left the engine. running,
the vehicle can move suddenly. You
.or others could be injured. To be
sure' your vehicle won't move, when
you're on fairly level ground, use
the
steps that follow. If you are
parking on
a hill, also see the Index
under Parking on Hills.
1. Hold the bralre pedal down with your
right foot and set the p-arlting
brake.
2. Move the shift lever into the P (Park)
position
by holding in the button on
the lever and pushing t-he 1ever.all the
way toward the front of the vehicle.
3. Move the ignition key to Lock.
4. Remove the key and take it with YOU.
If you can walk away from your
vehicle with the ignition key in your
hand, your vehicle
is in P (Park).
Leaving Your Vehicle With the
Engine
Running
(AUTOMATIC TRANSMISSION)
If you have-to leave your vehicle with the
engine
running, be sure your vehicle is in
P (Park) and your parking brake is
firmly set be€ore you leave it. After
you've moved the shift lever into the-
P (Park) position, hold the regular brake
pedal
down. Then, see if you can move
the shift lever away from P (.PC&)
without first pushing the button.
If you can, it means that the shift lever
wasn't
fully lockdinto P (Park).

Downloaded from www.Manualslib.com manuals search engine Horn
You can sound the horn by pressing
either horn
symbol on your steering
wheel.
Tilt Steering Wheel
A tilt steering wheel allows you to
adjust the steering wheel before
you
drive, You can also raise it to the.
highest level to give your
legs more.
room when
you exit and enter the
vehicle.
To tilt the wheel, hold the- steering
wheel
and .pull the lever. Move the
steering wheel to a corn€wtable level,
then release the lever to lock: the wheel
in place.
Power Windows
With power windows, switches on the.
driver’s amest control
each of the
windows when the ignition is on. In
addition, the passenger door has a
control switch €or its, own window.
Push each s~tch up
or forward to raise
the power window; push it down or
rearward to lower the window.
The power windows
will remain
.operative
for. fifteen minutes after the
ignitionley is turned to the Off position.
Once eithgr door is opened the
windows will not operate. See the
Index
under DAB (Delayed Accessory Bus).
~. ..
81

Downloaded from www.Manualslib.com manuals search engine Features & Controls
88
Using Cruise. Control on HMs.
How well your cruise control will work
on hills depends upon y~ur speed, load,
and the steepness of. the hills. When
going up steep hills, you may have to
step
on the accelerator pedal to
maintain your
speed. When going
downhill, you may have to brake or
shift to zt lower gear to keep your speed
down. Of course, applying the brake or
dutch pedal takes you out of cruise
control.
Many drivers find this to be too
much trouble and don't use cruise
control
on steep hills.
Ti Get Out of Cruk Control
There are several ways to turn off the
cruise control:
Step lightly on the brake pedal or
push
the clutch pedal, if you have a
manual transmission; OR
Move the cruise switch to OFF; OR
* When the ASR systern.is4 activated, it
will turn off the cruise control. For
information about the ASR system,
see the lndex under Accekatiotz Slip
Regulation (ASR) System.
To Erase Cruise Speed Memory
When you turn off the cruise control or
*the ignition, your cruise control set
speed memory is erased.
f
L
F

Downloaded from www.Manualslib.com manuals search engine ... 4
Acceleration Slip Regulation
(ASR) System
Push this .button to turn off the ASR
system. When the ASR system is off,
the ASR OFF light will illuminate on
the Driver Information Center. Push it
again to turn
the system back on. When
the ASR system is active, ASR ACTIVE
will illuminate on the Driver
Information Center. The ASR system
comes
on automatically each time you
start your Corvette. See the
Index
under Acceleration Slip Regulation
(ASR) System.
Headlights
Rotate the headlight knob to p: to
turn
on:
Parking Lights
Side Marker Lights
Tadlights
To read your odometer and
fuel level
with
the ignition off, turn on your
parking lights.
To Turn the Lights Off: Rotate the
headlight
knob to OFF.
Rotate the headlight knob to -:a- to
turm
on:
Headlights
Parking Lights
Side Marker Lights
Taillights
To Turn the Lights Off: Rotate the
headlight
knob to OFF.
Your digital display will dim sharply at
dusk to remind you to turn on your
headlights.
If you turn the ignition of€ and open the
door when the lights are on, a warning
chime will alert
you to turn off 'the'
lights.

Downloaded from www.Manualslib.com manuals search engine us.
Features & Controls
Operation of Lights
Although your vehicle’s lighting system
(headlamps, parking lamps,
fog lamps,
side marker lamps and taillamps) meets
all applicable federal lighting
requirements, certain states
and
provinces may apply their own lighting
regulations that may require special
attention before
you operate these
lamps. For exampk, some jurisdictions
may require
that you operate your lower
beam lamps with fog lamps at all times,
or that headlamps be turned on
whenever
you must use your windshield
wipers. In addition, most jurisdictions
prohibit driving solely
with parking
lamps, especially at dawn or dusk It is
recommended that you check with your
own state or provincial highway
authority
for applicable lighting
regulations.
?O
Concealed Headlights
The headlights of your vehicle are
concealed behind protective doors. The
doors open when the headlights are
turned
on.
Do not force the doors open or closed.
To open them manually, turn the
manual hob
on the inside of each
headlight assembly countercloclnvise
until the doors are open.
Daytime Running Lights
(CANADA ONLY)
, The Canadian Federal Government has
decided that Daytime Running Lights
(Dm) are a useful feature, in that DRL
can make your vehicle more visible to
pedestrians and other drivers during
daylight hours.
DRL are required on
new vehicles sold in Canada,
Your
DRL work with a light sensor on
tap of the instrument panel. Don’t
1 come
cover
it
up.
Both front turn. signal lightswil
on in daylight when:
The ignition is on
The headlight switch.is &,-and
The parking brake is released.

Downloaded from www.Manualslib.com manuals search engine P
I
P
At dusk, the exterior lights will come on
automatically and both front turn 9ignal
lights
will go out. At dawn, the exterior
lights will
go out and both front turn
signal lights
will come on (if the
headlight switch is
off).
Of course, you may still turn on the
headlights any time you need to.
To idle your vehicle with the DRL off,
set the parking brake while the ignition
is in the Off or Lock position. Then
start the vehicle. The DRL will stay off
until you release the parking brake.
Changer
To change the headlights from low
beam to
high or high to low, pull the
turn signal lever all the
way toward you.
Then release it.
When the
high beams are on, a blue
light
on the instrument panel also will
be
on.
Instrument Panel Intensity
Confro!
During daylight, the brightness of your
instrument cluster lights will be
maintained automatically. But when
your headlights or parking lights are on,
you can brighten or dim your
instrument cluster lights by
sliding the
DIMMER control up or down. Slide
the control all
the way up to turn on the
interim courtesy lights,
reading and
map lights, and cargo area lights. Slide
the control
down to dim the instrument
cluster lights and displays.
To avoid draining.your vehicle's battery,
be sure to turn off all lights when.:. -
leaving your vehicleA