tow CHEVROLET TRACKER 1996 Workshop Manual

Sidemarker Lamps
To replace the sidemarker bulb:
1. Push the sidemarker housing toward the back of the
vehicle to release the clip and pull out the front edge.
The housing should pull away from the vehicle.
2. Turn the socket counterclockwise and pull it out of
the housing.
3. Pull the bulb out of the socket.
4. Reverse the steps with a new bulb.
6-37
ProCarManuals.com

Rear Sidemarker Lamps
To replace the rear sidemarker bulb:
Rear Combination Lamps
1.
2.
3.
4.
5.
Remove the screw (hardtop only).
Pull the sidemarker lamp housing out at the
back edge.
Turn the socket toward the rear of the vehicle and
pull it out.
Pull the bulb out
of the socket.
Reverse the steps with a new bulb.
To remove the rear combination bulbs:
1. Remove the two screws from the combination lamps.
6-38
ProCarManuals.com

After the tires have been rotated, adjust the front and rear
inflation pressures as shown on the Tire-Loading
Information label. Make certain that all wheel nuts are
properly tightened. See “Wheel Nut Torque”
in the Index.
Rust or dirt on a wheel, or on the parts to which
it is fastened, can make wheel nuts become loose
after a time. The wheel could come off and cause
an accident. When
you change a wheel, remove
any rust or dirt from places where the wheel
attaches to the vehicle. In an emergency, you can
use
a cloth or a paper towel to do this; but be
sure
to use a scraper or wire brush later, if you
need to, to get all the rust or dirt off. (See
“Changing
a Flat Tire” in the Index.) When
It’s Time
for New Tires
One way to tell when it’s
time for new tires
is to
check the treadwear
indicators, which will
appear when your tires have
only
1/16 inch (1.6 mm) or
less of tread remaining.
You need a new tire if any of the following statements
are true:
0 You can see the indicators at three or more places
You can see cord or fabric showing through the
tire’s rubber.
0 The tread or sidewall is cracked, cut or snagged deep
enough to show cord or fabric.
0 The tire has a bump, bulge or split.
The tire has a puncture, cut or other damage that
around the tire.
can’t be repaired well because of the size or location
of the damage.
6-43
ProCarManuals.com

Using Foam-Type Cleaner on Fabric
1. Vacuum and brush the area to remove any
loose dirt.
2. Always clean a whole trim panel or section. Mask
3. Mix Multi-Purpose Powdered Cleaner following
surrounding trim along stitch
or welt lines.
the directions on the container label.
4. Use suds only and apply with a clean sponge.
5. Don’t saturate the material.
6. Don’t rub it roughly.
7. As soon as you’ve cleaned the section, use a sponge
8. Rinse the section with a clean, wet sponge.
9. Wipe off what’s left with a slightly damp paper
to remove the suds.
towel or cloth.
10. Then dry it immediately with a blow dryer.
11. Wipe with a clean cloth.
Using Solvent-Type Cleaner on Fabric
First, see if you have to use solvent-type cleaner at all.
Some spots and stains will clean
off better with just
water and mild soap.
If you need to use a solvent:
Gently scrape excess soil from the trim material with
a clean, dull knife or scraper. Use very little cleaner,
light pressure and clean cloths (preferably
cheesecloth). Cleaning should start at the outside of
the stain, “feathering” toward the center. Keep
changing to a clean section of the cloth.
When you clean a stain from fabric, immediately
dry the area with a blow dryer to help prevent
a
cleaning ring.
Fabric Protection
Your Geo has upholstery that has been treated with
Scotchgard” Fabric Protector, a 3M product.
It protects
fabrics by repelling oil and water, which are the carriers
of most stains. Even with this protection, you still need
to clean your upholstery often to keep it looking new.
Further information on cleaning
is available by calling
1-800-433-3296 (in Minnesota, 1-800-642-6167).
6-49
ProCarManuals.com

Clean the blade by wiping vigorously with a cloth
soaked
in full-strength windshield washer solvent. Then
rinse the blade with water.
Wiper blades should be checked on a regular basis and
replaced when worn.
Weatherstrips
Silicone grease on weatherstrips will make them last
longer, seal better, and not stick or squeak. Apply
silicone grease with a clean cloth. at least every six
months. During very cold, damp weather more frequent
application
may be required. (See “Recommended
Fluids and Lubricants” in the Index.)
Cleaning the Outside of Your Geo
The paint finish on your vehicle provides beauty, depth
of color, gloss retention and durability.
Washing Your Vehicle
The best way to preserve your vehicle’s finish is to keep
it clean by washing it often with lukewarm or cold water.
Don’t wash your vehicle in the direct rays
of the sun.
Don’t use strong soaps or chemical detergents. Use
liquid
hand, dish or car washing (mild detergent) soaps.
Don’t use cleaning agents that
are petroleum based, or that
contain acid or abrasives. All cleaning agents
should be flushed promptly and not allowed to dry on
the surface, or they could stain. Dry the
finish with a
soft, clean chamois or a 100% cotton towel to avoid
surface scratches and water spotting.
High pressure vehicle washes may cause water to enter
your vehicle.
Finish Care
Occasional waxing or mild polishing of your Geo by
hand may be necessary to remove residue from the paint
finish. You can get GM-approved cleaning products
from your dealer. (See “Appearance Care and Materials”
in the Index.)
Your Geo has a “basecoat/clearcoat” paint fish.
The clearcoat gives more depth and gloss to the colored
basecoat. Always use waxes and polishes that are
non-abrasive and made for a basecoat/clearcoat paint finish.
NOTICE:
Machine compounding or aggressive polishing on
a basecoatklearcoat paint finish
may dull the
finish or leave swirl
marks.
6-52
ProCarManuals.com

Don’t put any labels, stickers or tape on windows.
It’s
hard to remove adhesives left on the window
when such items are removed.
If a sticker or label
must
be removed, remove any adhesive left on the
window while the adhesive
is still soft and sticky.
Press on
a new sticker or piece of tape and then lift it
off again; keep doing this until all the adhesive lifts
off with the sticker or tape.
Aluminum Wheels (If So Equipped)
Keep your wheels clean using a soft clean cloth with
mild soap and water. Rinse with clean water. After
rinsing thoroughly, dry with a soft clean towel. A wax
may then be applied.
The surface
of these wheels is similar to the painted
surface
of your vehicle. Don’t use strong soaps,
chemicals, abrasive polishes, abrasive cleaners or
abrasive cleaning brushes on them because
you could
damage the surface.
Don’t take your vehicle through
an automatic vehicle
wash
that has silicon carbide tire cleaning brushes. These
brushes
can also damage the surface of these wheels.
Tires
To clean your tires, use a stiff brush with a tire cleaner.
I NOTICE:
’ When applying a tire dressing always take care to
wipe off any overspray or splash from all painted
surfaces on the body or wheels
of the vehicle.
Petroleum-based products may damage the paint
finish.
Sheet Metal Damage
If your vehicle is damaged and requires sheet metal
repair or replacement, make sure the body repair shop
applies anti-corrosion material to the
parts repaired or
replaced to restore corrosion protection.
6-54
ProCarManuals.com

Maintenance Schedule
I Short TriplCity Definition
Follow the Short. Trip/City Maintenance Schedule if any
one of these conditions is true for your vehicle:
Most trips are less than 5 to 10 miles (8 to 16 km).
This is particularly important when outside
temperatures are below freezing.
Most trips include extensive idling (such as frequent
driving in stop-and-go traffic).
your vehicle.
You frequently tow a trailer or use a carrier on top of
If the vehicle is used for delivery service, police, taxi
or other commercial application.
One of the reasons you should follow this schedule if ,
you operate your vehicle under any of these conditions
is that these conditions cause engine oil to break
down sooner.
Short TriplCity Intervals
Every 3,000 Miles (5 000 km): Engine Oil and Filter
Change
(or 3 months, whichever occurs first).
Free-Wheeling
Hubs Inspection (if equipped)
(or
3 months, whichever occurs first).
Every 6,000 Miles (10 000 km): Tire Rotation.
Every 15,000 Miles (25 000 km): Air Cleaner Filter
Inspection, if driving in dusty conditions. Front
Wheel Bearing Repack (or at each brake relining,
whichever occurs first). Manual Transmission Fluid
Change
(or every 15 months, whichever occurs first).
Engine
Idle Speed Check. Valve Lash (Clearance),
Adjustment. Propeller Shafts
and U-Joints Inspection
(or every
15 months, whichever occurs first).
Every 30,000 Miles (50 000 km): Air Cleaner Filter
Replacement. Spark Plug Replacement. Engine
Accessory Drive Belt Inspection (or every
24 months,
whichever occurs
first). C.ooling System Service
(or every 30 months, whichever occurs first). Fuel
Filter Replacement (or every
30 months, whichever
occurs
first).
7-4
ProCarManuals.com

I Short Trip/City Maintenance Schedule I
100,000 Miles (166 000 km)
Change automatic transmission fluid and
filter
if the vehicle is mainly driven under
one
or more of these conditions:
- In heavy city traffic where the outside
temperature regularly reaches
90 OF
(32" C) or higher.
- In hilly or mountainous terrain.
- When doing frequent trailer towing.
- Uses such as found in taxi, police or
If you do not use your vehicle under any of these
conditions, the fluid andfilter do not require changing.
delivery service.
0 Replace Po sitive Cranl ltcase Ventilation
(PCV) valve.
Replace any worn, plugged or
collapsed hoses.
An Emission Control Service.
0 Inspect Exhaust Gas Recirculation (EGR)
system.
An Emission Control Service.
0 Inspect fuel injector.
An Emission Control Service.
0 Replace evaporative emissions canister.
An Emission Control Service.
I DATE ACTUAL MILEAGE SERVICED BY:
7-31
ProCarManuals.com

i Long TriplHighway Maintenance Schedule
50,000 Miles (83 000 km)
0 Change automatic transmission fluid and
filter
if the vehicle is mainly driven under
one or more
of these conditions:
- In heavy city traffic where the outside
temperature regularly reaches
90 OF
(32°C) or higher.
- In hilly or mountainous terrain.
- When doing frequent trailer towing.
- Uses such as found in taxi, police or
delivery service.
If you do not use your vehicle under any of these
conditions, thefluid
andfilter do not require changing.
0 Replace Positive Crankcase Ventilation
(PCV) valve. Replace any worn, plugged or
collapsed hoses. An Emission Control Service.
7-38
ProCarManuals.com

r Long Trip/Highway Maintenance Schedule
100,000 Miles (1 66 000 km)
0 Change automatic, transmission fluid and
filter if the vehicle is mainly driven under
one or more of these conditions:
- In heavy city traffic where the outside
temperature regularly reaches
90 OF
(32 O C) or higher.
- In hilly or mountainous terrain.
- When doing frequent trailer towing.
- Uses such as found in taxi, police or
delivery service.
If you do not use your vehicle under any of these
conditions,
the fluid andfilter do not require changing.
0 Replace Positive Crankcase Ventilation
(PCV) valve. Replace any worn, plugged or
collapsed hoses.
An Emission Control Service.
0 Inspect Exhaust Gas Recirculation (EGR)
17 Inspect fuel injector.
system. An Emission Control Service.
An Emission Control Service.
0 Replace evaporative emissions canister.
An Emissitin Control Service.
DATE SERVICED BY: ACTUAL MILEAGE
7-46
ProCarManuals.com