climate control CHRYSLER 200 2015 2.G Owner's Manual

system will go into STOP/START READY and if all other
conditions are met, can go into a STOP/START AU-
TOSTOP ACTIVE “Autostop” mode.
To Activate The Autostop Mode, The Following Must
Occur:
•The system must be in STOP/START READY state. A
STOP/START READY message will be displayed in
the Electronic Vehicle Information Center (EVIC) or
Driver Information Display (DID) within the Stop/
Start section. Refer to “Electronic Vehicle Information
Center (EVIC)” or “Driver Information Display (DID)”
in “Understanding Your Instrument Panel” for further
information.
• The vehicle must be completely stopped.
• The shifter must be in DRIVE or NEUTRAL and the
brake pedal depressed.The engine will shut down, the tachometer will move to
the zero position and the Stop/Start telltale will illuminate
indicating you are in Autostop. While in Autostop, the
Climate Controls system may automatically adjust airflow
to maintain cabin comfort. Customer settings will be
maintained upon return to an engine running condition.
Possible Reasons The Engine Does Not
AUTOSTOP
Prior to engine shut down, the system will check many
safety and comfort conditions to see if they are fulfilled.
Detailed information about the operation of the Stop/Start
system may be viewed in the EVIC/DID Stop/Start Screen.
In the following situations the engine will not stop:
• Driver ’s seat belt is not buckled.
• Driver ’s door is not closed.
452 STARTING AND OPERATING

Call toll free at:
•1–800–890–4038 (U.S.)
• 1–800–387–1143 (Canada)
Or
Visit us on the Worldwide Web at:
•
www.techauthority.com
DEPARTMENT OF TRANSPORTATION UNIFORM
TIRE QUALITY GRADES
The following tire grading categories were established by
the National Highway Traffic Safety Administration. The
specific grade rating assigned by the tire’s manufacturer
in each category is shown on the sidewall of the tires on
your vehicle.
All passenger car tires must conform to Federal safety
requirements in addition to these grades.
Treadwear
The Treadwear grade is a comparative rating, based on
the wear rate of the tire when tested under controlled
conditions on a specified government test course. For
example, a tire graded 150 would wear one and one-half
times as well on the government course as a tire graded
100. The relative performance of tires depends upon the
actual conditions of their use, however, and may depart
significantly from the norm due to variations in driving
habits, service practices, and differences in road charac-
teristics and climate.
Traction Grades
The Traction grades, from highest to lowest, are AA, A, B,
and C. These grades represent the tire’s ability to stop on
wet pavement, as measured under controlled conditions
on specified government test surfaces of asphalt and
concrete. A tire marked C may have poor traction perfor-
mance.
9
IF YOU NEED CONSUMER ASSISTANCE 671

Center Seat LATCH..................... .100
Child Restraints .........................86
Child Seat Installation ....................103
How To Stow An Unused ALR Seat Belt .......101
Infants And Child Restraints ................89
Install A LATCH-compatible Child Restraint . . . .100
Installing Child Restraints Using The Vehicle
Seat Belt ............................. .102
LATCH Positions ........................95
Locating The LATCH Anchorages ............98
Lower Anchors And Tethers For Children .......94
Older Children And Child Restraints ..........89
Seating Positions ........................93
Using The Top Tether Anchorage ............106
Child Safety Locks .........................34
Clean Air Gasoline ....................... .531
Cleaning Wheels .............................. .621
Climate Control ......................... .400Coin Holder
............................ .306
Cold Weather Operation ....................449
Compact Spare Tire ........................511
Console, Floor .......................... .306
Console, Overhead ....................... .277
Contract, Service ......................... .667
Coolant Pressure Cap (Radiator Cap) ...........613
Cooling System .......................... .609
Adding Coolant (Antifreeze) ...............611
Coolant Capacity ...................... .651
Coolant Level ......................... .614
Disposal of Used Coolant .................613
Drain, Flush, and Refill ...................610
Inspection ........................... .609
Points to Remember .....................614
Pressure Cap ......................... .613
Radiator Cap ......................... .613
Selection of Coolant (Antifreeze) .............610
Corrosion Protection ...................... .619
10
INDEX 677