wheel Citroen C CROSSER 2008 1.G Owner's Guide
[x] Cancel search | Manufacturer: CITROEN, Model Year: 2008, Model line: C CROSSER, Model: Citroen C CROSSER 2008 1.GPages: 216, PDF Size: 4.85 MB
Page 142 of 216
P R A C T I C A L I N F O R M A T I O N
IX
140
Access to the fuses
O p e n t h e g l o v e b o x ,
Push the two opening guides
C
i n w a r d s t o p a s s t h e fi r s t n o t c h ,
Remove the retaining tab D pulling it outwards,
Support the cover and tilt it downwards,
Change the fuse (refer to the corresponding
paragraph).
* T h e m a x i - f u s e s p r o v i d e a d d i t i o n a l p r o t e c t i o n f o r t h e e l e c t r i c a l s y s t e m s . A l l w o r k o n t h e m a x i - f u s e s m u s t b e c a r r i e d
out by a CITRÖEN dealer.
Fuse N° Rating Functions
17 10 A 4 wheel drive control unit.
18 7.5 A Reversing lights, parking assistance control unit,
reversing camera, air bags control unit.
19 15 A Accessories socket.
2 0 * 30 A Electric window controls.
21 *
30 A Rear screen demisting.
22 7.5 A H e a t e d e x t e r i o r m i r r o r s .
23 - Not used.
24 25 A Driver’s electric seat, footwell lighting, releasing of
the rear bench seat.
25 30 A Heated seats.
Page 148 of 216
P R A C T I C A L I N F O R M A T I O N
IX
146
TOWING
Access to the tools Having your vehicle towed on a
flatbed
Below the front bumper, install the
towing system on the towing eye 1 .
On the rear bumper, remove the
cover by pulling at the bottom using
the jack handle 2 .
Towing another vehicle
The towing eye and the tools are stored
in the storage compartment in the right-
hand boot trim.
To access them:
open the boot,
turn button A to the left,
remove the cover B ,
r e m o v e t h e fi x i n g b a n d C and take
out the tool bag
D containing the
tools,
take the towing eye and the tools
required out of the tool bag.
When being towed with the
engine off, there is no longer any
braking or steering assistance.
Place the gear lever in neutral.
Always have the vehicle
t o w e d o n a fl a t b e d .
Never have the vehicle towed
with the four wheels on the ground,
this could damage the transmission.
The vehicle must not be towed with
the front or rear wheels on the ground
even if it is in front “2WD” (2 wheel
drive) mode.
Screw in the towing eye fully using
the wheelbrace 3 .
Install the towbar.
Switch on the hazard warning lights
on the towed vehicle.
Operating procedure for having your
v e h i c l e t o w e d o n a fl a t b e d o r f o r t o w i n g
another vehicle using a removable
mechanical device.
Page 152 of 216
T E C H N I C A L D A T A
X
150
CONSUMPTION
The consumption values presented here correspond to the values communicated at the time of printing.
The consumption values were established in accordance with Dire ctive 80/1268/CEE. They may vary depending on the style
o f d r i v i n g , t r a f fi c c o n d i t i o n s , w e a t h e r c o n d i t i o n s , t h e l o a d i n t h e v e h i c l e , t h e m a i n t e n a n c e o f t h e v e h i c l e a n d t h e u s e o f t h e
accessories.
In accordance with directive 80/1268/CEE
Engine Gearboxes
Model
codes
Wheels
Urban
driving mpg
(litres/100 km)
Inter-urban
driving mpg
(litres/100 km)
Mixed
driving mpg
(litres/100 km)
Emission of
CO 2 by weight
(g/km) mixed
2.4 litre 16V
Manual
(5-speed)
VUSFZC -
VVSFZC
- 22.4 (12.6) 37.7 (7.6) 30.1 (9.4) 225
CVT
(6-speed)
VUSFZF
- VVSFZF
- 22.4 (12.6) 37.6 (7.5) 30.4 (9.3) 222
2.2 litre HDI
PEF 16V
Manual
(6-speed)
U4HNH
V4HNH
16” 29.7 (9.5) 47.9 (5.9) 39.3 (7.2) 191
2.2 litre HDI
PEF 16V
Manual
(6-speed)
U4HNH
V4HNH
18” 29.4 (9.6) 47.1 (6.0) 38.7 (7.3) 194
Page 155 of 216
T E C H N I C A L D A T A
X
153
A.
Manufacturer’s plate.
This number is indicated on a plate riveted on the centre pillar, on the
driver’s side.
B.
Serial number under the bonnet.
This number is engraved on the bodywork near the windscreen.
C.
After Sales plate.
This plate is riveted on the inside of the bonnet.
D.
Front number plate.
E.
Tyres / paint label.
T h i s l a b e l i s a f fi x e d t o t h e p a s s e n - ger’s door centre pillar.
It indicates the following information:
- the tyres pressures without load and with load,
- the rim and tyre sizes,
- the pressure of the spare wheel,
- the paint colour reference.
F. Serial number behind the wind-
screen.
This number is engraved on the fas- cia, behind the windscreen.
IDENTIFICATION FEATURES
The tyre pressures must be checked
when cold at least once a month.
Low tyre pressures increase fuel
consumption.
Page 156 of 216
A U D I O E Q U I P M E N T a n d T E L E M A T I C S
XI
154
YOUR AUDIO-CD SYSTEM
This consists of the following
components:
- a control panel,
- a multifunction display,
- steering wheel audio controls,
- 4 or 6 speakers (according to version),
- a CD changer (according to version),
- a u x i l i a r y s o c k e t s , l o c a t e d a t t h e r e a r of the centre console (according to
version),
- a radio aerial, located on the roof at the rear of the vehicle. Steering wheel audio controls
1.
On / Off and selection of the
radio or CD mode
2.
Decreasing of the volume
3.
Increasing of the volume
4.
Search for a higher radio
frequency / Next track / Fast
forwards play
5
.
Search for a lower radio frequency / Previous track / Rewind play
They can be used when the ignition
switch is in the “ON” or “ACC” position.
Switching on
Press button 1 for more than two
seconds.
The last source selected before switching
off comes back into operation.
Selecting the source
Press button 1 .
The source changes in the following
order: FM1 / FM2 / FM3 / MW / LW /
CD / FM1...
Searching in radio mode
Press button 4 or
5 to search for a higher
or lower radio frequency respectively.
While a track is being played,
press button 5 once to return to the
beginning of this track.
Adjusting the volume
Press and hold button
2 or
3 to decrease
or increase the volume respectively.
It allows you to:
- listen to the radio in FM/MW/LW,
- listen to audio CDs (CD-DA, CD- T e x t , C D - R / R W ) o r C D s w i t h M P 3
fi l e s . Switching off
Press button 1 for more than two
seconds. Searching in CD mode
Press button
4 or
5 t o s e l e c t t h e n e x t o r
previous track on the CD respectively.
Press and hold button 4 or 5 for fast
forwards or rewind playing of the current
track of the CD respectively.
Page 172 of 216
A U D I O E Q U I P M E N T a n d T E L E M A T I C S
XI
169
YOUR AUDIO-TELEMATICS SYSTEM
This consists of the following components:
- a t i l t i n g 7 ˝ L C D c o l o u r t o u c h s c r e e n ,
- a GPS aerial located in your fascia,
- a radio aerial located at the rear, on the roof of the vehicle,
- 4 to 6 speakers (according to version),
- controls around the screen and at the steering wheel plu s touch buttons on the screen according to the display,
- a voice synthesiser (male or female) giving the directions duri ng navigation,
GPS aerial
It allows you to:
- b e g u i d e d t o t h e d e s t i n a t i o n o f y o u r c h o i c e ( E u r o p e a n m a p o n 3 0 G b h a r d d i s c ) t a k i n g t r a f fi c c o n d i t i o n s i n t o a c c o u n t ,
- listen to the radio,
- l i s t e n t o a u d i o C D s ( C D D A , C D - T e x t , C D - R / R W ) o r C D s w i t h M P 3 a n d W M A fi l e s ,
- copy audio CDs to a music server, up to 2,500 songs (coded i n MP3/WMA) on 10 Gb available on the hard disc,
- play DVDs (playing of video if the vehicle is stationary),
- make hands-free telephone calls.
For maintenance of the display, we recommend the use of a n on-abrasive soft cloth (spectacles cloth) without any additional
products.
Page 209 of 216
A U D I O E Q U I P M E N T a n d T E L E M A T I C S
XI
206
HANDS-FREE TELEPHONE
What is the Bluetooth® hands-free telephone with voice
recognition?
The system uses wireless communication technology referred to as
Bluetooth® which allows you to make hands-free telephone calls in
SPEAK
Pressing activates the voice recognition (“Listening” is displayed).
During voice recognition, a brief press pauses this recognition.
A n e x t e n d e d p r e s s d e a c t i v a t e s t h e r e c o g n i t i o n .
A brief press will activate the recognition even if a telep hone call is
progress.
Increasing of the audio volume.
PICK UP
Press to answer an incoming call.
If a second incoming call is received,
p r e s s t h i s b u t t o n t o p l a c e t h e fi r s t
call on hold and speak to the second
caller.
In this case, a brief press switches
between callers.
To establish a three-way conver-
sation, press the SPEAK button to
switch to voice recognition mode and
say “Incorporate the call”.
HANG UP
Press to reject an incoming call.
During a call, pressing ends this call.
General notes
Decreasing of the audio volume. Audio system on/off. your vehicle via your Bluetooth® com-
patible mobile telephone.
It has a voice recognition function which
allows you to make telephone calls us-
ing a microphone, located in the courte-
sy light, and also by means of easy use
of the steering wheel controls or using
voice commands. Five languages are
available: English (by default), Spanish,
French, German and Italian.