service schedule CITROEN C-CROSSER DAG 2012 Handbook (in English)

20

Limit the causes of excess consumption

Spread loads throughout the vehicle;place the heaviest items in the bottomof the boot, as close as possible to therear seats.
Limit the loads carried in the vehicleand reduce wind resistance (roof bars,roof rack, bicycle carrier, trailer...). Usea roof box in preference.

Remove roof bars and roof racks after use.

At the end of winter, remove snowtyres and refi t your summer tyres.


Observe the recommendations on maintenance

Check the tyre pressures regularly,when cold, referring to the label in thedoor aperture, driver's side.

Carry out this check in particular:



- before a long journey,


- at each change of season,


- after a long period out of use.

Don't forget the spare wheel and thetyres on any trailer or caravan.


Have your vehicle serviced regularly(engine oil, oil fi lter, air fi lter...) and ob-serve the schedule of operations rec-ommended by the manufacturer.
When refuelling, do not continue after the 3
rd cut-off of the nozzle to avoidany overfl ow.


At the wheel of your new vehicle, it is onlyafter the fi rst 1 800 miles (3 000 kilometres)that you will see the fuel consumption set-tle down to a consistent average.

I
MONITORING
30

Prevention messages




Information messa
ges (ignition at "ON")



Message



is on



Status of the system



2WD two wheel
drive system
Flashing When the "2WD" (2 wheel drive) mode is selected using the
transmission mode selector.

4WD four wheel
drive system
Flashing When the "4WD" (4 wheel drive) mode is selected using the
transmission mode selector.
This mode is the default mode.

4WD LOCK four
wheel drive system
Flashing When the "LOCK" (4 wheel drive) mode is selected using the
transmission mode selector.

Ambient
temperature
Fixed This indicates the ambient temperature.
When the vehicle is stationary or if the speed is below 12 mph (20 km/h)
the temperature displayed may not be the true temperature.


Display



is on



Cause



Solution - action



Observations



Service
indicator
Fixed Informs the driver of
the time remaining
before the vehicle's
scheduled service. Contact a CITROËN
dealer or a qualifi ed
workshop. This is displayed for a few
seconds when the ignition is
switched on.

Break
advised
Fixed Informs the driver that
they should stop to
take a break. You are advised to
take a break. This is displayed when the
driving time that you set
previously is reached.
An audible signal is heard
3 times and is then heard every
5 minutes until the vehicle stops.

I
31 The total distance is
displayed in zone 1
of the screen and the
trip distance in zone 2

(refer to the "Distance
recorders" section).
Distance recorder (A and B)
INFORMATION ON THE
IN
STRUMENT PANEL SCREEN
Information displa
y
With the ignition on, press the INFO
button, located on the fascia to the
left of the instrument panel, to display
the various types of information in
succession:


- distance recorder A,

- distance recorder B,

- service indicator,

- coolant temperature,

- range,

- trip computer,

- setting menu. This displays the distance
and the number of
months remaining before
the next service, in line
with the manufacturer's
servicing schedule (refer
to the "Service indicator"
section).
Service indicator
When the engine is
running, this indicates
the temperature of the
coolant (refer to the
"Coolant temperature
indicator" section).
Coolant temperature When the engine is
running, this indicates
the number of miles
(kilometres) which can
still be travelled with the
fuel remaining in the tank,
based on the average
fuel consumption over
the last few miles (kilometres) travelled
(refer to the "Range" section).
Range
This indicates the average
fuel consumption, the
average speed and the
current fuel consumption
(refer to the "Trip
computer" section).
Trip computer

When the vehicle is
stationary
, this allows
the user to change the
following settings (refer
to the "Setting menu"
section):


- the display language,

- the temperature dis-
play units,

- the fuel consumption units,

-
the option to reinitialise the average fuel
consumption and the average speed,

- the break (rest) reminder display interval.




Setting menu

I
MONITORING
33
SERVICE INDICATOR Resetting the service indicator to zero
Your CITROËN dealer or a qualifi ed
workshop carries out this operation
after each service.
If you have carried out your vehicle's
service yourself, the zero reset
procedure is the following:


)
switch off the ignition.

)
press the INFO
button several times
in succession until the service indi-
cator is displayed.

)
press and hold the INFO
button for
a few seconds until the spanner
fl ashes
.

)
press the INFO
button while the
spanner is fl ashing to change the dis-
play "---"
to "CLEAR"
then the time
remaining before the next service is
due is displayed.


Service overdue
O
peration
When the ignition is switched on, you
must press the INFO
button several
times in succession until the service
indicator is displayed. The distance
recorder display line indicates the
number of miles (kilometres) remaining
and the time elapsed line indicates the
number of months remaining before the
next service is due.
After a certain distance and a certain
time, the display of "---"
is reinitialised
and the display indicates the time
remaining before the next service is
due. System which informs the driver when
the next service is due in accordance
with the manufacturer's servicing
schedule.
The point at which the next service is
due is calculated from the last service
indicator zero reset.
It is determined by two parameters:


- the distance travelled (in miles (km)),

- the time elapsed since the last ser-
vice (in months).
The distance remaining to be travelled
may be weighted by the time factor,
depending on the user's driving habits.
Example:
the display indicates that
7 300 miles (kilometres) remain before
the next service is due.
The symbol "--"
remains displayed
until the fi rst service of a new vehicle
has been carried out.

Example:
the display indicates that the
service is overdue. This service must
be carried out by a CITROËN dealer or
a qualifi ed workshop. Each time the ignition is switched on,
the display "PERIODIC INSPECTION"

is displayed for a few seconds to
indicate that the service must be carried
out without delay.