rear view mirror CHRYSLER PT CRUISER 2009 1.G Owners Manual

MIRRORS
Inside Day/Night Mirror
A two-point pivot system allows for horizontal and
vertical mirror adjustment. Adjust the mirror to center on
the view through the rear window.
Headlight glare can be reduced by moving the small
control under the mirror to the night position (toward the
rear of the vehicle). The mirror should be adjusted while
set in the day position (toward the windshield).
Outside Mirror — Driver Side
Adjust the outside mirror to center on the adjacent lane of
traffic, with a slight overlap of the view obtained on the
inside mirror.
Adjusting Rearview Mirror
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 79

it your purse, pocket, or briefcase), as long as your phone
is turned on and has been paired to the vehicle’s
uconnectphone. The uconnect phone allows up to
seven cellular phones to be linked to the system. Only
one linked (or paired) cellular phone can be used with the
system at a time. The system is available in English,
Spanish, or French languages.
Phone Button The rearview mirror contains the microphone
for the system (depending on the type of
mirror and radio equipped), and either the
radio or the mirror has the two control buttons
(PHONE Button and VOICE RECOGNITION button)
that will enable you to access the system.
Voice Recognition Button Actual button location may vary with the ra-
dio. The individual buttons are described in the
“Operation” section. The uconnect
phone can be used with any Hands-Free
Profile certified Bluetooth cellular phone. See the
uconnect website for supported phones. If your cellular
phone supports a different profile (e.g., Headset Profile)
you may not be able to use any uconnect phone
features. Refer to your cellular service provider or the
phone manufacturer for details.
The uconnect phone is fully integrated with the vehi-
cle’s audio system. The volume of the uconnect phone
can be adjusted either from the radio volume control
knob or from the steering wheel radio control (right
switch), if so equipped.
The radio display will be used for visual prompts from
the uconnect phone such as CELLor caller ID on
certain radios.
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 83

This procedure may be repeated with a new user. The
system will adapt to the last trained voice only.
To restore the Voice Recognition system to factory default
settings, enter the Voice Training session via the above
procedure and follow the prompts.
Voice Recognition (VR)
•
For best performance, adjust the rearview mirror to
provide at least12in (1 cm) gap between the overhead
console (if equipped) and the mirror.
•Always wait for the beep before speaking.
•Speak normally, without pausing, just as you would
speak to a person sitting a few feet/meters away from
you.
•Make sure that no one other than you is speaking
during a voice recognition period.
•Performance is maximized under:
•low-to-medium blower setting,
•low-to-medium vehicle speed,
•low road noise,
•smooth road surface,
•fully closed windows,
•dry weather condition.
•Even though the system is designed for users speaking
in North American English, French, and Spanish ac-
cents, the system may not always work for some.
•When navigating through an automated system such
as voice mail, or when sending a page, at the end of
speaking the digit string, make sure to say Send.
•Storing names in the phonebook when the vehicle is
not in motion is recommended.
102 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

CAUTION!
To prevent possible damage, do not slam the hood to
close it. Lower the hood until it is open approxi-
mately 8 in (20 cm) and then drop it. This should
secure both latches. Never drive your vehicle unless
the hood is fully closed, with both latches engaged.
WARNING!
If the hood is not fully latched it could fly up when
the vehicle is moving and block your forward vision.
You could have a collision. Be sure all hood latches
are fully latched before driving.
LIGHTS
Map/Reading Lights
These lights are mounted between the sun visors above
the rearview mirror. Each light is turned on by pressingthe button. Press the button a second time to turn the
light off. The lights also come on when a door is opened
or the dimmer control is turned fully upward, past the
second detent.
Map Reading Lights
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 125

Do not use abrasive cleaning components, solvents, steel
wool or other aggressive material to clean the lenses.
Glass Surfaces
All glass surfaces should be cleaned on a regular basis
with MOPARGlass Cleaner or any commercial
household-type glass cleaner. Never use an abrasive-type
cleaner. Use caution when cleaning the inside rear win-
dow equipped with electric defrosters, or the right rear
quarter window equipped with the radio antenna. Do
not use scrapers or other sharp instruments that may
scratch the elements. When cleaning the rear view mirror,
spray cleaner on the towel or rag that you are using. Do
not spray cleaner directly on the mirror.
Instrument Panel Cover
The instrument panel cover has a low glare surface,
which minimizes reflections in the windshield. Do not
use protectants or other products which may cause
undesirable reflections. Use soap and warm water to
restore the low glare surface.
Cleaning Plastic Instrument Cluster Lenses
The lenses in front of the instruments in this vehicle are
molded in clear plastic. When cleaning the lenses, care
must be taken to avoid scratching the plastic.
1. Clean with a wet soft rag. A mild soap solution may be
used, but do not use high alcohol content or abrasive
cleaners. If soap is used, wipe clean with a clean damp
rag.
2. Dry with a soft tissue.
7
MAINTAINING YOUR VEHICLE 339

CAUTION!
•When installing the Integrated Power Module
cover, it is important to ensure the cover is prop-
erly positioned and fully latched. Failure to do so
may allow water to get into the Integrated Power
Module, and possibly result in an electrical system
failure.
•When replacing a blown fuse, it is important to use
only a fuse having the correct amperage rating. The
use of a fuse with a rating other than indicated may
result in a dangerous electrical system overload. If
a properly rated fuse continues to blow, it indicates
a problem in the circuit that must be corrected.
VEHICLE STORAGE
If you will not be using your vehicle for more than
21 days, you may want to take steps to preserve your
battery.
•Disengage the mini-fuse in the Power Distribution
Center labeled IOD (Ignition Off-Draw).
•Disconnect the negative cable from the battery.
REPLACEMENT BULBS
LIGHT BULBS — InteriorBulb No.
Center Console Floor Lamp ................. T37
Climate Controls ...................... 6233137
Console Gear Selector ................... PC194
Dome Light (Sedan) ...................... T579
Instrument Cluster Illumination ............... 74
Overhead Reading Light (Overhead Console) . . . T1037
Overhead Reading Light (Rearview Mirror) .....T192
Rear Cargo ............................ T906
Visor Vanity ......................... 6501966
All the interior bulbs are brass or glass wedge base.
Aluminum base bulbs are not approved and should not
be used for replacement.
344 MAINTAINING YOUR VEHICLE

Odometer........................... 167
Tachometer .......................... 165
General Information ...............18,25,110,269
General Maintenance ..................... 312
Glass Cleaning .......................... 339
Gross Axle Weight Rating .................. 279
Gross Vehicle Weight Rating .............277,278
Hands-Free Phone (uconnect) ............... 82
Hazard Driving Through Flowing, Rising,
or Shallow Standing Water ............... 237
Hazard Warning Flasher ................... 292
Head Restraints ......................... 114
Headlights Bulb Replacement ...................... 345
Cleaning ............................ 338
High Beam .......................... 129
High Beam/Low Beam Select Switch ........ 129Passing
............................. 130
Heated Seats ........................... 114
Hitches Trailer Towing ........................ 281
HomeLink (Garage Door Opener) Transmitter . . . 136
Hood Release .......................... 123
Ignition ............................... 12
Key ................................ 12
Ignition Key Removal ..................... 12
Immobilizer (Sentry Key) .................15,19
Infant Restraint .......................... 62
Information Center, Vehicle ................. 178
Inside Rearview Mirror .................... 79
Instrument Cluster .................... 161,164
Instrument Panel and Controls .............. 160
Instrument Panel Cover ................337,339
Instrument Panel Lens Cleaning ............. 339
Integrated Power Module (Fuses) ............ 340
396 INDEX

Manual, Service......................... 385
Manual Transaxle .................. 224,226,334
Downshifting ......................... 229
Fluid Level Check ..................... 334
Frequency of Fluid Change ............... 334
Lubricant Selection ..................... 334
Map/Reading Lights ..................... 125
Master Cylinder (Brakes) .................. 329
Methanol ............................. 270
Mini-Trip Computer ...................... 174
Mirrors ................................ 79
Electric Remote ........................ 80
Outside .............................. 79
Rearview ............................. 79
Vanity ............................... 81
Modifications/Alterations, Vehicle ............. 7
Monitor, Tire Pressure System ............... 265
Mopar Parts ......................... 31 1,384New Vehicle Break-In Period
................ 70
Occupant Classification System (OCS) .......... 50
Occupant Restraints (Sedan) ................. 35
Octane Rating, Gasoline (Fuel) .............. 270
Odometer ............................. 167
Trip ............................. 167,169
Oil, Engine ......................... 312,349
Capacity ............................ 349
Change Interval ....................... 313
Checking ............................ 312
Disposal ............................ 315
Filter ............................... 316
Identification Logo ..................... 314
Materials Added to ..................... 315
Quality ............................. 314
Recommendation ................... 314,349
Synthetic ............................ 315
Viscosity ............................ 315
Oil Filter, Selection ....................... 316
10
INDEX 399