horn CHEVROLET VOLT 2012 1.G User Guide

Black plate (51,1)Chevrolet Volt Owner Manual - 2012
Driving and Operating 9-51
6. Place the charge cord, facedown, into the storage
compartment with the front
edge (F) of the charge cord
body under the clips (G) located
in the front of the storage
compartment. The vehicle
plug (B) should be on the right
side of the charge cord.
7. Push the charge cord handle down until it locks into the
handle clip at the rear of the
storage compartment.Delayed Charging
Override
To temporarily override a delayed
charge event, unplug the charge
cord from the charge port and then
plug it back in within five seconds.
A single horn chirp will sound and
charging will begin immediately.
To cancel a temporary override,
unplug the charge cord, wait for
10 seconds, and then plug the
charge cord back in. A double horn
chirp will sound and charging will be
delayed.
See “Programmable Charging” in
Charging on page 5‑32 for
advanced charge scheduling
options.

Black plate (53,1)Chevrolet Volt Owner Manual - 2012
Driving and Operating 9-53
Charging StatusIndicator Sound Action/Reason
Solid Green One horn chirp Charging has begun.
Long Flashing Green Two horn chirps Charging is delayed by Programmable
Charging or, if vehicle is equipped
accordingly, by a total utility interruption via
OnStar. Charging will begin later. See
Utility
Interruption of Charging on page 9‑58.
Short Flashing Green None Charging is complete.
Yellow (Upon Plug‐in) None Charge cord is okay and vehicle is not yet
charging.
Yellow (For Extended
Time Period after
Plug‐in) None Charge cord is okay, but vehicle is not
charging. This may be due to a total utility
interruption via Onstar and charging will
begin later. See
Utility Interruption of
Charging on page 9‑58 orMalfunction
Indicator Lamp on page 5‑19.
Solid Green or Long
Flashing Green Four horn chirps Insufficient time to fully charge by
departure time.
None (Upon Plug‐in) None Charge cord connection should be checked.

Black plate (54,1)Chevrolet Volt Owner Manual - 2012
9-54 Driving and Operating
Charging StatusIndicator Sound Action/Reason
None (After Green or
Yellow CSI Indication
Observed) None Charge cord connection should be checked.
If connection is good, this may be due to a
total utility interruption via OnStar and
charging will begin later. See
Utility
Interruption of Charging on page 9‑58 or
Malfunction Indicator Lamp on page 5‑19.
None Repeated horn chirps
To disable this feature, see
“Charge Power
Loss Alert” inVehicle Personalization on
page 5‑56.
To stop this alert, do one of the following:
.Unplug the charge cord.
.PressKon the RKE.
.Press and hold7on the RKE, then
press again to stop the panic alarm.
.Press the horn pad. Electricity was interrupted before charging
was complete.

Black plate (43,1)Chevrolet Volt Owner Manual - 2012
Vehicle Care 10-43
FusesUsage
F5 Driver Door
Switches (Outside
Rearview Mirror/
Charge Port Door
Release/Refuel
Request/Driver
Window Switch)
F6 Fuel (Diurnal Valve
and Evap. Leak
Check Module)
F7 Accessory Power
Module Cooling Fan
F8 Amplifier
(If Equipped)
F9 Empty
F10 Regulated Voltage
Control/Ultrasonic
Front and Rear
Parking Assist
(If Equipped) Fuses
Usage
F11 Horn
F12 Rear Power
Windows
F13 Electric Parking
Brake
F14 Rear Defog
(Upper Grid)
F15 Empty
F16 Hatch Release
F17 Empty
F18 Empty Relays
Usage
R1 Rear Defog
(Upper Grid)
R2 Hatch Release
R3 Empty
R4 Empty
R5 Empty
R6 Empty
R7/R8 Horn
Diodes Usage DIODE Empty

Black plate (56,1)Chevrolet Volt Owner Manual - 2012
10-56 Vehicle Care
Follow the TPMS sensor matching
process:
1. Set the parking brake.
2. Put the vehicle in ON/RUN andplace the vehicle in P (Park).
3. If the DIC display is minimized, press the SELECT knob to
maximize it.
4. Use the SELECT knob to scroll to the Tire Pressure display
screen.
5. Press and hold the SELECT knob for five seconds to begin
the sensor matching process.
A message displays confirming
to begin the process.
6. Use the SELECT knob to select YES with the highlighted
selection, and press the
SELECT knob again to confirm
the selection. The horn sounds twice to signal
the receiver is in relearn mode
and the TIRE LEARNING
ACTIVE message displays on
the DIC screen.
7. Start with the driver side front tire.
8. Place the relearn tool against the tire sidewall, near the valve
stem. Then press the button to
activate the TPMS sensor.
A horn chirp confirms that the
sensor identification code has
been matched to this tire and
wheel position.
9. Proceed to the passenger side front tire, and repeat the
procedure in Step 8.
10. Proceed to the passenger side rear tire, and repeat the
procedure in Step 8. 11. Proceed to the driver side rear
tire, and repeat the procedure
in Step 8. The horn sounds
two times to indicate the
sensor identification code has
been matched to the driver
side rear tire, and the TPMS
sensor matching process is no
longer active. The TIRE
LEARNING ACTIVE message
on the DIC display screen
goes off.
12. Turn the vehicle off.
13. Set all four tires to the recommended air pressure
level as indicated on the Tire
and Loading Information label.

Black plate (5,1)Chevrolet Volt Owner Manual - 2012
INDEX i-5
G
Garage Door Opener . . . . . . . . . . 5-65Programming . . . . . . . . . . . . . . . . . 5-65
Gasoline Specifications . . . . . . . . . . . . . . . . . 9-60
Gauges Battery . . . . . . . . . . . . . . . . . . . . . . . 5-14
Driver Efficiency . . . . . . . . . . . . . . 5-15
Fuel . . . . . . . . . . . . . . . . . . . . . . . . . . 5-15
Odometer . . . . . . . . . . . . . . . . . . . . . 5-14
Speedometer . . . . . . . . . . . . . . . . . 5-14
Trip Odometer . . . . . . . . . . . . . . . . 5-14
Warning Lights and
Indicators . . . . . . . . . . . . . . . . . . . . 5-8
General Information Service and Maintenance . . . . . 11-1
Towing . . . . . . . . . . . . . . . . . . . . . . . . 9-64
Vehicle Care . . . . . . . . . . . . . . . . . . 10-2
Glove Box . . . . . . . . . . . . . . . . . . . . . . 4-1
GM Mobility Reimbursement Program . . . . . . . . . . . . . . . . . . . . . . 13-6
H
Halogen Bulbs . . . . . . . . . . . . . . . . 10-29
Hatch . . . . . . . . . . . . . . . . . . . . . . . . . . 2-14
Hazard Warning Flashers . . . . . . . 6-3
Head Restraints . . . . . . . . . . . . . . . . 3-2
Headlamps . . . . . . . . . . . . . . . . . . . 10-29Aiming . . . . . . . . . . . . . . . . . . . . . . 10-28
Bulb Replacement . . . . . . . . . . 10-29
Daytime Running
Lamps (DRL) . . . . . . . . . . . . . . . . . 6-2
Flash-to-Pass . . . . . . . . . . . . . . . . . . 6-2
High-Beam On Light . . . . . . . . . . 5-27
High/Low Beam Changer . . . . . . 6-2
Lamps On Reminder . . . . . . . . . 5-28
Heated Front Seats . . . . . . . . . . . . . 3-6
Heated Mirrors . . . . . . . . . . . . . . . . . 2-17
Heating and Air Conditioning . . . 8-1
High Voltage Battery Gauge . . . 5-14
High Voltage Devices and Wiring . . . . . . . . . . . . . . . . . . . . . . . 10-32
High-Beam On Light . . . . . . . . . . . 5-27
Highway Hypnosis . . . . . . . . . . . . . . 9-9
Hill and Mountain Roads . . . . . . . . 9-9
Hood . . . . . . . . . . . . . . . . . . . . . . . . . . 10-7 Hood, Door, Hatch Open
Light . . . . . . . . . . . . . . . . . . . . . . . . . 5-28
Horn . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-6
How to Wear Safety Belts Properly . . . . . . . . . . . . . . . . . . . . . . 3-12
I
Immobilizer . . . . . . . . . . . . . . . . . . . . 2-16
Infants and Young Children,Restraints . . . . . . . . . . . . . . . . . . . . 3-36
Information Energy . . . . . . . . . . . . . . . . . . . . . . . 5-43
Infotainment . . . . . . . . . . . . . . . . . . . . 7-1
Instrument Cluster . . . . . . . . . . . . . . 5-9
Instrument Panel
Storage Area . . . . . . . . . . . . . . . . . . 4-1
Introduction . . . . . . . . . . . . . . . . . . . . . . . iii
J
Jump Starting . . . . . . . . . . . . . . . . . 10-75