hood release CHEVROLET S10 1994 2.G Owners Manual

Downloaded from www.Manualslib.com manuals search engine n ;are s ler symbols you may see:
t
m
Fuse Hood Release Lighter Horn

Downloaded from www.Manualslib.com manuals search engine Be careful not to spill gasoline. Clean gasoline from painted surfaces as
soon as possible. See “Cleaning the Outside of Your Vehicle” in the Index.
When
you put the cap back on, turn it to the right until you hear a clicking
noise.
NOTICE:
If you need a new cap, be sure to get the right type. Your dea\
ler
can get one for you. If you get the wrong type, it may not fit or
have proper venting, and your fuel tank and emissions system
might be damaged.
Checking Things Under fhe Hood
Hood Release
To open the hood, first
pull the handle inside
the vehicle on the
, lower left side of the
~ instrument panel.
6-6

Downloaded from www.Manualslib.com manuals search engine Then go to the front of
the vehicle and release
the secondary hood
release.
Lift the hood, release the hood prop from its
retainer and put the
hood prop into the slot
in the hood. You will
have an underhood
light that
comes on
when you lift the
hood.
Before closing the
hood, be sure
all the
filler caps are
on
properly. Then lift the
hood to relieve
pressure on the hood
Prop.
6-7

Downloaded from www.Manualslib.com manuals search engine Steering Column Lock Operation - While parked, try to turn the key to
LOCK in each gear shift position.
With an automatic transmission, the key should turn to LOCK only
0 With manual shift, the key should turn to LOCK only wnen you’re in
On vehicles with a key release lever, try to turn the key to
LOCK without
pressing the lever. The key should turn to
LOCK only with the key lever
depressed.
On
all vehicles, the key should come out only in LOCK.
when the gear shift is in “P’ (Park).
“R’ (Reverse).
Parking ‘Brake and Transmission “P’ (Park) Mechanism Operation -
Park on a fairly steep hill, with the vehicle facing downhill. Keeping your
foot on the regular brake, set the manual parking brake.
0
0 To check the parking brake: With the engine running and the
transmission
in “N” (Neutral), slowly remove foot pressure from the
regular brake pedal.
Do this until the vehicle is held by the parking
brake only.
To check the
“P’ (Park) mechanism’s holding ability: Apply the regular
brake and shift to
“P’ (Park). Release the manual parking brake, then
slowly release the regular brake.
Lap and Shoulder Belts Condition and Operation - Inspect belt system,
including: webbjng, buckles, latch plates, retractors, guide loops and
anchors. Have a belt assembly replaced
if the webbing has been cut or
otherwise damaged.
Body Lubrication Service - Lubricate all body door hinges including the
tailgate and tailgate handle pivot points. Lubricate the body hood, fuel door
and rear compartment hinges, latches and locks including interio\
r glove box
and console doors, and any moving seat hardware. Lubricate the \
hood safety
lever pivot and prop rod pivot.
More frequent lubrication may be required
when exposed to a corrosive environment.
7-11

Downloaded from www.Manualslib.com manuals search engine USAGE FLULD/LUIBRICANT
Column Shift, Transfer Chassis lubricant meeting requirements of
Case Shift Lever, Propeller NLGI Grade 2, Catagory LB or GC-LB
Shaft
Slip Splines and (GM Part No. 1052497).
Universal Joints.
Clutch Linkage. Pushrod to Chassis lubricant meeting requirements of
clutch fork joint. NLGI Grade 2, Catagory LB
or GC-LB
(GM Part No. 1052497).
Hood Latch Assembly:
a, Pivots and spring anchor
b. Release Pawl
Front Wheel Bearings a. Engine oil (GM Part No. 1050109).
b. Chassis lubricant meeting requirements of
GM-6031-M (GM Part No. 1052497).
Wheel bearing lubricant meeting
requirements
of NLG Grade 2, Catagory GC
or GC-LB (GM Part No. 1051344).
Constant Velocity
Universal Joint
Automatic Transmission Shift Linkage, Floor Shift
Linkage, Hood and Door
Hinges, Body Door Hinge
Pins, Folding Seat, Fuel Door Hinge
Key Lock Cylinders
Chassis Lubrication
Windshield Washer Solvent
Weatherstrip Chassis lubricant meeting requirements
of
NLG Grade 2, Catagory LB or
GC-LB (GM
Part No. 1052497).
Engine oil (GM Part No. 1050109).
GM Multi-Purpose Lubricant (GM Part No. 12345 120) or a synthetic light weight engine
oil
(SAE 5W-30).
Chassis lubricant meeting requirements of
NLG Grade
2, Catagory LB or GC-LB (GM
Part No. 1052497).
GM Optikleen
TM washer solvent (GM Part
No. 1051515) or equivalent.
Silicone grease (GM Part No. 1052863) or
equivalent.
Tailgate Handle Pivot Multi-purpose lubricant meeting
Points, Hinges, Latch Bolt, requirements of GM Part No. 9985164.
and Linkage
Gas Line
Weather Strips Gas Line De-Icer (GM Part No. 10515 16).
Spray-A-Squeek (GM
Part
No. 1052277).

Downloaded from www.Manualslib.com manuals search engine Hood Release
Lever
See Page 6-6.
Remote Oil Filfer
See Page
6-1 3.
Windshield -
Washer Fluid
See Page 6-28.
Power Steering '
Reservoir
See Page 6-26.
,Battery
The Delco
Freedom battery
needs no water.
See Page 6-32. I 4
,Cooling Sysfem
Check and add
coolant
only at
the coolant
recovery tank.
See Page 6-23.
I fit-
Engine Oil
\see Page 6-9m Transmission
Fluid
Automatic:
See Page 6-15.
Manual:
See Page 6-18.
/ Clutch Fluid
Reservoir
See Page 6-20.
I
I c
/
,Fuel
Capacity 20 U.S.
Gal.
(7.6L). Use
unleaded gas
only,
87 octane
or higher.
See Page 6-3.
Brake Fluid.
Reservoir
See Page 6-29.
Cold TiFe
Pressure
See Tire-Loading
sticker
on the
inside
of the
rear edge
of
the driver's door lock pillar.
See Page 6-45.
Spare Tire /
Pressure
See Page 6-45.
7- 17