reset CHRYSLER PT CRUISER 2006 1.G User Guide

STARTING AND OPERATING
CONTENTS

Starting Procedures.....................280
▫Automatic Transaxle...................280
▫Manual Transaxle.....................280
▫Normal Starting......................280
▫Extremely Cold Weather
(Below
20°F Or
29°C)................281
▫If Engine Fails To Start.................281
▫After Starting........................282
▫Turbocharger “Cool Down”..............282
Automatic Transaxle — If Equipped.........284
▫Brake/Transmission Interlock System.......285
▫Automatic Transaxle Ignition Interlock System . 285
▫Four Speed Automatic Transaxle..........285
▫Reset Mode.........................285
▫Gear Ranges For Four Speed Automatic
Transaxle...........................286

AutoStick — If Equipped.................289
▫AutoStick Operation...................289
5

Brake/Transmission Interlock System
This system prevents you from moving the gear shift out
of Park and into any gear unless the brake pedal is
pressed. This system is active only while the ignition
switch is in the ON or ACC positions. Always depress the
brake pedal first,before moving the gear selector out of
PARK.
NOTE:If a malfunction occurs, the system will function
normally, except you may be able to shift the vehicle from
PARK, without depressing the brake pedal. If this occurs
obtain service as soon as possible.
Automatic Transaxle Ignition Interlock System
This system prevents the key from being removed unless
the shift lever is in PARK and the shift knob push button
is out. It also prevents shifting out of PARK unless the
key is in the ACC or ON positions, and the brake pedal
is depressed.NOTE:If a malfunction occurs, the system will trap the
key in the ignition cylinder to warn you that this safety
feature is inoperable. The engine can be started and
stopped but the key cannot be removed until you obtain
service.
Four Speed Automatic Transaxle
The electronically controlled transaxle provides a precise
shift schedule. The transaxle electronics are self calibrat-
ing; therefore, the first few shifts on a new vehicle may be
somewhat abrupt. This is a normal condition, and preci-
sion shifts will develop within a few shift cycles.
Reset Mode
The transaxle is monitored electronically for abnormal
conditions. If a condition is detected that could cause
damage, the transaxle shifts automatically into second
gear. The transaxle remains in second gear despite the
forward gear selected. Park (P), Reverse (R), and Neutral
STARTING AND OPERATING 285
5

(N) will continue to operate. This second gear limp-in
feature allows the vehicle to be driven to a dealer for
service without damaging the transaxle.
In the event that the problem has been momentary, the
transaxle can be reset to regain all forward gears.
Stop the vehicle and shift into Park (P).
Turn the Key to OFF then restart the engine.
Shift into D and resume driving.
NOTE:Even if the transaxle can be reset, it is recom-
mended that you visit a dealer at your earliest possible
convenience. Your dealer has diagnostic equipment to
determine if the problem could recur.
If the transaxle cannot be reset, dealer service is required.Gear Ranges For Four Speed Automatic
Transaxle
DO NOT race the engine when shifting from PARK or
NEUTRAL positions into another gear range.
“P” Park
Supplements the parking brake by locking the transmis-
sion. The engine can be started in this range. Never use P
(Park) while the vehicle is in motion. Apply the parking
brake when leaving the vehicle in this range. Always
apply the parking brake first, and then place the selector
in P (Park) position.
286 STARTING AND OPERATING

NOTE:Tighten the gas cap about 1/4 turn until you
hear one click. This is an indication that cap is properly
tightened.
If the gas cap is not tighten properly, the Malfunction
Indicator Light will come on. Be sure the gas cap is
tightened every time the vehicle is refueled.
WARNING!
A fire may result if gasoline is pumped into a
portable container that is inside of a vehicle. You
could be burned. Always place gas containers on the
ground while filling.
Loose Fuel Filler Cap Message
If the vehicle diagnostic system determines that the fuel
filler cap is loose, improperly installed, or damaged, a
“gASCAP” message will be displayed in the Odometer/
Trip Odometer in the instrument cluster. Refer to “Instru-
ment Cluster Description” in Section 3 of this manual.
Tighten the fuel filler cap properly and press the
odometer/trip odometer reset button to turn the message
off. If the problem continues, the message will appear the
next time the vehicle is started. Refer to “Onboard
Diagnostic System — OBDII” in Section 7 of this manual
for more information.
328 STARTING AND OPERATING

aclickingsound is heard. This is an indication that the
gas cap is properly tightened. Press the odometer reset
button to turn the message off. If the problem persists,
the message will appear the next time the vehicle is
started. This might indicate a damaged cap. If the prob-
lem is detected twice in a row, the system will turn on the
Malfunction Indicator Light (MIL). Resolving the prob-
lem will turn the MIL light off.
EMISSIONS INSPECTION AND MAINTENANCE
PROGRAMS
In some localities, it may be a legal requirement to pass
an inspection of your vehicle’s emissions control system.
Failure to pass could prevent vehicle registration.
For states which have an I/M (Inspection and
Maintenance) requirement, this check verifies the
following: the MIL (Malfunction Indicator Lamp)is functioning and is not on when the engine is running,
and that the OBD (On Board Diagnostic) system is ready
for testing.
Normally, the OBD system will be ready. The OBD
system maynotbe ready if your vehicle was recently
serviced, if you recently had a dead battery, or a battery
replacement. If the OBD system should be determined
not ready for the I/M test, your vehicle may fail the test.
Your vehicle has a simple ignition key actuated test
which you can use prior to going to the test station. To
check if your vehicle’s OBD system is ready, you must do
the following:
1. Insert your ignition key into the ignition switch.
2. Turn the ignition to the ON position, but do not crank
or start the engine.
3. If you crank or start the engine, you will have to start
this test over.
MAINTAINING YOUR VEHICLE 365
7

ABS (Anti-Lock Brake System).............. 297
Adding Engine Coolant (Antifreeze).......... 384
Adding Fuel........................... 326
Adding Washer Fluid..................187,275
Additives, Fuel......................... 324
Air Cleaner, Engine (Engine Air Cleaner Filter) . . . 374
Air Conditioner Maintenance............... 377
Air Conditioning Controls................. 266
Air Conditioning, Operating Tips............ 271
Air Conditioning Refrigerant.............377,378
Air Conditioning System................266,377
Air Pressure, Tires....................... 312
Airbag.............................. 55,89
Airbag Deployment.................... 68,101
Airbag Light.................... 70,103,115,227
Airbag Maintenance.................... 69,103
Airbag, Side.......................... 65,99
Alarm, Panic............................ 33
Alarm System (Security Alarm)............ 36,226Alignment and Balance................... 319
Alterations/Modifications, Vehicle............. 7
Antenna, Satellite Radio................... 265
Antifreeze (Engine Coolant)...........383,411,412
Capacities........................... 411
Disposal............................ 385
Anti-Lock Brake System (ABS).............. 297
Anti-Lock Warning Light.................. 227
Anti-Theft Security Alarm (Theft Alarm)........ 36
Appearance Care........................ 395
Auto Down Power Windows................ 43
Automatic Door Locks................... 20,21
Automatic Transaxle.............. 13,280,284,391
Fluid and Filter Changes................. 393
Fluid Level Check...................... 392
Interlock System..................... 18,285
Reset Mode.......................... 285
Selection Of Lubricant................... 391
Shifting ............................. 286
448 INDEX

Recreational.......................... 340
Weight .............................. 332
Traction.............................. 354
Traction Control......................188,300
Traction Control Switch.................188,300
TrailerTowing .......................... 329
Cooling System Tips.................... 340
Hitches............................. 332
Minimum Requirements................. 334
Trailer and Tongue Weight................ 333
Wiring .............................. 338
TrailerTowingGuide ..................... 332
TrailerWeight .......................... 332
Transaxle............................. 284
Automatic.................... 13,280,284,391
Autostick............................ 289
Manual........................ 14,280,290
Operation........................... 284
Overdrive........................... 288Selection of Lubricant................... 391
Transmission
Range Indicator....................... 223
Transmitter Battery Service
(Remote Keyless Entry).................. 30,35
Transmitter, Garage Door Opener (HomeLink) . . 192
Transmitter Programming
(Remote Keyless Entry).................. 27,34
Transporting Pets...................... 79,113
Tread Wear Indicators.................... 317
Trip Odometer.......................... 223
Trip Odometer Reset Button................ 228
Trunk Lid, Deck Lid (Convertible)............. 39
Tumbling Rear Seat (Convertible)............ 171
Tumbling Rear Seat (Sedan)................ 169
Turbo Cool Down....................... 282
Turn Signals.........................183,224
Understanding Your Instrument Panel......... 218
INDEX 463
10