Convertible top CHRYSLER SEBRING CONVERTIBLE 2008 3.G User Guide

CAUTION!
²Do not operate the Power Top when the vehicle is in motion.
²Do not operate the Power Top with the hydraulic pump
valve open.
²Do not allow the top to remain in the suspended position.
After approximately 10 minutes in the suspended position,
the hydraulic pressure will release, which will allow the top
and the trunk lid to lower. Pressing the Power Top switch
will cancel this operation.
²Always use a normal ice scraper to remove snow or ice from
the rear window. Use of a sharp object or other tools could
scratch the fabric or panels when removing snow or ice.
²Always close the top when leaving your vehicle so as not to
leave the interior exposed to potentially damaging outdoor
conditions.
²Do not leave the top lowered for several weeks at a time.
Close it occasionally to prevent discoloration in the folds of
the fabric and to allow the creases to smooth out. This is
especially important if the top was stowed when not com-
pletely dry.
Failure to follow these cautions can cause damage to the convert-
ible top components, trunk contents, and the vehicle interior.
WARNING!
²Before operating the Power Top, make sure that no moving
parts of the convertible top can injure a person or animal.
²Never place any extremities (hands, feet, etc.) near the
convertible top components, the upper windshield area, the
shelf area behind the rear seats, or the convertible top
stowage area while raising or lowering the convertible top.
²When using the Power Top button on RKE transmitter, if
potential danger exists while lowering the top, release the
button immediately to interrupt the operation.
²When using the Power Top switch on the instrument panel,
if potential danger exists while lowering the top, press and
release the switch immediately to interrupt the operation.
²When using the Power Top switch on the instrument panel,
if potential danger exists while raising the top, release the
switch immediately to interrupt the operation.
²
Only drive the vehicle with the convertible top completely closed
and latched or fully lowered into its stowage compartment.
²Do not operate the Power Top when the vehicle is in motion.
Failure to follow these warnings can result in injuries that are
serious or fatal to you, your passengers, and others around you. 84 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Cargo Protector
The cargo protector is located in the trunk. Before low-
ering the convertible top, you must unfold the cargo
protector and seat the tabs at each end of the cargo
protector in the V slots in the trunk liner. Doing so closes
a switch that allows top operation. If the switch is not
closed, a warning message displays in the instrument
cluster to notify the driver.
Positioning the Cargo Protector for Top Operation
Pull the cargo protector toward you to begin unfolding
the panels. Grasp the handle in the center of the outer-
most (top) panel and raise the cargo protector. Then,
align and seat the tabs at each end of the cargo protector
in the V slots in the trunk liner as shown in the illustra-
tion.
Cargo Protector
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 85
3

Power Convertible Top Controls
The Power Top switch is located on the instrument panel
to the left of the steering column.There is also a Power Top button on the Remote Keyless
Entry (RKE) Transmitter for remotely lowering the power
convertible top.
Power Top SwitchPower Top Button
86 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Lowering the Power Convertible Top
Using the Power Top Switch
NOTE:The Power Top switch will operate when the
ignition switch is turned to the ON or ACC position and
when in the power accessory delay.
There are two Top Down switch positions.
Press the switch to the first detent and release
it. The system will lower all fully raised win-
dows approximately 0.5 inches (10 mm), lower
the top to its fully retracted position, and then raise the
windows. Press the switch to the second detent and
release it. The system will lower all four windows and the
top to their fully retracted positions.
Using the Remote Keyless Entry (RKE) Transmitter
1. Press and release the Unlock button.
2. Press, release, then press, and hold the
Power Top button down until the operation of
lowering the top and all four windows to their
fully retracted positions is complete.
NOTE:If you release the Power Top button before fully
retracting the top, you must repeat steps 1 and 2 above to
resume lowering the top.
Raising the Power Convertible Top
Using the Power Top Switch
NOTE:The Power Top switch will operate when the
ignition switch is turned to the ON or ACC position and
when in the power accessory delay.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 87
3

Press and hold the switch in the Top Up
position until the operation of raising the top
and latching it is complete, which is indicated
by the system raising the windows and dis-
playing ªTOP DONEº in the odometer or ªCONVERT-
IBLE TOP COMPLETEº in the EVIC (if equipped).
Using the Remote Keyless Entry (RKE) Transmitter
You cannot use the Power Top button on the RKE
transmitter to raise the power convertible top. You must
use the Power Top switch inside the vehicle to perform
this operation.
Manually
Closing the power convertible top manually is a compli-
cated and physically demanding procedure, and it re-
quires a special tool to do so. In the event that you
experience a malfunction when operating the power
convertible top:1. Read all of the Notes, Cautions, and Warning found
under ªPower Convertible Top Usage Precautionsº to
verify all operating conditions are met.
2. Check for Operation and Warning Messages as de-
scribed under ªPower Convertible Top Operation &
Warning Messages.º If applicable, perform the related
action to correct the condition present.
3. If Steps 1 and 2 do not resolve the problem, see your
authorized dealer for service.
Wind Stop
The Wind Stop installs in the backseat area of the vehicle.
The Wind Stop will not interfere with power top opera-
tion. Therefore, it can remain installed when the top is up.
However, when not in use, the Wind Stop folds to allow
for convenient storage underneath the cargo protector in
the trunk.
88 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Removing & Storing the Wind Stop
Reverse the installation procedure to remove, fold, and
store the Wind Stop. However, note the following before
doing so:
²Disengage the pivot lock (1) to fold the small frame flat
onto the large frame. Disengage the frame lock (2) to
disconnect the small frame from the large frame.
Power Convertible Top Operation & Warning
Messages
When the appropriate conditions exist, the PTCM dis-
plays various power convertible top operation and warn-
ing messages in the Electronic Vehicle Information Center
(EVIC) ± if equipped, or in the Odometer for vehicles not
equipped with the EVIC. Refer to the following chart for
message related information:
92 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

LIf so equipped.
LLFor vehicles not equipped with the EVIC.
LLLThe PTCM will LOCKOUT the power convertible top system if the vehicle charging system is malfunc-
tioning, or the battery is run down, or the hydraulic pump is overheating. In addition, the system prohibits low-
ering the top when ambient temperature is at 0ÉF (-18ÉC) or lower and raising the top when ambient temperature
is below -40ÉF (-40ÉC).
²If you are trying to lower the top and ambient temperature is 0ÉF (-18ÉC) or lower, wait until the temperature
rises and the top is thawed and dry before operating the Power Top.
²If you are trying to raise the top and ambient temperature is below -40ÉF (-40ÉC), wait until the temperature
rises before operating the Power Top.
²If the vehicle charging system is malfunctioning, see your authorized dealer for service.
²If the battery is run down, have it recharged and tested at your authorized dealer.
²Hydraulic pump overheating can occur if you lower and raise the top consecutively (usually more than six or
seven times depending upon the ambient temperature). Wait at least 5 minutes before operating the Power Top
again.NOTE:If LOCKOUT occurs due to hydraulic pump overheating, the system will allow you to raise the top
without waiting 5 minutes. However, do so only if necessary.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 95
3

²In a convertible vehicle, system performance may be
compromised with the convertible top down.
Far End Audio Performance
²
Audio quality is maximized under:
²low-to-medium blower setting,
²low-to-medium vehicle speed,
²low road noise,
²smooth road surface,
²fully closed windows,
²dry weather condition, and
²operation from driver seat.
²Performance, such as audio clarity, echo, and loudness
to a large degree rely on the phone and network, and
not the UConnecttsystem.
²Echo at the far end can sometimes be reduced by
lowering the in-vehicle audio volume.
²In a convertible vehicle, system performance may be
compromised with the convertible top down.
BluetoothtCommunication Link
Cellular phones have been found to lose connection to
the UConnecttsystem. When this happens, the connec-
tion can generally be re-established by switching the
phone off/on. Your cell phone is recommended to remain
in Bluetootht9ON9mode.
Power-Up
After switching the ignition key from OFF to either ON
or ACC position, or after a language change, you must
wait at least five seconds prior to using the system.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 119
3

²RKE (Remote Keyless Entry) Battery Low (with a
single chime)
²Personal Settings Not Available ± Vehicle Not in Park.
²Left/Right Door Ajar (one or more, with a single
chime if speed is above 1 mph)
²Door(s) Ajar (with a single chime if vehicle is in
motion)
²Trunk Ajar (with a single chime)
²Headlights On
²Key In Ignition
²Convertible Top In Operation (with a single chime)
²Convertible Top Complete (with a single chime)
²Secure Cargo Shield (with a single chime)
²Speed Too High (with a single chime)
²Convertible Top Malfunction (with a single chime)
²Oil Change Required (with a single chime)
Oil Change Required
Your vehicle is equipped with an engine oil change
indicator system. The ªOil Change Requiredº message
will flash in the EVIC display for approximately 10
seconds after a single chime has sounded to indicate the
next scheduled oil change interval. The engine oil change
indicator system is duty cycle based, which means the
engine oil change interval may fluctuate dependent upon
your personal driving style.
Unless reset, this message will continue to display each
time you turn the ignition switch to the ON/RUN
position. To turn off the message temporarily, press and
release the Menu button. To reset the oil change indicator
system (after performing the scheduled maintenance)
perform the following procedure:
UNDERSTANDING YOUR INSTRUMENT PANEL 189
4

NA/C Air Filter Ð If Equipped............370
NPower Steering Ð Fluid Check............371
NFront Suspension Ball Joints..............372
NSteering Linkage......................372
NBody Lubrication.....................372
NWindshield Wiper Blades................373
NWindshield Washers...................374
NExhaust System......................374
NCooling System.......................375
NHoses And Vacuum/Vapor Harnesses.......381
NFuel System.........................381
NBrake System........................381
NAutomatic Transaxle...................384NFront And Rear Wheel Bearings...........387
NAppearance Care And Protection
From Corrosion......................387
NCleaning The Center Console Cup Holders . . . 392
mConvertible Top Care....................393
NSoft Top............................393
NWeather Strip Care Ð Soft & Hard Top......395
mFuses (Totally Integrated Power Module)......395
mVehicle Storage........................400
mReplacement Bulbs......................400
mBulb Replacement......................401
NLow Beam Headlight, High Beam Headlight . . 401
NFront Turn Signal/Park Light.............402
352 MAINTAINING YOUR VEHICLE