lock CHRYSLER SEBRING CONVERTIBLE 2008 3.G Service Manual

Removing & Storing the Wind Stop
Reverse the installation procedure to remove, fold, and
store the Wind Stop. However, note the following before
doing so:
²Disengage the pivot lock (1) to fold the small frame flat
onto the large frame. Disengage the frame lock (2) to
disconnect the small frame from the large frame.
Power Convertible Top Operation & Warning
Messages
When the appropriate conditions exist, the PTCM dis-
plays various power convertible top operation and warn-
ing messages in the Electronic Vehicle Information Center
(EVIC) ± if equipped, or in the Odometer for vehicles not
equipped with the EVIC. Refer to the following chart for
message related information:
92 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

EVIC
MessageLEVIC
Message
Display
TimeLOdometer
Message
(< 5 mph
[8 km/h])LLOdometer
Message
Display
TimeLLOdometer
Message
(> 5 mph
[8 km/h])LLOdometer
Message
Display
TimeLLChime ConditionOperator
Action
Required
SPEED TOO
HIGH9 Seconds SPEED TOO
HIGHDisplay Scrolls
for 9 SecondsTOP 6 Seconds Single
ChimeYou Are Operat-
ing the Power
Top at a Vehicle
Speed Greater
Than 0 mph (0
km/h)The Top Will
Not Operate
Unless the Ve-
hicle is Station-
ary.
TRUNK
AJARContinu-
ousDECK Continuous DECK Continuous Single
ChimeThe Trunk Lid is
Unlatched or
OpenThe Top Will
Not Operate
Unless the
Trunk Lid is
Closed
CONVERT-
IBLE TOP
MALFUNC-
TION6 Seconds TOP FAIL Display Scrolls
for 6 SecondsTOP 6 Seconds Single
ChimeThe PTCM Acti-
vated the System
LOCKOUT Fea-
tureRefer to Foot
NoteLLL
CONVERT-
IBLE TOP
MALFUNC-
TIONUntil Fault
is No
Longer De-
tected or
RepairedTOP FAIL Display Scrolls
until Fault is
No Longer De-
tected or Re-
pairedTOP Display
Flashes un-
til Fault is
No Longer
Detected or
RepairedSingle
ChimeThe PTCM Acti-
vated the System
LOCKOUT Fea-
tureSee your au-
thorized dealer
for service
94 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

LIf so equipped.
LLFor vehicles not equipped with the EVIC.
LLLThe PTCM will LOCKOUT the power convertible top system if the vehicle charging system is malfunc-
tioning, or the battery is run down, or the hydraulic pump is overheating. In addition, the system prohibits low-
ering the top when ambient temperature is at 0ÉF (-18ÉC) or lower and raising the top when ambient temperature
is below -40ÉF (-40ÉC).
²If you are trying to lower the top and ambient temperature is 0ÉF (-18ÉC) or lower, wait until the temperature
rises and the top is thawed and dry before operating the Power Top.
²If you are trying to raise the top and ambient temperature is below -40ÉF (-40ÉC), wait until the temperature
rises before operating the Power Top.
²If the vehicle charging system is malfunctioning, see your authorized dealer for service.
²If the battery is run down, have it recharged and tested at your authorized dealer.
²Hydraulic pump overheating can occur if you lower and raise the top consecutively (usually more than six or
seven times depending upon the ambient temperature). Wait at least 5 minutes before operating the Power Top
again.NOTE:If LOCKOUT occurs due to hydraulic pump overheating, the system will allow you to raise the top
without waiting 5 minutes. However, do so only if necessary.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 95
3

Use the hood prop rod to secure the hood in the open
position. Place the upper end of the prop rod in the hole
on the underside of the hood.
Before closing the hood, make sure to stow the prop rod
in its proper location. To prevent possible damage, do notslam the hood to close it. Use a firm downward push at
the center of the hood to ensure that both latches engage.
WARNING!
If the hood is not fully latched, it could fly up when
the vehicle is moving and block your forward vision.
You could have a collision. Be sure all hood latches
are fully latched before driving.
LIGHTS
Exterior & Interior Lighting Control
The Multi-Function Control Lever on the left side
of the steering column controls the operation of
the headlights, parking lights, turn signal lights,
instrument panel lights, instrument panel light dimming,
interior lights, and fog lights (if equipped).
Hood Prop Rod Hole Location
138 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Headlights & Parking Lights
Turn the end of the Multi-Function Control Lever to the
first detent for parking light operation. Turn the end of
the lever to the second detent for headlight operation.
Automatic Headlights Ð If Equipped
This system automatically turns the headlights ON or
OFF according to ambient light levels. To turn the system
ON, turn the end of the Multi-Function Control Lever to
the (A) AUTO position (third detent). When the system is
ON, the Headlight Time Delay feature is also ON. This
means the headlights will stay ON for up to 90 seconds
after you turn the ignition switch to the LOCK position.
To turn the Automatic System OFF, turn the end of the
Multi-Function Control Lever out of the (A) position.
NOTE:The engine must be running before the head-
lights will turn ON in the Automatic mode.
Headlights with Wipers (Available with Auto
Headlights Only)
When this feature is active, the headlights will turn ON
approximately 10 seconds after the wipers are turned on
if the Multi-Function Control Lever is placed in the (A)
Headlight Switch
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 139
3

AUTO position. In addition, the headlights will turn OFF
when the wipers are turned off if they were turned on by
this feature.
The Headlights with Wipers feature can be turned on or
off through the Electronic Vehicle Information Center
(EVIC) Ð if equipped. For details, refer to ºHeadlights
with Wipers,º under ªPersonal Settings (Customer Pro-
grammable Features),º under ªElectronic Vehicle Infor-
mation Centerº in Section 4 of this manual.
Headlight Time Delay Ð If Equipped
This feature is particularly useful when exiting your
vehicle in an unlit area. It provides the safety of headlight
illumination for about 90 seconds after turning the igni-
tion switch to the LOCK position.
To activate the delay, turn the ignition switch to the
LOCK position while the headlights are still on. Then,
turn off the headlights within 45 seconds. The delayinterval begins when you turn off the headlights. Only
the headlights will illuminate during this time.
If you turn the headlights, parking lights, or ignition
switch on again, the system will cancel the delay.
If you turn the headlights off before the ignition, they will
turn off in the normal manner.
The Headlight delay time is programmable on vehicles
equipped with the Electronic Vehicle Information Center
(EVIC). For details, refer to ªHeadlights Off Delay,º
under ªPersonal Settings (Customer Programmable Fea-
tures),º under ªElectronic Vehicle Information Center
(EVIC)º in Section 4 of this manual.
Daytime Running Lights (DRL) Ð If Equipped
The high beam headlights will turn on as Daytime
Running Lights (DRL) and operate at DRL (lower) inten-
sity, whenever the ignition is on, the engine is running,
140 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

the headlight switch is off, the parking brake is off, the
turn signal is off, and the selector lever is in any position
except ªPº (Park).
NOTE:The Daytime Running Lights will turn off
automatically when the turn signal is in operation and
turn on again when the turn signal is not operating.
Lights-On Reminder
If the headlights or parking lights are on after the ignition
is turned to the LOCK position, a chime will sound to
alert the driver when the driver's door is opened.
Fog Lights Ð If Equipped
To activate the front fog lights, turn on the parking
lights or the low beam headlights and pull out on
the end of the Multi-Function Control Lever.NOTE:The front fog lights will only operate with the
headlights on low beam. Selecting high beam headlights
will turn off the front fog lights.Front Fog Light Control
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 141
3

Interior Lights
Two courtesy/reading lights are located in the bottom of
the rearview mirror. You can turn these lights on and off
from the switches in the mirror or from the Dimmer
Control in the Multi-Function Lever. These lights are also
controlled automatically by the illuminated entry system.A courtesy light is also found in the rear of the center
console. You can turn this light on and off from the
dimmer control in the Multi-Function Lever. This light is
also controlled automatically by the illuminated entry
system.
Battery Saver Feature
To protect the battery, the interior lights will turn off
automatically 10 minutes after the ignition switch is
moved to the LOCK position. This will occur if the
interior lights were switched on manually or are on
because a door is open.
Dimmer Control
The Dimmer Control is part of the Multi-Function Con-
trol Lever. It controls the operation of the interior lights
and the brightness of the instrument panel lights.
1 Ð Left Lamp 3 Ð Right Lamp Switch
2 Ð Left Lamp Switch 4 Ð Right Lamp 144 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

WARNING!
Commercially available windshield washer solvents
are flammable. They could ignite and burn you. Care
must be exercised when filling or working around
the washer solution.
TILT/TELESCOPING STEERING COLUMN
This feature allows you to tilt the steering column
upward or downward. It also allows you to lengthen or
shorten the steering column. The tilt/telescoping control
handle is located below the steering wheel at the end of
the steering column.To unlock the steering column, push the control handle
downward. To tilt the steering column, move the steering
wheel upward or downward as desired. To lengthen or
shorten the steering column, pull the steering wheel
outward or push it inward as desired. To lock the steering
column in position, pull the control handle upward until
fully engaged.
150 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

WARNING!
Do not adjust the steering wheel while driving. The
tilt/telescoping adjustment must be locked while
driving. Adjusting the steering wheel while driving
or driving without the tilt/telescoping adjustment
locked could cause the driver to lose control of the
vehicle.
ELECTRONIC SPEED CONTROL Ð IF EQUIPPED
When engaged, this device takes over the accelerator
operation at speeds greater than 25 mph (40 km/h).
Electronic Speed Control Operation
The Speed Control Lever is located on the right side of
the steering wheel.
To Activate:
Push and release the ONOFF button located on
the end of the Speed Control Lever. The
CRUISE indicator in the instrument cluster will
illuminate. To turn the system OFF, push and
Speed Control Location
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 151
3