light CHEVROLET TRACKER 1996 User Guide

Parking Brake
To set the parking brake, hold the brake pedal down and
pull up
on the parking brake lever. If the ignition is on,
the brake system warning light will come on.
To release the parking brake, hold the brake pedal down.
Pull the parking brake lever up until
you can push in the
release button. Hold the release button in as you move
the lever all the way down.
2-20
ProCarManuals.com

Horn
The lever on the left side of the steering column
includes
your:
Turn Signal and Lane Change Indicator
Headlamp High/Low Beam Changer and Passing Signal
Lighting Operation
Turn Signal and Lane Change Indicator
The turn signal has two upward (for right) and two
downward (for left) positions. These positions allow
you to signal a turn
or a lane change.
To signal a tum, move the lever all the way up or down.
When the turn is finished, the lever will return automatically.
To sound the horn, press one of the horn symbols on
your steering wheel.
?ttm Signal/Multifunction Lever
An &ow on the instrument
panel will
flash in the direction
of the turn or lane change.
To signal a lane change, just
raise or lower the lever until
the arrow starts to flash.
Hold it there until you
complete your lane change.
The lever will return
by
itself when you release it.
As you signal a turn or a lane change, if the mows don’t
flash but just stay on, a signal bulb may be burned out
and other drivers won’t see your turn signal.
If a bulb is burned out, replace it to help avoid an
accident. If the arrows don’t go on at all when you
signal a turn, check the fuse (see “Fuses and Circuit
Breakers” in
the Index) and for burned-out bulbs.
2-28
ProCarManuals.com

Lamps Control
Turn the outside part of the lever to control the lamps.
There are three positions for the lamp switch.
OFF: All lamps are off.
-300: : The parking lamps, taillamps, license plate
lamp and
the instrument panel lights come on. The
headlamps are off.
-:g- : The headlamps and all other operating lamps
come on.
Lamps On Reminder
If you turn the ignition off, remove the key, open the
door and leave the lamps
on, a chime will remind you to
turn off your lamps.
Headlamp High/Low Beam Changer
First, you must have the headlamps on. For high beams,
push the turn signal lever away
from you.
When the high beams are
on, a light on the instrument
panel also
will be on. It will
go off when you switch to
low beam.
To switch back to low beams, pull the lever toward you.
2-29
ProCarManuals.com

Flash-to-Pass
With the lever in the low-beam position, pull the lever
towad you to momentarily switch to high beam (to
signal that you are going to pass). When you release the
lever, the headlamps will return
to low-beam operation.
Windshield WipedWasher Lever
The lever on the right side of the steering column
controls the windshield wipers
and washers. Move the wiper switch
to the position
you want:
OFF: The wipers are off.
INT Intermittent wiper operation. In light rain or snow,
you might want to use this position rather than
continuous wiping.
LO: The wipers will run continuously at low speed.
HI: The wipers will run continuously at high speed.
For a single wiping cycle, pull the lever toward
you.
Hold it there until the wipers start, then let go. The
wipers will stop after one cycle. If you want more
cycles, hold the lever longer.
Be sure
to clear ice and snow from the wiper blades
before
using them. If they’re frozen to the windshield,
carefully loosen or thaw them.
If your blades do become
damaged, get new blades
or blade inserts.
Heavy snow or ice
can overload your wipers. A circuit
breaker will stop them until the motor cools. Clear away
snow or ice
to prevent an overload.
2-30
ProCarManuals.com

Setting Cruise Control 2. Get up to the speed you want.
A CAUTION: I
If you leave your cruise control switch on when
you’re not using cruise, you might hit a button and
go into cruise when you don’t want
to. You could
be startled and even lose control. Keep the cruise
control switch
OFF until you want to use it.
1. Press the
CRUISE Cm’L
switch on the
instrument panel
to turn the system
on. The indicator
light
on the switch
will come on.
3. Once you’re going 25 mph (40 km/h) or more, turn
the lever to COAST/SET and release. Your cruise
will set.
4. Take your foot off the accelerator pedal.
2-33
ProCarManuals.com

Using Cruise Control on Hills
How well your cruise control will work on hills depends
upon your speed, load and the steepness
of the hills.
When going up steep hills, you may have to step on the
accelerator pedal to maintain your speed. When going
downhill, you may have to brake or shift to a lower gear
to keep your speed down. Of course, applying the brake
takes you out of cruise control. Many drivers find this to
be too much trouble and don't use cruise control on
steep hills.
Getting Out of Cruise Control
There are three ways to turn off cruise control:
Step lightly on the brake pedal, or push the clutch
pedal if you have a manual transmission.
Push in the CANCEL button on the end of the cruise
control lever.
0 Press OFF on the cruise control switch.
Erasing Speed Memory
When you turn off the cruise control or the ignition,
your cruise control set speed memory is erased.
Lamps
Daytime Running Lamps
Daytime Running Laps (DRL) can make it easier for
others to see the front of your vehicle during the day.
DRL can be helpful in many different driving
conditions, but they can be especially helpful
in the
short periods after dawn and before sunset.
The DRL system will make your low-beam headlamps
come on at a reduced brightness when:
0 The ignition is on,
0 The headlamp switch is off, and
The parking brake is released.
When you turn on the headlamp switch, your DRL will
go out, and your headlamps will come on.
The other lamps that come on
with your headlamps will
also come on.
When you turn off the headlamp switch, the regular
lamps will go
off, and your low-beam headlamps come
on at the reduced brightness of DRL.
To idle your vehicle with the DRL off, set the parking brake.
The
DRL will stay off until you release the parking brake.
As with any vehicle, you should turn on the regular
headlamp system when you need
it.
2-35
ProCarManuals.com

Interior Lamps
Instrument Panel Brightness Control
This knob controls the
brightness
of your
instrument panel lights.
Turn the knob to the right to
brighten the lights
or to the
left to dim them.
Dome Lamp
The dome lamp has a
three-position switch.
1: This position is to the left when sitting in the driver’s
seat. The dome lamp
turns on and stays on whether or
not a door is open.
2: This is the center position. The lamp comes on when
a door is opened.
3: This position is to the right when sitting in the driver’s
seat. The lamp stays off even when a door is open.
2-36
ProCarManuals.com

Coinholder and Bin
Your console has a coinholder and a small storage bin.
Cupholder
Two cupholders are on the center console next to the
parking brake lever.
Ashtrays and Lighter
To use the lighter, push the lighter in all the way and let
go. When it’s ready, it will pop back by itself.
NOTICE:
Don’t hold a cigarette lighter in with your hand
while
it is heating. If you do, it won’t be able to
back away from the heating element when it’s
ready. That can make
it overheat, damaging the
lighter and the heating element.
2-40
ProCarManuals.com

A. Defroster
B. Rear Defogger (Option)
C. Turn Signal/Multifunction Lever
D. Power Mirror Control (Option)
E. Air Vent
E Instrument Panel Brightness Control
G. Hazard Switch
H. Fuse Block
I. Instrument Cluster
J. Ignition Switch
K. Horn
L. Windshield Wipermasher Lever
M. Cruise Control ON/OFF Button (Option)
N. Rear Window Wiper Button (Option)
0. Rear Window Washer Button (Option)
P. Comfort Controls
Q. Cigarette Lighter
R. Shift Lever
S. Parking Brake Lever
T. Coinholder/Bin
U. Audio System
V. Transfer Case Shift Lever
W. Ashtray
X. Glove Box
2-57
ProCarManuals.com

Warning Lights, Gages and Indicators
This part describes the warning lights and gages that
may be on your vehicle. The pictures will help you
locate them.
Warning lights and gages can signal that something is
wrong before it becomes serious enough to cause an
expensive repair or replacement. Paying attention to
your warning lights and gages could also save you or
others from injury.
Warning lights come on when there may be or is a
problem with one of your vehicle’s functions. As you
will see in the details on the next few pages, some
warning lights come on briefly when
you start the
engine just
to let you know they’re working. If you are
familiar with this section, you should not be alarmed
when this happens.
Gages can indicate when there may be or is a problem
with
one of your vehicle’s functions. Often gages and
warning lights work together to let you know when
there’s
a problem with your vehicle. When
one of the warning lights comes
on and stays on
when you
are driving, or when one of the gages shows
there may be a problem, check the section that tells YOU
what to do about it. Please follow this manual’s advice.
Waiting to
do repairs can be costly -- and even
dangerous.
So please get to know your warning lights
and gages. They’re a big help.
Safety Belt Reminder Light
When the key is turned to
ON or STAFtT, a light will
come on for about eight
seconds to remind people to
fasten their safety belts.
Unless the driver’s safety
belt is already buckled, a
chime will also sound.
2-60
ProCarManuals.com