ignition CHRYSLER PACIFICA HYBRID 2017 2.G Owners Manual

INSTRUMENT PANEL
Instrument Panel
1—AirVents
2 — Multifunction Lever
3 — Instrument Cluster
4 — Windshield Wiper Lever5 — Glove/Storage Compartment
6 — Ignition
7 — Steering Wheel
8 — Headlight Switch
10 GRAPHICAL TABLE OF CONTENTS

GETTING TO KNOW YOUR VEHICLE
CONTENTS
HIGH VOLTAGE BATTERY ..................17
 HIGH VOLTAGE CHARGING OPERATION ......19
▫ SAE J1772 Charging Inlet ..................19
▫ AC Level 1 Charging (120V, 15 Amp) ..........20
▫ AC Level 2 Charging (240V, 30 Amp) ..........30
▫ Charging Times .........................31
▫ Vehicle Charge Indicators ..................32
▫ Hybrid Electric Pages .....................34
 KEYS .................................37
▫ KeyFob..............................37
 IGNITION SWITCH .......................46
 REMOTE STARTING SYSTEM — IF EQUIPPED . . .49
▫ Remote Start Cancel Message — If Equipped ....50
▫ How To Use Remote Start ..................50 ▫
To Enter Remote Start Mode ................51
▫ To Exit Remote Start Mode Without Driving The
Vehicle ...............................51
▫ To Exit Remote Start Mode And Drive The
Vehicle ...............................51
▫ Remote Start Comfort Systems — If Equipped . . .52
▫ Remote Start Windshield Wiper De–Icer Activation
— If Equipped ..........................52
▫ General Information .....................52
 SENTRY KEY ............................52
 VEHICLE SECURITY ALARM — IF EQUIPPED . . .53
▫ Rearming Of The System ..................53
▫ To Arm The System .....................53
▫ To Disarm The System ...................54
 DOORS ...............................553

TRI-PANE PANORAMIC SUNROOF — IF
EQUIPPED ............................ .123
▫ Opening Sunroof ...................... .124
▫ Closing Sunroof ....................... .125
▫ Wind Buffeting ....................... .125
▫ Power Sun Shade — If Equipped ............125
▫ Pinch Protect Feature ....................126
▫ Sunroof Maintenance ....................126
▫ Ignition Off Operation ...................126
 HOOD .............................. .126
▫ Opening ............................ .126
▫ Closing ............................. .128
 LIFTGATE ............................ .128
▫ Opening ............................ .128
▫ Closing ............................ .129▫
Power Liftgate — If Equipped ..............130
▫ Hands-Free Liftgate — If Equipped ..........132
▫ Cargo Area Features .....................134
 INTERNAL EQUIPMENT ..................134
▫ Storage ............................. .134
▫ Illuminated Vanity Mirrors — If Equipped . . . .138
▫ Power Outlets ........................ .138
▫ Power Inverter — If Equipped .............142
▫ Cigar Lighter — If Equipped ...............142
▫ Smoker’s Package Kit — If Equipped ........143
▫ Overhead Storage With Sunglass Storage ......143
 ROOF LUGGAGE RACK — IF EQUIPPED ......144
▫ Deploying

The Crossbars .................145
▫ Stowing The Crossbars ...................147
16 GETTING TO KNOW YOUR VEHICLE

General Information
The vehicle is also equipped with a Battery Management
System that is designed to:
•Ensure safe operation
• Maximize driving range
• Maximize the life expectancy of the high voltage battery
NOTE:
• During vehicle start up and shut down a clicking noise
may be heard from within the vehicle. When the ignition
is in the ON position, the high voltage battery contactors
inside the battery are closed to make the stored electric-
ity inside available for vehicle use. The clicking noise
observed is the sound of these contactors as they open
and close and is for normal operation.
• In extreme temperatures, the High Voltage Battery may
need to be conditioned and therefore may require the
vehicle to be plugged-in. When the vehicle is not
plugged-in, the following message, “Plug In Vehicle for
Battery Conditioning” might appear in the instrument
cluster display. When the High Voltage Battery is not
ready to crank the vehicle at start up, due to conditions
including extreme temperatures, the message “Battery
Conditioning Leave Ignition In Run” will be displayed in the instrument cluster display. Keep the ignition in the
ON/RUN position for the battery to recover. Switch the
ignition back to the OFF position when the message
disappears, and then start the vehicle. When the “Bat-
tery Conditioning Leave Ignition in Run” message is
displayed on the instrument cluster display, do not
operate any air conditioning controls.
Battery Conditioning Instrument Cluster Display Message
18 GETTING TO KNOW YOUR VEHICLE

•Under cold or hot temperatures, while the vehicle is
plugged-in and the ignition is in the OFF position, the
vehicle may wake-up to pre-condition the high voltage
battery for usage.
• It is recommended that the vehicle be plugged-in over
night where possible to maximize the electric range of
the vehicle.
HIGH VOLTAGE CHARGING OPERATION
SAE J1772 Charging Inlet
Your vehicle uses an industry standard SAE J1772 charge
inlet (vehicle charge inlet) for both AC Level 1 (120V) and
AC Level 2 (240V) charging.
Battery Conditioning Instrument Cluster Display Message
Vehicle Charge Inlet
3
GETTING TO KNOW YOUR VEHICLE 19

5. To stop the charging process, disconnect the vehicle sideconnector first and then the charging cordset from the
wall receptacle. To disengage the vehicle coupler, press
the button on the charge connector first and then
remove the connector from the vehicle charge inlet.
6. Close the inlet door. NOTE:
It is good practice to keep the ignition in the OFF
position while conducting Level 1 Charging. This mini-
mizes any additional vehicle loads the EVSE has to support
which extend the charging time.
Troubleshooting Using The Status Indicator Display
If the vehicle is not charging properly, consult the status
indicator lights.
The AC Power Indicator displays the status and safety of
the input power. If this indicator is green, the power is
within acceptable limits to charge the vehicle. If only the
AC Power Indicator is flashing red, then there is a problem
with the AC power at the electrical outlet. If the AC Power
Indicator does not return to green, then the outlet should
be inspected by a licensed electrician to ensure the voltage,
frequency, and grounding are complaint to national and
local electrical codes and ordinances. It may be possible to
attempt charging from a different outlet.
Removing The Charge Connector From The Vehicle
Charge Inlet
3
GETTING TO KNOW YOUR VEHICLE 25

NOTE:
•The charging times below are estimates based on a
completely discharged high voltage battery
• Charging times will vary based on the age, condition,
state of charge and temperature of the high voltage
battery.
• Charging times may be longer if a thermal self-
protection reduces the charging current from the EVSE.
• If the vehicle’s ignition is in either the ACC or RUN
position, the vehicle charge indicator may not indicate
greater than a 99% state of charge, and will continue to
charge the vehicle, due to the vehicle loads.
Type of EVSE Estimated Charge Time
Level 1 (120V/12A) Approximately 14 hours
Level 2 (240V/30A) Approximately 2 hours
Vehicle Charge Indicators
Instrument Cluster High Voltage Battery Gauge
There is a battery gauge indicator located on the instru-
ment cluster. The battery gauge will display the current
state of charge for the high voltage battery; with the
percentage value located to the left of the symbol.
High Voltage Battery Gauge
32 GETTING TO KNOW YOUR VEHICLE

NOTE:If the vehicle is plugged in outside of the charging
schedule set in the Uconnect 8.4 radio, the vehicle’s battery
will not charge. Charging will only begin immediately if
the vehicle is plugged in within the time and date set in the
schedule. Otherwise, charging will automatically begin
when the selected charge time/date occurs.
This feature can be overridden if the vehicle is plugged in,
unplugged, and then plugged in a second time. This
“double plugged-in” feature will override the schedule
that is set in the radio, and begin charging the vehicle
immediately. The double plug sequence must be completed
within 10 seconds for it to override the programed sched-
ule.
If the vehicle is turned off outside of the charging window
a radio pop-up message will be displayed, that allows the
user to charge it immediately. If “Yes” is selected, the
vehicle will begin charging immediately, ignoring the
charge schedule, if plugged in within an hour of turning
the vehicle off.KEYS
The keyless ignition system consists of a key fob with a
built in emergency key and a Keyless Push Button Ignition
system.
Key Fob
This system allows you to lock or unlock the doors and
liftgate, and activate the Panic Alarm, optional power
liftgate, left power sliding door, and right power sliding
door from distances up to approximately 66 ft (20 m) using
a hand-held key fob. The key fob does not need to be
pointed at the vehicle to activate the system.
3
GETTING TO KNOW YOUR VEHICLE 37

CAUTION!
•Always remove the key fobs from the vehicle and
lock all doors when leaving the vehicle unattended.
• For vehicles equipped with Keyless Enter-N-Go —
Ignition, always remember to place the ignition in
the OFF mode.
Duplication of key fobs may be performed at an authorized
dealer. This procedure consists of programming a blank
key fob to the vehicle electronics. A blank key fob is one
that has never been programmed.
NOTE: When having the Sentry Key Immobilizer System
serviced, bring all vehicle keys with you to an authorized
dealer.
KeySense Features — If Equipped
This feature provides the vehicle owner with the ability to
identify a specific vehicle key for which a customized
category of vehicle settings can be applied to determine the
driving experience for other drivers of the vehicle. The
vehicle settings are protected by a unique 4-digit PIN,
which the vehicle owner creates when accessing the spe-
cific settings for the first time. This feature also has additional features that are always
enabled when the specific key is in use that cannot be set
by the vehicle owner. While this specific key fob is in use,
the vehicle will respond accordingly to the customized
vehicle settings and mandatory features. This includes
enhanced driving assistance features, increased driver
alerts, and the locking of certain optional features.
KeySense Key Fob
3
GETTING TO KNOW YOUR VEHICLE 45

KeySense Unique Splash Screen
At start-up the KeySense splash screen should inform the
driver that the vehicle will be functioning in KeySense
mode when the KeySense key is in use.
Start Up Display Features
•Unique splash screen graphic
• Telltale
illuminated
•After unique splash screen, and after stored messages
are cycled, then start-up KeySense messages (Range &
Max Speed) are displayed
The following features are always enabled when this key is
in use:
• Entertainment Audio Muted if 1st row occupied Seat
Belts are not Fastened
• Consistent Seat Belt Unfastened Chime
• Maximum Radio Volume limited to 15 out of 39
• Daytime Running Lights
For additional information please refer to “Uconnect Set-
tings” located in “Multimedia.”
IGNITION SWITCH
This feature allows the driver to start the vehicle with the
push of a button, as long as the key fob is in the passenger
compartment, and the drivers foot on the brake pedal.
NOTE: This vehicle is equipped with an automatic shut-
down feature. If the vehicle is left in “READY” state
(vehicle running) with shifter in “PARK”, for one hour
after the driver exits, it will automatically turn off the
vehicle. Notifications have been designed into this feature
to raise awareness of the timed event. The instrument
cluster display will display “Ready to drive” accompanied
with three audible chimes while exiting. The interior
warnings will occur regardless if the key fob remains in the
vehicle or is removed. The horn will sound three times if
the fob is removed from the vehicle and the ignition state is
in “READY” mode. Please consider this feature when
intentionally standing the vehicle for extended periods of
time over one hour. To restart the vehicle, follow the
normal process for starting your vehicle.
The Keyless Push Button Ignition has four operating
positions; three of which are labeled and will illuminate
when in position. The three positions are OFF, ACC, and
ON/RUN. The fourth position is START, during start RUN
will illuminate.
46 GETTING TO KNOW YOUR VEHICLE