boot Citroen BERLINGO MULTISPACE 2016 2.G Owner's Manual

17
Motoring & the Environment
Berlingo-2-VP_en_Chap02_eco-conduite_ed01-2016
Limit the causes of excess
consumption
Spread loads throughout the vehicle;
place  the   heaviest   items   in   the   bottom  
of the boot, as close as possible to
the

  rear   seats.
Limit
  the   loads   carried   in   the  
vehicle and reduce wind resistance
(roof

  bars,   roof   rack,   bicycle  
carrier

,   trailer...).   Use   a   roof   box   in  
preference.
Remove

  roof   bars   and   roof   racks  
after

  use.
At
  the   end   of   winter,   remove   snow  
tyres

  and   refit   your   summer   tyres.
Observe the recommendations
on maintenance
Check the tyre pressures regularly, when cold, referring to the label in the
door  aperture,   driver's   side.
Carry
  out   this   check   in   particular:
-
 
before
  a   long   journey,
-

at each change of season,
-

 
after
  a   long   period   out   of   use.
d

on't forget the spare wheel and the
tyres
  on   any   trailer   or   caravan.
Have your vehicle serviced regularly
(engine
  oil,   oil   filter,   air   filter,   passenger  
compartment

  filter...)   and   observe   the  
schedule

  of   operations   recommended  
in

  the   manufacturer's   service   schedule.
With a BlueH
d i d iesel engine, if the
SCR
  system   is   faulty   your   vehicle  
becomes

  polluting;   go   to   a   CITROËN  
dealer

  or   a   qualified   workshop   without  
delay

  to   have   the   emissions   of   nitrous  
oxides

  brought   back   to   the   legal   level.When refuelling, do not continue after
the third cut-off of the nozzle to avoid
any
  overflow.
a

t the wheel of your new vehicle,
it
  is   only   after   the   first   1   800   miles  
(3 000

  kilometres)   that   you   will   see  
the

  fuel   consumption   settle   down   to   a  
consistent

  average.
2
ECO-DRIVING

76
Berlingo-2-VP_en_Chap04_Ergonomie_ed01-2016
DEMISTING AND DEFROSTING
G
OOD PRACTICE
V

ents
"Leave them open"
For
  optimum   distribution   and   diffusion  
of hot or cool air in the passenger
compartment,

  there   are   adjustable  
central and side vents which can
be directed sideways (right or left)
or

  vertically   (up   or   down).   For   your  
comfort

  while   driving,   do   not   close  
them

  and   direct   the   flow   of   air   towards  
the

  windows   instead.
a

ir vents in the footwells and directed
towards
  the   windscreen   complete   the  
equipment.
Do

  not   block   the   vents   located   at   the  
windscreen or the air extractor located
in

  the   boot.
Dust filter, odour filter
(activated carbon)
This filter traps certain dust and limits odours.
Ensure   that   this   filter   is   in   good  
condition

  and   have   all   of   the   filter  
elements

  replaced   regularly.
Refer
  to   the   "Checks"   section   of  
chapter

  7.
Air conditioning
In all seasons, the air conditioning
should only be used with the
windows  closed.   However,   if   the  
interior

  temperature   remains   high  
after

  a   prolonged   period   parked   in  
the

  sun,   first   ventilate   the   passenger  
compartment

  for   a   few   minutes.
Use
  the  
AUT
O   mode   as   much   as  
possible

  as   it   permits   optimised  
control

  of   all   of   the   functions:   air   flow,  
passenger

  compartment   comfort  
temperature,

  air   distribution,   air  
intake

  mode   or   air   recirculation   in   the  
passenger

  compartment.
Operate
  the   air   conditioning   system   for  
5

 
to
 
10
 
minutes,
 
once
 
or
 
twice
 
a
 
month,
 
to

  keep   it   in   good   working   order.
If
  the   system   does   not   produce   cold   air,  
do not use it and contact a CITR

o Ë n
dealer
  or   a   qualified   workshop.
Automatic mode: visibility
programme
The
 
comfort
 
programme
 
(AUTO)
 
may
 
not

 
be
 
sufficient
 
to
 
quickly
 
demist
 
or
 
defrost

 
the
 
windows
 
(humidity,
 
several
 
passengers,

 
ice).
In this case, select the visibility
programme.
 
The

 
visibility
 
programme
 
indicator

 
comes
 
on.
It activates the air conditioning, the air
flow
 
and
 
provides
 
optimum
 
distribution
 
of the ventilation to the windscreen and
side

 
windows.
It
 
deactivates
 
the
 
air
 
recirculation. It
  is   normal   that   the   condensation  
created

  by   the   air   conditioning   system  
results

  in   a   flow   of   water   which   may  
form

  a   puddle   under   the   vehicle   when  
parked.
Ventilation

 99
Berlingo-2-VP_en_Chap04_Ergonomie_ed01-2016
From insideFrom outside
Rear box
This roof box can be accessed from the
  rear   seats   and   the   boot.
From
  the   rear   seats,   slide   the   flaps   to  
open.
Vents
a 3-position control allows you to
adjust   the   air   flow   through   the   vents.
The
  vents   are   also   fitted   with   a   scented  
air

  freshener.
From
 
the
 
boot,
 
place
 
your
 
thumb
 
on
 the recess then pull the handle to
open.
Open
 
carefully
 
to
 
prevent
 
objects
 
stored

 
in
 
this
 
interior
 
roof
 
box
 
from
 
fallin

g
 
out.
The
 
maximum
 
authorised
 
load
 
is
 
10
 
kg.
EASE OF USE and COMFORT
4
Practical information

105
Berlingo-2-VP_en_Chap04_Ergonomie_ed01-2016
LOAD SPACE COVER (5 SEAT VERSION)
This rigid shelf conceals the objects stored  in   the   boot. Removing
Fold
  the   load   space   cover.
Detach   it   from   the   notches   A and B
pulling
  it   towards   you.
Raise
  it   and   remove   the   assembly.
Refitting
Place the load space cover in front
of A and B.
Push it forwards to insert the lugs in
the
  notches.
Unfold and clip into the notches C.
Folding
From
  the   boot,   fold   the   half-shelf,  
raising

  it   to   detach   it   from   the   notch   C. Storing (according to version)
A 
location   is   provided   in   the   back   of   the  rear
  seats   to   accommodate   the   load  
space

  cover   folded   onto   itself.
Slide it vertically between the side
guides
  located   at   mid   seat   back   height.
Insert
  the   hinge   first,   with   the   free   flaps  
turned

  upwards.
This rigid load space cover can
form
  a   shelf.   However,   as   a   safety  
measure,

  do   not   place   objects  
on

  it   which   could   become   dangerous  
projectiles

  in   the   event   of   sharp   braking  
or

  rear   impact.
EaSE oF USE and CoMFoRT
4
Practical information

108
Berlingo-2-VP_en_Chap04_Ergonomie_ed01-2016
Storage flaps
Raise the corresponding flap.next to the boot sill, the recess is
intended to receive the roller tube
containing
  the   load   space   cover.
Seat belts
Ensure that the centre seat belt has
reeled in correctly to its carrier in the
roof.
Prevent
  the   row   3   seat   belt   buckles  
from

  knocking   by   raising   them   as   close  
as possible to the anchorages in the
roof.
The

  seat   belt   buckle   attachment   rings  
on

  each   side   of   the   boot   must   not   be  
used

  to   retain   loads.
Practical information

 109
Berlingo-2-VP_en_Chap04_Ergonomie_ed01-2016
BLIND, LOAD SPACE COVER
Position the load space screen so as to
present  the   rear   load   space   cover   flaps  
towards

  you.
Engage the left-hand lug of the roller in
the support A.
The load space cover is the roller blind
type.
 
T

ake
 
care
 
not
 
to
 
place
 
heavy
 
objects

 
on
 
the
 
load
 
space
 
cover
 
when
 
unreeled.
Compress
  then   place   the   right-hand  lug facing the support
B.
Release to engage the roller in its
support.
Unroll the load space cover to the rear
side
  pillars.
Engage the ends in the rear notches to
keep
  it   taut.
To install it
Place the row 3 seats in the fully folded
position.
Raise
 
the
 
storage
 
flap
 
at
 
the
 
boot
 
sill.
Take
 
hold
 
of
 
the
 
roller
 
in
 
the
 
centre
 
and
 
compress

 
it
 
towards
 
the
 
left-hand
 
pillar.
Raise
 
the
 
assembly.
EASE OF USE and COMFORT
4
Practical information

11 0
Berlingo-2-VP_en_Chap04_Ergonomie_ed01-2016
To remove it
From  the   boot,   pull   the   load   space  
cover

  towards   you   to   release   it   from  
the

  side   pillars.
Guide
  the   load   space   cover   as   it   rolls   up.
Remove
  the   clips   of   the   three   flaps  
from

  the   base   of   each   row   2   head  
restraint.
Compress

  the   roller   to   the   left   to  
remove

  it   from   the   support   B.
Raise
  it   and   pivot   it   forwards. To store it
Store it in the recess at the boot sill,
with
  the   two   rear   flaps   uppermost.
First,
  compress   the   load   space   screen  
to

  the   left.
Release.
Arrange
  the   two   flaps   and   close   the  
storage

  flap.
The
 
roller
 
is
 
fitted
 
with
 
three
 
flaps
 
permitting

 
concealment
 
of
 
the
 
boot, whether the row 2 seats
are

 
in
 
the
 
normal
 
position
 
or
 
the
 
comfort

 
position.
Each
 
flap
 
has
 
two
 
clips
 
which
 
are
 
hooked

 
on
 
the
 
base
 
of
 
each
 
head
 
restraint.
Practical information