homelink CHRYSLER PT CRUISER 2009 1.G Owners Manual
[x] Cancel search | Manufacturer: CHRYSLER, Model Year: 2009, Model line: PT CRUISER, Model: CHRYSLER PT CRUISER 2009 1.GPages: 410, PDF Size: 5.24 MB
Page 79 of 410
Tilt Steering Column ................... 132
Electronic Speed Control — If Equipped ..... 133
▫ To Activate ......................... 134
▫ To Set a Desired Speed ................ 134
▫ To Deactivate ....................... 134
▫ To Resume Speed .................... 134
▫ To Vary The Speed Setting .............. 135
▫ Manual Transaxle .................... 135
▫ To Accelerate For Passing .............. 136
▫ Using Electronic Speed Control On Hills .... 136
Garage Door Opener — If Equipped ........ 136
▫ Programming HomeLink .............. 137
▫ Gate Operator/Canadian Programming .... 141▫
Security ........................... 141
▫ Troubleshooting Tips .................. 142
▫ General Information .................. 142
Power Sunroof — If Equipped ............ 143
▫ Express-Open Feature ................. 143
▫ Wind Buffeting ...................... 144
▫ Sunroof Maintenance ................. 145
Electrical Power Outlets ................. 145
Storage ............................. 147
▫ Center Console/Armrest Storage Bin ...... 147
▫ Storage Pockets ..................... 148
Console Features ...................... 148
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 77
Page 138 of 410
To Accelerate for Passing
Depress the accelerator as you would normally. When the
pedal is released, the vehicle will return to the set speed.
Using Electronic Speed Control on Hills
NOTE:The Electronic Speed Control system maintains
speed up and down hills. A slight speed change on
moderate hills is normal.
Vehicles equipped with four-speed automatic transaxles
may experience a downshift to 3rd gear while climbing
uphill or descending downhill. This downshift to 3rd
gear is necessary to maintain vehicle set speed.
On steep hills a greater speed loss or gain may occur so
it may be preferable to drive without Electronic Speed
Control.
GARAGE DOOR OPENER — IF EQUIPPED
HomeLink replaces up to three remote controls (hand-
held transmitters) that operate devices such as garage door openers, motorized gates, lighting, or home security
systems. The HomeLink
unit operates off your vehicle’s
battery.
The HomeLink buttons that are located in the headliner
or sun visor designate the three different HomeLink
channels.HomeLink Buttons
136 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Page 139 of 410
NOTE:HomeLink is disabled when the Vehicle Secu-
rity Alarm is active.
WARNING!
•Your motorized door or gate will open and close
while you are training the universal transceiver.
Do not train the transceiver if people or pets are in
the path of the door or gate. Only use this trans-
ceiver with a garage door opener that has a “stop
and reverse” feature as required by Federal safety
standards. This includes most garage door opener
models manufactured after 1982. Do not use a
garage door opener without these safety features.
Call toll-free 1–800–355–3515 or, on the Internet at
www.HomeLink.com for safety information or as-
sistance.
(Continued)
WARNING! (Continued)
•Vehicle exhaust contains carbon monoxide, a dan-
gerous gas. Do not run your vehicle in the garage
while training the transceiver. Exhaust gas can
cause serious injury or death.
Programming Homelink
Before You Begin
If you have not trained any of the HomeLink buttons,
erase all channels before you begin training.
To do this, press and hold the two outside buttons for up
to 20 seconds until the red indicator flashes.
It is recommended that a new battery be placed in the
hand-held transmitter of the device being programmed
to HomeLink for more efficient training and accurate
transmission of the radio-frequency signal.
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 137
Page 140 of 410
Your vehicle should be parked outside of the garage
when programming.
Begin Programming
1. Turn the ignition switch to the ON/RUN position.
2. Hold the battery side of the hand-held transmitter
away from the HomeLinkbutton you wish to program.
Place the hand-held transmitter 1 to 3 in (3 to 8 cm) away
from the HomeLink button you wish to program while
keeping the indicator light in view.
3. Simultaneously press and hold both the chosen
HomeLink button and the hand-held transmitter button
until the HomeLink indicator changes from a slow to a
rapidly blinking light, then release both the HomeLink
and hand-held transmitter buttons. Watch for the HomeLink
indicator to change flash rates.
When it changes, it is programmed. It may take up to
30 seconds, or longer in rare cases. The garage door may
open and close while you train.
NOTE:
•Some gate operators and garage door openers may
require you to replace Step 3 with procedures noted in
the “Gate Operator/Canadian Programming” section.
•After training a HomeLink channel, if the garage
door does not operate with HomeLink and the ga-
rage door opener was manufactured after 1995, the
garage door opener may have a rolling code. If so,
proceed to Step 5 “Programming A Rolling Code
System.”
4. Press and hold the just-trained HomeLink button
and observe the indicator light.
138 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Page 141 of 410
If the indicator light stays on constantly, programming is
complete and the garage door (or device) should activate
when the HomeLinkbutton is pressed.
If the indicator light blinks rapidly for two seconds and
then turns to a constant light, proceed to Step 5 “Pro-
gramming A Rolling Code System.”
5. Programming A Rolling Code System
At the garage door opener motor (in the garage), locate
the “Learn” or “Training” button.
This can usually be found where the hanging antenna
wire is attached to the garage door opener motor. It is
NOT the button normally used to open and close the
door.
Training The Garage Door Opener
1 — Door Opener
2 — Training Button
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 139
Page 142 of 410
6. Firmly press and release the “Learn” or “Training”
button. The name and color of the button may vary by
manufacturer.
NOTE:There are 30 seconds in which to initiate the next
step after the “Learn” button has been pressed.
7. Return to the vehicle and press the programmed
HomeLink button twice (holding the button for two
seconds each time). If the device is plugged in and
activates, programming is complete.
If the device does not activate, press the button a third
time (for two seconds) to complete the training.
If you have any problems, or require assistance, please
call toll-free 1–800–355–3515 or, on the Internet at
www.HomeLink.com for information or assistance.
To program the remaining two HomeLink buttons,
repeat each step for each remaining button. DO NOT
erase the channels.Using HomeLink
To operate, simply press and release the programmed
HomeLink button. Activation will now occur for the
trained device (i.e., garage door opener, gate operator,
security system, entry door lock, home/office lighting,
etc. The hand-held transmitter of the device may also be
used at any time.
Reprogramming a Single Homelink Button
To reprogram a channel that has been previously trained,
follow these steps:
1. Turn the ignition switch to the ON/RUN position.
2. Press and hold the desired HomeLink button until
the indicator light begins to flash after 20 seconds. Do not
release the button.
3. Without releasing the button, proceed with Program-
ming Homelink Step 2 and follow all remaining steps.
140 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Page 143 of 410
Gate Operator/Canadian Programming
Canadian radio frequency laws require transmitter sig-
nals to time-out (or quit) after several seconds of trans-
mission – which may not be long enough for HomeLink
to pick up the signal during programming. Similar to this
Canadian law, some U.S. gate operators are designed to
time-out in the same manner.
It may be helpful to unplug the device during the cycling
process to prevent possible overheating of the garage
door or gate motor.
If you are having difficulties programming a garage door
opener or a gate operator, replace “Programming
HomeLink” Step 3, with the following:
3. Continue to press and hold the HomeLink button
while you press and release - every two seconds
(“cycle”) your hand-held transmitter until HomeLink has successfully accepted the frequency signal. The
indicator light will flash slowly and then rapidly when
fully trained.
If you unplugged the device for training, plug it back in
at this time.
Then proceed with Step 4 under “Programming
HomeLink,” earlier in this section.
Security
It is advised to erase all channels before you sell or turn
in your vehicle.
To do this, press and hold the two outside buttons for
20 seconds until the red indicator flashes. Note that all
channels will be erased. Individual channels cannot be
erased.
The HomeLink
Universal Transceiver is disabled when
the Vehicle Security Alarm is active.
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 141
Page 144 of 410
Troubleshooting Tips
If you are having trouble programming HomeLink, here
are some of the most common solutions:
•Replace the battery in the original transmitter.
•Press the “Learn” button on the Garage Door Opener
to complete the training for a Rolling Code.
•Did you unplug the device for training, and remember
to plug it back in?
If you have any problems, or require assistance, please
call toll-free 1–800–355–3515 or, on the Internet at
www.HomeLink.com for information or assistance.
General Information
This device complies with FCC rules Part 15 and Industry
Canada RSS-210. Operation is subject to the following
two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference that may be
received including interference that may cause undesired
operation.
NOTE:
•The transmitter has been tested and it complies with
FCC and IC rules. Changes or modifications not
expressly approved by the party responsible for com-
pliance could void the user ’s authority to operate the
device.
•The term IC before the certification/registration num-
ber only signifies that Industry Canada technical
specifications were met.
142 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Page 397 of 410
Cooling System....................... 323
Power Steering ........................ 241
Fluids ................................ 350
Fluids, Lubricants and Genuine Parts .......... 350
Fog Light Service ........................ 347
Fog Lights .......................... 128,172
Folding Front Passenger Seat ................ 113
Folding Rear Seat ........................ 116
Folding Rear Seat (Sedan) .................. 116
Freeing A Stuck Vehicle ................... 302
Fuel .............................. 270,350
Adding ............................. 274
Additives ............................ 272
Capacity ............................ 349
Clean Air ............................ 270
Ethanol ............................. 270
Filler Cap (Gas Cap) ................. 164,274
Filler Door (Gas Cap) ................... 164
Gasoline ............................ 270 Gauge
.............................. 164
Light ............................... 172
Materials Added ....................... 272
Methanol ............................ 270
Octane Rating ........................ 270
Requirements ......................... 270
Tank Capacity ........................ 349
Fuel System Caution ..................... 275
Fueling ............................... 274
Fuses ................................ 340
Garage Door Opener (HomeLink) ........... 136
Gas Cap (Fuel Filler Cap) ............274,276,309
Gasoline, Clean Air ...................... 270
Gasoline (Fuel) ....................... 270,349
Gasoline, Reformulated ................... 270
Gauges Coolant Temperature ................... 164
Fuel ............................... 164
10
INDEX 395
Page 398 of 410
Odometer........................... 167
Tachometer .......................... 165
General Information ...............18,25,110,269
General Maintenance ..................... 312
Glass Cleaning .......................... 339
Gross Axle Weight Rating .................. 279
Gross Vehicle Weight Rating .............277,278
Hands-Free Phone (uconnect) ............... 82
Hazard Driving Through Flowing, Rising,
or Shallow Standing Water ............... 237
Hazard Warning Flasher ................... 292
Head Restraints ......................... 114
Headlights Bulb Replacement ...................... 345
Cleaning ............................ 338
High Beam .......................... 129
High Beam/Low Beam Select Switch ........ 129Passing
............................. 130
Heated Seats ........................... 114
Hitches Trailer Towing ........................ 281
HomeLink (Garage Door Opener) Transmitter . . . 136
Hood Release .......................... 123
Ignition ............................... 12
Key ................................ 12
Ignition Key Removal ..................... 12
Immobilizer (Sentry Key) .................15,19
Infant Restraint .......................... 62
Information Center, Vehicle ................. 178
Inside Rearview Mirror .................... 79
Instrument Cluster .................... 161,164
Instrument Panel and Controls .............. 160
Instrument Panel Cover ................337,339
Instrument Panel Lens Cleaning ............. 339
Integrated Power Module (Fuses) ............ 340
396 INDEX