seat adjustment CHRYSLER PT CRUISER 2010 1.G User Guide

FRONT SEATS
WARNING!
Adjusting a seat while the vehicle is moving is dangerous. The sudden movement
of the seat could cause you to lose control. The seat belt might not be properly
adjusted, and you could be injured. Only adjust a seat while the vehicle is parked.
Manual Seat Adjustment
Forward/Rearward
• Lift up on the adjusting bar located at thefront of the seat near the floor and release
at the desired position.
Recliner
• Lift the recliner lever located on theoutboard side of the seat, lean back and
release at the desired position.
Lumbar Support
• The lumbar lever is on the inboard side ofthe seatback. Rotate the lumbar lever
downward to increase the lumbar support
or upward to decrease the lumbar support
as desired.
11
GETTING STARTED

Disclaimer:
• THE TIRE MANUFACTURER’SLIMITED WARRANTY PROGRAM, THE
DETAILS OF WHICH CAN BE FOUND,
ON THE OWNERS MANUAL DVD, THE
TIRE MANUFACTURER’S WEBSITE
OR AT ANY AUTHORIZED SERVICE
CENTER ARE IN LIEU OF ALL OTHER
REMEDIES OR WARRANTIES,
EXPRESS OR IMPLIED, ARISING BY
LAW OR OTHERWISE, INCLUDING
FITNESS FOR A PARTICULAR
PURPOSE OR MERCHANTABILITY.
THE TIRE MANUFACTURER
EXPRESSLY DISCLAIMS LIABILITY
FOR INDIRECT, SPECIAL,
INCIDENTAL OR CONSEQUENTIAL
DAMAGES, LOST PROFIT, LOSS OF
BUSINESS, LOSS OF GOODWILL,
LOSS OF REPUTATION, PUNITIVE OR
ANY OTHER DAMAGE, COST OR
LOSS OF ANY KIND. SOME STATES
AND PROVINCES DO NOT ALLOW
THE EXCLUSION OR LIMITATION OF
INCIDENTAL OR CONSEQUENTIAL
DAMAGES, SO THE ABOVE
LIMITATION OR EXCLUSION MAY
NOT APPLY TO YOU.
WARNING!
NOTE: Refer to the Owner’s Manual
on the DVD for complete warning
information that could prevent
accidents, injuries and even deaths.
WARNING!
Death, serious injury and/or
property damage may result from:
• Tire failure due to impact damageand/or improper maintenance.
(Continued)
WARNING!(Continued)
• Tires should be inspectedregularly by a qualified technician
for signs of damage, such as
punctures, impacts, under-
inflation or overloading.
• Progressive air loss may result from punctures, cuts, curbing,
impacts or partial bead unseating.
Some fitment causes for air loss
are:
• Incomplete bead seating.
• Bead tearing caused by a machine tool due to insufficient lubrication
or improper adjustment.
• Leaking valve core or rubber valve components (these should be
replaced when problems are
detected and whenever tires are
replaced).
• Tire failure due to improper repairs.
• See Rubber Manufacturer’s Association (RMA) established
repair procedures at www.rma.org
for information on proper repair
procedures. Never perform a
temporary repair or use an inner
tube as a substitute for a proper
repair. Only qualified persons
should repair tires.
• Explosion of tire/rim assembly due to improper mounting.
• Only specially trained persons should mount tires.
• Failure to mount tires on approved rims.
• Failure to deflate single or dual assemblies completely before
demounting.
51
CONSUMER ASSISTANCE