headlight bulb CHRYSLER 300 SRT 2013 2.G Owners Manual

Turn Signals
Move the multifunction lever up or down and the arrows
on each side of the instrument cluster flash to show
proper operation of the front and rear turn signal lights.
NOTE:
•If either light remains on and does not flash, or there is
a very fast flash rate, check for a defective outside light
bulb. If an indicator fails to light when the lever is
moved, it would suggest that the indicator bulb is
defective.
• A “Turn Signal On” message will appear in the EVIC
(if equipped) and a continuous chime will sound if the
vehicle is driven more than 1 mile (1.6 km) with either
turn signal on.
Lane Change Assist
Tap the lever up or down once, without moving beyond
the detent, and the turn signal (right or left) will flash
three times then automatically turn off.
High/Low Beam Switch
Push the multifunction lever away from you to switch
the headlights to high beam. Pull the multifunction lever
toward you to switch the headlights back to low beam.
Flash-To-Pass
You can signal another vehicle with your headlights by
lightly pulling the multifunction lever toward you. This
will turn on the high beams headlights until the lever is
released.
204 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

INSTRUMENT CLUSTER DESCRIPTIONS
1. Tachometer
The red segments indicate the maximum permissible
engine revolutions per minute (RPM x 1000) for each gear
range. Before reaching the red area, ease up on the
accelerator.
2. Park/Headlight ON Indicator — If EquippedThis indicator will illuminate when the park
lights or headlights are turned on.
3. Turn SignalIndicators The arrow will flash with the exterior turn signal
when the turn signal lever is operated. If the vehicle electronics sense that the vehicle is driven
more than 1 mile (1.6 km) with either turn signal on, a
continuous chime will sound to alert you to turn the
signals off. If either indicator flashes at a rapid rate, check
for a defective outside light bulb.
4. Front Fog Light Indicator — If Equipped
This indicator will illuminate when the front fog
lights are on.
5. High Beam Indicator
This indicator shows that the high beam head-
lights are on. Push the multifunction lever for-
ward to switch the headlights to high beam, and pull
toward yourself (normal position) to return to low beam.
4
UNDERSTANDING YOUR INSTRUMENT PANEL 301

Interior Appearance Care....................507
Interior Lights .......................... .207
Intermittent Wipers (Delay Wipers) .............210
Introduction ..............................4
Jump Starting ........................... .464
Key-In Reminder ..........................15
Keyless Enter-N-Go ........................34
Keyless Entry System .......................21
Keyless Go ...............................12
Key, Programming .........................18
Key, Replacement ..........................17
Keys ...................................12
Key, Sentry (Immobilizer) ....................16
Knee Bolster ..............................57
Lane Change and Turn Signals ................204
Lane Change Assist ....................... .204Lap/Shoulder Belts
.........................48
Latches .................................99
Hood ............................... .196
Latch Plate ...............................49
Lead Free Gasoline ....................... .440
Leaks, Fluid ..............................99
Life of Tires ............................ .428
Light Bulbs ..............................98
Lights ..................................98
Airbag ................................65
Alarm .............................. .307
Anti-Lock ............................ .307
Automatic Headlights ....................199
Brake Assist Warning ....................408
Brake Warning ........................ .307
Bulb Replacement ...................... .520
Daytime Running ...................... .202
Dimmer Switch, Headlight .................203
Electronic Stability Program (ESP) Indicator .....408
566 INDEX