ABS Citroen BERLINGO 2005 1.G User Guide
[x] Cancel search | Manufacturer: CITROEN, Model Year: 2005, Model line: BERLINGO, Model: Citroen BERLINGO 2005 1.GPages: 462, PDF Size: 10.48 MB
Page 410 of 462
Downloaded from www.Manualslib.com manuals search engine 404
BRAKES
B3FP7E2D
ABS/ESP HYDRAULIC BLOCK
Components Supplier Type Observations
Hydraulic blockBOSCHABS REF 8.0
Installed under the front LH
ESP 8.0chassis member. 4 regulation channels.
The emergency braking control is incorporated in the primary piston at «a».
B3FP7E3C
C4
Angl.-t2-PAGE398-427-2005 9/01/06 10:24 Page 404
Page 413 of 462
Downloaded from www.Manualslib.com manuals search engine 407
BRAKES
B3FP7ESD
BLEEDING AND FILLING THE BRAKING SYSTEM
Disconnect the connector «b».
Uncouple the pipe (5).
Remove the reservoir (6), moving aside the tabs «c»of the pins (7).
Clean the brake fluid reservoir (4) and the brake fluid reservoir (6).
Refit the brake fluid reservoir (6).
Couple the pipe (5).
Reconnect the connector «b».
Couple the clickfit union, at «a».
Refit:
- The brake fluid reservoir (4).
- The screws (1).
- The filter of the brake fluid reservoir.
- The battery tray.
- The screws (3).
- The battery.
Reconnect the battery.
IMPERATIVE: Carry out the operations that are necessary following a reconnection of the
battery
(see corresponding operation).
B3FP7ERC
C4
Angl.-t2-PAGE398-427-2005 9/01/06 10:24 Page 407
Page 414 of 462
Downloaded from www.Manualslib.com manuals search engine 408
BRAKES
B3FP7EUC
BLEEDING AND FILLING THE BRAKING SYSTEM
Filling the braking circuit.
WARNING: Use only the approved and recommended hydraulic fluids.
IMPERATIVE: Only use new brake fluid that has not emulsified; avoid any introduction of
impurities into the hydraulic circuit.
Fill the brake fluid reservoir (4).
Bleeding the primary braking circuit.
WARNING: During the bleed operations: take care to maintain the level of the brake fluid
in the reservoir, keep it topped up.
WARNING: The ABS system must not be in action during the bleed operation.
WARNING: Respect the sequence for the opening of the bleed screws.
Front brake caliper : Bleed screw (8).
Rear brake caliper : Bleed screw (9).
Bleed each brake caliper, proceeding in the following sequence:
- Front LH wheel.
- Front RH wheel.
- Rear LH wheel.
- Rear RH wheel.
B3FP7ETC
C4
Angl.-t2-PAGE398-427-2005 9/01/06 10:24 Page 408
Page 416 of 462
Downloaded from www.Manualslib.com manuals search engine 410
BRAKESBLEEDING AND FILLING THE BRAKING SYSTEM
Bleeding the braking circuit without the bleed apparatus.
NOTE:Two operators are necessary.
For each brake circuit:
- Apply the brake pedal to place the circuit under pressure.
- Couple a transparent tube on the bleed screw.
- Submerge the other end of the tube in a clean container.
- Open the bleed screw.
- Wait until the fluid flows out without air bubbles.
- Close the bleed screw.
NOTE:Recommence the process a second timeif that is necessary.
Check the level of the brake fluid
(between the «DANGER»level and
the «MAXI»level).
Fill if necessary with the the approved and recommended synthetic
brake fluid.Bleeding the secondary braking circuit.
WARNING: During the bleed operations: take care to maintain the
level of the brake fluid in the reservoir, keep it topped up.
NOTE:The bleed apparatus [1]is still connected on the brake fluid
reservoir (4).
Use the diagnostic tools [2]or [3].
Select the menu corresponding to the vehicle:
- ABSmenu
(according to equipment).- ESPmenu (according to equipment).
Follow the instructions of the diagnostic tool.
At the end of the bleed programme, check the level of the brake fluid,
top up if necessary.
Check the travel of the brake pedal: it must not be excessive. If it is,
restart the bleed procedure.
C4
Angl.-t2-PAGE398-427-2005 9/01/06 10:24 Page 410
Page 417 of 462
Downloaded from www.Manualslib.com manuals search engine 411
BRAKES
Without ABS 23,8 (expansion holes)With ABS 23,8 (valve)
228,6
BOSCH 54 LUCAS 57 BOSCH 54
266 283 266
22 / 20
FERF 769 ASFM 380 FERF 769
13 / 2
228 / 230 228 / 230
247 247
8 / 6 8 / 6
JURID
E 558 519 E 558 519
BOSCH/Load-sensitive compensator
32
0,3 - White
BRAKE SPECIFICATIONS
Estates
TU3JP TU5JP4 EW10J4 DW8 DV4TD DW10TDDW10
ATED
FTØ
mmMaster cylinder
Amplifier
Caliper makes/pistons
Disc
Disc thickness/min. thicknessVentilated
Brake pad grade
Thickness/min. thickness
RRØ
mmDrum - Ø min./max.
Disc non-ventilated
Make
Brake lining grade
Make/type
Cut-off pressure in bars
Ramp/paint reference
Disc thickness/min. thickness
XSARA
Angl.-t2-PAGE398-427-2005 9/01/06 10:24 Page 411
Page 418 of 462
Downloaded from www.Manualslib.com manuals search engine 412
BRAKES
ABS/ESP HYDRAULIC BLOCK XSARA
Braking system specifications
- 'X'braking circuit.
- Front: disc brakes, ventilated
(according to model).
- Rear: drum brakes with automatic adjustment.
- Cable operated handbrake acting on the rear wheels.
(1)Hydraulic valve block «ABS Bosch 5.3»or
(1)Hydraulic valve block «ABS Bosch 5.3 REF»or
(1)Hydraulic valve block «ABS with ESP Bosch 5.7».
(2)Load sensitive braking compensator
(according to model).
B3FP09HC
B3FP09JC
2
1
Angl.-t2-PAGE398-427-2005 9/01/06 10:24 Page 412
Page 421 of 462
Downloaded from www.Manualslib.com manuals search engine 415
BRAKESBraking system without ABS (rear drum brakes) Braking system without ABS (rear disc brakes)
BRAKE SPECIFICATIONSXSARA
B3FP14GDB3FP14FD
Angl.-t2-PAGE398-427-2005 9/01/06 10:24 Page 415
Page 422 of 462
Downloaded from www.Manualslib.com manuals search engine 416
BRAKES
Braking system with ABS (rear drum brakes)
BRAKE SPECIFICATIONS
B3FP14HD
XSARA
Angl.-t2-PAGE398-427-2005 9/01/06 10:24 Page 416
Page 423 of 462
Downloaded from www.Manualslib.com manuals search engine 417
BRAKESBraking system with ABS REF (rear disc brakes)Braking system with ABS REF (rear drum brakes)
BRAKE SPECIFICATIONS
B3FP14JDB3FP14KD
XSARA
Angl.-t2-PAGE398-427-2005 9/01/06 10:24 Page 417
Page 424 of 462
Downloaded from www.Manualslib.com manuals search engine 418
BRAKES
Braking system with ABS REF (rear drum brakes)
BRAKE SPECIFICATIONS
B3FP14LD
XSARA
Angl.-t2-PAGE398-427-2005 9/01/06 10:24 Page 418