radiator CHEVROLET S10 1997 2.G User Guide

Downloaded from www.Manualslib.com manuals search engine Thermostat
NOTICE:
Your radiator cap is a 15 psi (105 kPa)
pressure-type cap and must be tightly installed to
prevent coolant loss and possible engine damage
from overheating. Be sure the arrows on the cap
line
up with the overflow tub.e on the radiator
filler neck.
Engine coolant temperature is controlled by a thermostat
in the engine
coolant sys-tem. The. thermostat stops the
flow of coolant through the radiator until the coolant
reaches a preset temperature.
Power Steering Fluid
6-28

Downloaded from www.Manualslib.com manuals search engine Adding Washer Fluid
dpen the cap labeled WASHER FLUID ONLY with the
washer synibol on it. Add washer fluid until the tank
is full.
.NOTIICE-:
a
a
e
When using concentrated washer fluid,
follow the manufacturer’s instructions .for
adding water.
Don’t
mix water with rea-dy-to-use washer
fluid. Water can cause- the soIution
to freeze.
.and damage your washer
fluid. tank .and
other parts of the washer system. Also,
water.doe-sn’t clean as well’aswasher fluid.
Fill yourwasher fluid tank only
thre-elquarters full-when it’s very
cold. This
alIows for expansion if freezing occurs,
which codd damage: the tank if it is
completely full.
Don’t use radiator :antifreeze
in your
windshield washer. It can damage your
washer system and paint.
6-30

Downloaded from www.Manualslib.com manuals search engine Composite Headlamps
1. Open. the hood.
2. Remove the black
protective cap.s
from the
removal pins at the
top
of the radiator support.
Use
a hex socket to
unscrew
the pins.
3. Pull the headlamp lens
' assembly out. (Some
vehicles may have
side-by-side bulbs.)
4. Unplug the electrical connector.
6-37

Downloaded from www.Manualslib.com manuals search engine F.ront Sidemarker Lamps.
1.
2.
3.
4.
5.
6 ,.
7.
8.
9.
Remove the le-ns retaining screws.
Remove the sidenmker lens from the .radiator grille.
Turn the bulb and socket one-quarter of a-turn
counterclockwise,
Remove thebulb and socket fro'm the lens.
Install. the new:bulb and socket 10 the
sidemarker lens.
Rotate
the bulb and-socket one-quarter of-a
.turn ciockwise.
Install the sidemarker lens to the radiator grille.
Insert the tabs into.the locators-
Tnstall and tighten the screws.
Center High-Mounted- Stoplamp
1. Remove the lais i-.etairiing scre~s;
.2. Remove the lens.

Downloaded from www.Manualslib.com manuals search engine 100,000 Miles (166 000 km) (Continued)
If you do no.t use your vehicle under any of these
conditions, the
fZuid andfilter do not require changing.
Manual ,transrnis.sion fluid doesn’t
require change.
Inspect Positive Crankcase Ventilation
(PCV) valve.
An Emission Control Service.
I DATE ACTUAL MILEAGE SERVICED BY:
150,000 Miles (240 000 h)
0 Drain, flush and refill cooling system
(or every 60 months since last service,
whichever occurs first). See “Engine
Coolant” in the Index
€or what to we.
Inspect hoses. Clean radiator, c.ondenser,
pressure cap and neck. Pressure test cooling
system and
pres.sure cap-.
An Emission Control Service.
DATE ACTUAL MILEAGE SERVICED BY:

Downloaded from www.Manualslib.com manuals search engine Long Tripmighway Maintenan t Schedull-
- Uses such as found -in taxi, police or
If you do not use your vehicle unde.r any of these
coiiditions, th.efluid andfilter do not require changing.
Manual transmission fluid does.n’t
require change.
a 1ns.pest Positive Crankcase Ventilation
(Pcv) valve.
A-n Emission Control Service.
delivery service.
1-
150,000 Miles (240 000 km)
0 Drain, flmh .and refill cooling system
(or every 60 months since last service.,
whichever occurs .first).
See “Engine
@oolant” in the Index ‘for what to use.
Inspect hoses. Clean radiator, condenser,
pressure. cap. and neck. Pressure test the
cooling
system and pres.sure cap.
An Emission Con‘tvul Service.