emergency towing CHEVROLET MONTE CARLO 2004 Owners Manual

Radiator Pressure Cap
Notice:The radiator cap on your vehicle is a
pressure-type cap and must be tightly installed to
prevent coolant loss and possible engine damage
from overheating. Be sure the arrows on the cap
line up with the overow tube on the radiator
ller neck.
The radiator pressure cap is located in the front of the
engine compartment on the passenger’s side, near
the diagonal cross brace. SeeEngine Compartment
Overview on page 5-12for more information on location.
Engine Overheating
You will nd a coolant temperature gage and a warning
message about a hot engine on your instrument
panel cluster. SeeEngine Coolant Temperature Gage
on page 3-38andHot Coolant Temperature Warning
Message on page 3-45.
Overheated Engine Protection
Operating Mode
This emergency operating mode allows your vehicle to
be driven to a safe place in an emergency situation.
If an overheated engine condition exists, an overheat
protection mode which alternates ring groups of
cylinders helps prevent engine damage. In this mode,
you will notice a signicant loss in power and engine
performance. The low coolant light may come on
and the temperature gage will indicate an overheat
condition exists. Driving extended miles (km) and/or
towing a trailer in the overheat protection mode should
be avoided.
Notice:After driving in the overheated engine
protection operating mode, to avoid engine damage,
allow the engine to cool before attempting any repair.
The engine oil will be severely degraded. Repair the
cause of coolant loss, change the oil and reset the
oil life system. SeeEngine Oil on page 5-18.
5-34

Driving Through Deep Standing Water...............4-20
Driving Through Flowing Water.........................4-20
Driving with a Trailer.......................................4-42
Dual Climate Control System............................3-21
E
Easy Entry Seat............................................... 1-7
Electrical System
Add-On Equipment.....................................5-103
Fuses and Circuit Breakers.........................5-104
Headlamp Wiring.......................................5-103
Power Windows and Other Power Options....5-103
Windshield Wiper Fuses.............................5-103
Emergency Trunk Release Handle.....................2-12
Emissions Inspection and
Maintenance Programs.................................3-41
Engine
Air Cleaner/Filter.........................................5-26
Battery.......................................................5-53
Change Oil Message...................................3-47
Check and Service Engine Soon Light............3-39
Coolant......................................................5-31
Coolant Heater............................................2-20
Coolant Temperature Gage...........................3-38
Drive Belt Routing.......................................6-14
Engine Compartment Overview......................5-12Engine (cont.)
Exhaust.....................................................2-29
Low Oil Level Message................................3-46
Oil .............................................................5-18
Overheating................................................5-34
Starting......................................................2-18
Supercharger Oil.........................................5-24
Engine Cooling When Trailer Towing..................4-45
Engine Oil Additives........................................5-22
Entry Lighting.................................................3-17
Erasing HomeLink
®Buttons..............................2-39
Event Data Records (EDR)..............................7-10
EXIT (Exit Feature
Customization Mode)....................................2-50
Express-Down Window....................................2-14
Extender, Safety Belt.......................................1-28
Exterior Lamps...............................................3-14
F
Filter
Engine Air Cleaner......................................5-26
Finding a Program Type (PTY)
Station (RDS and XM™)..............3-60, 3-71, 3-82
Finding a Station............................3-58, 3-69, 3-80
Finish Care....................................................5-98
Finish Damage...............................................5-99
5