CHEVROLET EXPRESS PASSANGER 2006 1.G Owners Manual

CHEVROLET EXPRESS PASSANGER 2006 1.G Owners Manual EXPRESS PASSANGER 2006 1.G CHEVROLET CHEVROLET https://www.carmanualsonline.info/img/24/8179/w960_8179-0.png CHEVROLET EXPRESS PASSANGER 2006 1.G Owners Manual
Trending: clock, service indicator, suspension, battery capacity, air suspension, oil level, fuel pressure

Page 301 of 406

CHEVROLET EXPRESS PASSANGER 2006 1.G Owners Manual How to Check Lubricant
To get an accurate reading, the vehicle should be on a
level surface.
If the level is below the
bottom of the filler plug
hole, you may need to add
some lubricant.
When the dif

Page 302 of 406

CHEVROLET EXPRESS PASSANGER 2006 1.G Owners Manual Federal law prohibits the following acts or the causing
thereof:
1. The removal or rendering inoperative by any
person, other than for purposes of maintenance,
repair or replacement, of any device or

Page 303 of 406

CHEVROLET EXPRESS PASSANGER 2006 1.G Owners Manual Halogen Bulbs
{CAUTION:
Halogen bulbs have pressurized gas inside
and can burst if you drop or scratch the bulb.
You or others could be injured. Be sure to read
and follow the instructions on the bulb

Page 304 of 406

CHEVROLET EXPRESS PASSANGER 2006 1.G Owners Manual 5. Lift the outboard side of the headlamp to release
the outboard tab from the radiator support.
6. Lower the headlamp to allow the vertical adjustor to
clear the tie bar.
7. Turn the headlamp forward

Page 305 of 406

CHEVROLET EXPRESS PASSANGER 2006 1.G Owners Manual Front Turn Signal, Sidemarker and
Parking Lamps
To replace the front turn signal, sidemarker and/or
parking lamp bulb(s), do the following:
1. Use a small tool to unlatch the outboard clip on
the lamp

Page 306 of 406

CHEVROLET EXPRESS PASSANGER 2006 1.G Owners Manual Center High-Mounted Stoplamp
(CHMSL)
The center high-mounted stoplamp (CHMSL) is located
above the rear doors at the center of the vehicle.
To replace a bulb, do the following:
1. Remove the two screw

Page 307 of 406

CHEVROLET EXPRESS PASSANGER 2006 1.G Owners Manual 6. Remove the bulb socket by squeezing the tab on
the side of the socket while turning it
counterclockwise.
7. Turn the bulb counterclockwise to remove it.
8. Install a new bulb.
9. Reverse the steps

Page 308 of 406

CHEVROLET EXPRESS PASSANGER 2006 1.G Owners Manual Windshield Wiper Blade
Replacement
Windshield wiper blades should be inspected for wear
and cracking. SeeScheduled Maintenance (Gasoline
Engine) on page 6-4for more information on wiper blade
inspecti

Page 309 of 406

CHEVROLET EXPRESS PASSANGER 2006 1.G Owners Manual 5. Make sure that the notches are locked by the
bottom claws. Make sure that all other claws
are properly locked on both sides of the insert slot.
6. Put the blade assembly pivot in the wiper arm
hook

Page 310 of 406

CHEVROLET EXPRESS PASSANGER 2006 1.G Owners Manual Tire Sidewall Labeling
Useful information about a tire is molded into the
sidewall. The following illustrations are examples of a
typical P-Metric and a LT-Metric tire sidewall.
(A) Tire Size:The tire
Trending: tires, horn, oil capacities, ground clearance, warning light, tire type, oil temperature