check engine Citroen BERLINGO MULTISPACE 2015 2.G Owner's Guide

278
Berlingo-2-VP_en_Chap10b_Rd45_ed01-2015
The table below gives answers to the most frequently asked questions on your audio system.
Q UESTION ANSWER SOLUTION
With the engine off, the
audio
  system   switches   off  
a

fter   a   few   minutes   of   use.When
  the   engine   is   switched   off,   the   audio   system   operating   time  
d

epends   on   the   state   of   charge   of   the   battery.
The
  switch-off   is   normal:   the   audio   equipment   switches   to   economy  
m

ode   and   switches   off   to   prevent   discharging   of   the   vehicle's  
b

attery. Start the vehicle's engine to increase the battery
charge.
The
  message   "the   audio  
s

ystem   is   overheated"  
a

ppears   on   the   display.In
  order   to   protect   the   installation   if   the   surrounding   temperature  
i

s   too   high,   the   audio   system   switches   to   an   automatic   thermal  
p

rotection   mode   leading   to   a   reduction   in   volume   or   CD   play  
s

topping. Switch
  the   audio   system   off   for   a   few   minutes   to  
a

llow   the   system   to   cool.
Frequently asked questions
QUESTIONANSWER SOLUTION
There is a difference in
sound quality between the
different audio sources
(radio,
 C

D...). For
  optimum   sound   quality,   the   audio   settings   (Volume,   Bass,  
T

reble,   Ambience,   Loudness)   can   be   adapted   to   the   different   sound  
s

ources,   which   may   result   in   audible   differences   when   changing  
s

ource   (radio,   CD...). Check
  that   the   audio   settings   (Volume,   Bass,  
T

reble,   Ambience,   Loudness)   are   adapted   to  
t

he   sources   listened   to.   It   is   advisable   to   set  
t

he audio functions (Bass, Treble, Front-Rear
Balance,
  Left-Right   Balance)   to   the   middle  
p

osition,   select   the   musical   ambience   "None"  
a

nd set the loudness correction to the "
ac
tive"
position
  in   CD   mode   or   to   the   "Inactive"   position  
i

n   radio   mode.
Radio
audio and Telematics

160


Fuel


FUEL CUT-OFF

In a serious collision, a mechanism
automatically prevents fuel from
reaching the engine.
The fl ashing of this warning
lamp is accompanied by a
message in the screen.
Check that there is no odour or
leakage of fuel outside the vehicle and
re-establish the fuel supply:


- switch off the ignition (STOP
position),

- remove the key,

- put the key back in the ignition,

- switch on the ignition and start.





DIESEL PRIMING PUMP


If you run out of fuel, it is necessary to
prime the fuel circuit.


- Fill the fuel tank with at least fi ve
litres of Diesel.

- Squeeze and release the manual
priming pump, under the bonnet,
under the protective cover.

- Operate the starter until the engine
starts.




- Fill the fuel tank with at least fi ve
litres of Diesel.

- Switch on the ignition (without
starting the engine).

- Wait around 6 seconds and switch
off the ignition.

- Repeat the operation 10 times.

- Operate the starter to run
the engine.









BlueHDi engine