service reset Citroen BERLINGO MULTISPACE RHD 2016 2.G Owner's Manual

28
Berlingo-2-VP_en_Chap03_Pret-a-partir_ed02-2015
Instruments and controls
Berlingo-2-VP_en_Chap03_Pret-a-partir_ed02-2015
Dials
1. Distance  recorder   in   kilometres   /  miles.
2.
 
Display
  screen.
3.
 
Fuel
  gauge,   coolant   temperature.
4.
 
Rev
  counter.
5.
 
T
rip   distance   recorder   /   service  
indicator

  reset.
6.
 
Instrument
  panel   lighting   dimmer.Level 1
INSTRUMENT PANELDisplay screens
Screens
The format of the information presented in the screen depends on
the
  vehicle's   equipment   level.
Level 2
with the touch screen tablet

47
Berlingo-2-VP_en_Chap03_Pret-a-partir_ed02-2015
Instruments and controls
Berlingo-2-VP_en_Chap03_Pret-a-partir_ed02-2015
SERVICE INDICATOR
This programmes service intervals according  to   the   use   of   the   vehicle.More than 1 000 miles/km before the
next service is due
Example:
  4   800   miles/km   remain  
before

  the   next   service   is   due.   When  
the ignition is switched on and for a
few

  seconds,   the   screen   shows:
a few seconds after the ignition is
switched on, the oil level is displayed
(depending on version), then the total
distance

  recorder   resumes   normal  
operation showing the total and trip
distances.
Less than 1 000 miles/km before the
next service is due
Each time the ignition is switched on and for a few seconds,  the   spanner   flashes   and   the   number   of miles/kilometres

  remaining   is   displayed:
a few seconds after the ignition is
switched on, the oil level is displayed
(depending on version), then the total
distance
  recorder   resumes   normal  
operation

  and   the   spanner   remains   on.  
This indicates that a service should be
carried

  out   shortly.
Service overdue
Operation
A
 

few
 
moments
 
after
 
the
 
ignition
 
has been switched on, the spanner
indicating

 
a
 
service
 
operation
 
comes
 
on; the display for the total distance
recorder

 
gives
 
(in
 
round
 
figures)
 
the
 
distance

 
remaining
 
before
 
the
 
next
 
service.
The points at which a service is due
are

 
calculated
 
from
 
the
 
last
 
indicator
 
zero

 
reset.
The point at which a service is due is
determined
 
by
 
two
 
parameters:
-

the distance travelled,
-

 
the

 
time
 
which
 
has
 
elapsed
 
since
 
the

 
last
 
service.
The
 
distance
 
remaining
 
before
 
the
 
next

 
service
 
may
 
be
 
weighted
 
by
 
the

 
time
 
factor,
 
depending
 
on
 
the
 
type

 
of
 
driving. With the engine running the spanner
remains
  on   until   the   service   has   been  
carried

  out.
For BlueH
d i d iesel versions, this
alert
  is   also   accompanied   by   the   fixed  
illu

mination   of   the   Service   warning  
lamp,

  on   switching   on   the   ignition.
Each
  time   the   ignition   is  
switched on and for a few
seconds, the spanner
flashes

  and   the   excess  
distance

  is   displayed.
For BlueH
d i d iesel versions, the
spanner
  can   also   come   on   early,  
according the level of deterioration
of

  the   engine   oil.   Deterioration   of   the  
engine oil depends on the conditions of
use

  of   the   vehicle.
REadY To Go
3

48
Berlingo-2-VP_en_Chap03_Pret-a-partir_ed02-2015
Instruments and controls
Berlingo-2-VP_en_Chap03_Pret-a-partir_ed02-2015
Trip recorder zero
reset button
after this operation, if you wish to
disconnect   the   battery,   lock   the  
vehicle

  and   wait   for   at   least   five  
minutes,

  otherwise   the   zero   re-set   will  
not

 
be   registered.
Engine oil level indicator
depending on your vehicle's engine,
when the ignition is switched on,
the engine oil level is indicated for
a few
seconds, after the service
information. Oil level
correct
Low oil level
Flashing of "OIL",
linked
  with   the  
service

  warning   lamp,  
accompanied

  by   an  
audible

  signal   and   a   message   in   the  
screen, indicates a low oil level which
could

  damage   the   engine.
If   the   low   oil   level   is   confirmed   by   a  
check

  using   the   dipstick,   it   is   essential  
that

  the   level   is   topped   up.
Oil level gauge fault
Flashing of "OIL--"
indicates a
malfunction   of   the  
engine oil level
indicator
.   Contact   a   CITROËN   dealer  
or

  a   qualified   workshop.
The level read will only be correct
if the vehicle is on level ground
and the engine has been off for
more   than   30   minutes.Dipstick
A
  =   maximum,   never   exceed  
this level as a surplus of oil
may

  damage   the   engine.
Contact a CITR o Ë n dealer
or   a   qualified   workshop  
without

  delay.
B  
=
 
minimum,
 
top
 
up
 
the
 
level
 
via

  the   oil   filler   cap,   using   the  
grade of oil suited to your
engine.
Lighting dimmer
With the ignition on, press
the button until the zeros
appear.
With the lighting on,
press the button to vary
the brightness of the
instruments
  and   controls.  
When the lighting
reaches

  the   minimum   (or  
maximum)

 
setting,   release   the   button  
then press it again to increase (or
reduce)

 
the
 
brightness.
a

s soon as the lighting is of the
required
 
brightness,   release   the   button.
Zero reset
Your CITROËN dealer or a qualified workshop  carries   out   this   operation  
after

  each   service.
However, if you carry out the service
yourself, the re-set procedure is as
follows:
-

switch of
f the ignition,
-

press and hold the trip recorder
reset button,
-

 
switch
  on   the   ignition.
The
  display   begins   a   countdown.
When the display shows "=0", release
the
  button;   the   spanner   disappears.

Audio and Telematics
228
Berlingo-2-VP_en_Chap10a_SMEGplus_ed02-2015
Display of options:
i f active but not available, the display will be greyed out,
if
  active   and   available,   the   display   will   be   blank.
di
splay of "Radiotext" for
the   current   station.
Manage
 
the
 
Jukebox.
Display
 
current
 
action.
Select  the   audio   source.
Display   the   "DAB"   band.
Display
 
of
 
the   name   of   the  
c

urrent
 
station.
Short-cut:   access   to   the   choice   of   audio  
s

ource and the list of stations (or titles,
depending   on   the   source).
Select   the   radio   station.
Any
 
thumbnail
 
broadcast
 
by
 
t

he
 
station.
Preset stations, buttons 1
to 15
Short  press:   select   the  
p

reset   radio   station.
Long   press:   preset   a   radio  
s

tation.
Next
 "
Multiplex".
Next   radio   station.
Secondary
 p

age.
Display
 
the
 
name
 
and
 
n

umber
 
of
 
the
 
multiplex
 
ser

vice
 b

eing
 u

sed.
Previous
 "

Multiplex".
Previous
 
radio
 
station.
daB (digital
au dio Broadcasting) radio
If the "daB" radio station being listened to is not
available
  on   "FM",   the   "DAB   FM"   option   is   greyed   out.
Journaline® is a text-based information service designed for digital radio systems.
I
t
 
provides
 
text-based   information   structured   around   topics   and   sub-topics.
This
 
service   is   available   from   the   "LIST   OF   DAB   STATIONS"   page.

Audio and Telematics
245
Berlingo-2-VP_en_Chap10a_SMEGplus_ed02-2015
Level 1Level 2 Comments
Connected services Secondary page Bluetooth
connection Search
Start
  the   search   for   a   device   to   connect.
Connect
/ Disconnect Start or end the Bluetooth connection to the
selected
 d

evice.
Update Import
  contacts   from   the   selected   telephone   to  
s

ave   them   in   the   audio   system.
Delete Delete
  the   selected   telephone.
Confirm Save
  the   settings.
Connected services
Secondary pageTransfer rate Reset
Reset
  the   usage   monitor,   them   confirm.
Confirm
Connected services Secondary pageWiFi connection All
Display
  all   Wi-Fi   networks.
Secure Display
  secure   Wi-Fi   networks.
Stored Memorise
  the   selected   Wi-Fi   network(s).
Add Add
  a   new   Wi-Fi   network.
Off/ On Activate
  or   deactivate   a   Wi-Fi   network.
Connect Select
  a   Wi-Fi   network   found   by   the   system   and  
c

onnect   to   it.
TECHNOLOGY on BOARD
10