immobilizer CHRYSLER 200 2012 1.G Owners Manual

Key-In-Ignition Reminder
Opening the driver’s door when the key is in the ignition
sounds a signal to remind you to remove the key.
NOTE:
•The Key-In-Ignition reminder only sounds when the
ignition key is placed in the LOCK or ACC position.
•With either front door open, and the key in the
ignition, both the power door locks and Remote Key-
less Entry (RKE) transmitter will not function.
Locking the Doors with the Key
There is only one external door lock cylinder which is
located in the driver’s door.
You can insert the key with either side up. To lock the
door, turn the key rearward. To unlock the door, turn the
key forward. For door lock lubrication, see “Maintenance
Procedures” in “Maintaining Your Vehicle” of this
manual.
SENTRY KEY
The Sentry KeyImmobilizer System prevents unauthor-
ized vehicle operation by disabling the engine. The
system does not need to be armed or activated. Operation
is automatic, regardless of whether the vehicle is locked
or unlocked.
The system uses ignition keys which have an embedded
electronic chip (transponder) to prevent unauthorized
vehicle operation. Therefore, only keys that are pro-
grammed to the vehicle can be used to start and operate
the vehicle. The system will shut the engine off in two
seconds if someone uses an invalid key to start the
engine.
NOTE: A key which has not been programmed is also
considered an invalid key even if it is cut to fit the
ignition switch lock cylinder for that vehicle.
During normal operation, after turning on the ignition
switch, the Vehicle Security Light will turn on for three
2
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 15

seconds for a bulb check. If the light remains on after the
bulb check, it indicates that there is a problem with the
electronics. In addition, if the light begins to flash after
the bulb check, it indicates that someone used an invalid
key to start the engine. Either of these conditions will
result in the engine being shut off after two seconds.
If the Vehicle Security Light turns on during normal
vehicle operation (vehicle running for longer than 10 sec-
onds), it indicates that there is a fault in the electronics.
Should this occur, have the vehicle serviced as soon as
possible by an authorized dealer.
CAUTION!
The Sentry KeyImmobilizer system is not compat-
ible with some after-market remote starting systems.
Use of these systems may result in vehicle starting
problems and loss of security protection. All of the keys provided with your vehicle have been
programmed to the vehicle electronics.
Replacement Keys
NOTE:
Only keys that have been programmed to the
vehicle electronics can be used to start the vehicle. Once
a Sentry Key has been programmed to a vehicle, it
cannot be programmed to any other vehicle.
CAUTION!
Always remove the Sentry Key from the vehicle and
lock all doors when leaving the vehicle unattended.
At the time of purchase, the original owner is provided
with a four-digit Personal Identification Number (PIN).
The PIN is required for authorized dealer replacement of
keys. Duplication of keys may be performed at an
16 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

authorized dealer or by using the Customer Key Pro-
gramming procedure. This procedure consists of pro-
gramming a blank key to the vehicle electronics. A blank
key is one which has never been programmed.
NOTE: When having the Sentry KeyImmobilizer
System serviced, bring all vehicle keys with you to the
authorized dealer.
Customer Key Programming
You can program new keys to the system if you have two
valid Sentry Keys by performing the following proce-
dure:
1. Cut the additional Sentry Key Transponder blank(s)
to match the ignition switch lock cylinder key code.
2. Insert the first valid key into the ignition switch. Turn
the ignition switch to the ON/RUN position for at least
three seconds, but no longer than 15 seconds. Then, turn
the ignition switch to the LOCK position and remove the
first key. 3. Insert the second valid key into the ignition switch.
Turn the ignition switch to the ON/RUN position within
15 seconds. After ten seconds, a chime will sound. In
addition, the Vehicle Security Light will begin to flash.
Turn the ignition switch to the LOCK position and
remove the second key.
4. Insert a blank Sentry Key
into the ignition switch.
Turn the ignition switch to the ON/RUN position within
60 seconds. After 10 seconds, a single chime will sound.
In addition, the Vehicle Security Light will stop flashing.
To indicate that programming is complete, the indicator
light will turn on again for three seconds and then turn
off.
The new Sentry Key is programmed.The Remote
Keyless Entry (RKE) transmitter will also be pro-
grammed during this procedure.
2
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 17

Ignition............................... 12
Key ............................... 12
Lock .............................. 12
Ignition Key Removal ..................... 12
Illuminated Entry ........................ 20
Immobilizer (Sentry Key) ................... 15
Infant Restraint ........................ 72,73
Information Center, Vehicle ................. 209
Inside Rearview Mirror .................... 96
Instrument Cluster .................... 193,194
Instrument Panel and Controls .............. 192
Instrument Panel Cover ................... 442
Instrument Panel Lens Cleaning ............. 443
Integrated Power Module (Fuses) ............ 444
Interior Appearance Care .................. 442
Interior Lights .......................... 155
Intermittent Wipers (Delay Wipers) ........... 157
Introduction ............................. 4 Jack Location
........................... 388
Jack Operation ....................... 388,390
Jacking Instructions ...................... 390
Jump Starting .......................... 398
Key-In Reminder ......................... 15
Key, Programming ........................ 17
Key, Replacement ........................ 16
Key, Sentry (Immobilizer) ................... 15
Keyless Entry System ...................... 21
Keyless Entry System (Sedan) ................ 21
Keys ................................. 12
Knee Bolster ............................ 58
Lane Change and Turn Signals ...........202,453
Lane Change Assist ...................... 152
Lap/Shoulder Belts ....................... 44
LATCH
(Lower Anchors and Tether for CHildren) ....... 79
494 INDEX

Heated............................ 137
Lumbar Support ..................... 141
Power ............................ 136
Rear Folding ..................... 146,147
Reclining .......................... 140
Security Alarm (Theft Alarm) ................ 18
Selection of Coolant (Antifreeze) ..........429,456
Selection of Oil ......................... 416
Sentry Key (Immobilizer) ................... 15
Sentry Key Programming ................... 17
Service Assistance ....................... 477
Service Contract ......................... 479
Service Manuals ........................ 481
Setting the Clock ................ 221,224,242,251
Settings, Personal ........................ 219
Shift Lever Override ...................... 403
Short Message Service (SMS) ................ 122
Shoulder Belts ........................... 44
Side Airbag ............................. 66 Side Window Demisters (Defrosters)
.......... 286
Signals, Turn ......................... 89,453
Slippery Surfaces, Driving On ............... 316
Snow Chains (Tire Chains) ................. 350
Snow Tires ............................ 351
Spare Tire ....................... 345,346,388
Specifications Oil ............................... 416
Speed Control (Cruise Control) ...........161,201
Speedometer ........................... 194
Starting ............................... 294
Engine Fails to Start .................. 295
Starting and Operating .................... 294
Starting Procedures ...................... 294
Steering Power .......................... 320,321
Tilt Column ........................ 160
Wheel, Tilt ......................... 160
Steering Wheel Audio Controls .............. 272
500 INDEX