warning CITROEN C-ELYSÉE 2018 Handbook (in English)

15
Warning / indicator lampStateCause Action / Observations
AdBlue
®
(BlueHDi Diesel)Fixed, on switching
on the ignition,
accompanied by an
audible signal and a
message indicating the
remaining driving range.The remaining driving range is
between 350 miles (600 km) and
1,500
miles (2,400 km). Have the AdBlue® tank topped up as soon as
possible: go to a CITROËN dealer or a qualified
workshop, or carry out this operation yourself.
Flashing, associated
with the Ser vice
warning lamp,
accompanied by an
audible signal and a
message indicating the
remaining driving range.The remaining driving range is
between 0 and 350 miles (0 and
6 0 0


k m). Yo u must
top up the AdBlue® tank to avoid a
breakdown : go to a CITROËN dealer or a qualified
workshop, or carry out this operation yourself.
Flashing, associated
with the Ser vice
warning lamp,
accompanied by an
audible signal and a
message indicating that
starting is prevented.The AdBlue® tank is empty: the
starting inhibition system required
by legislation prevents starting of the
engine. To be able to start the engine, you must
top up the
AdBlue® tank: go to a CITROËN dealer or a qualified
workshop, or carry out this operation yourself.
It is essential to add at least 4
litres of AdBlue
® to the
fluid tank.
1
Instruments

16
Warning / indicator lampStateCause Action / Observations
SCR emissions
control system
(BlueHDi Diesel) Fixed, on switching on
the ignition, associated
with the Ser vice and
engine auto diagnosis
warning lamps,
accompanied by an
audible signal and a
message. A fault with the SCR emissions
control system has been detected.
This alert disappears once the exhaust emissions
return to normal levels.
Flashing, on switching
on the ignition,
associated with the
Service and engine
auto diagnosis warning
lamps, accompanied by
an audible signal and
a message indicating
the remaining driving
range.After confirmation of the fault with
the emissions control system,
you can continue driving for up to
650
miles (1,100 km) before the
engine starting inhibition system is
triggered. Contact a CITROËN dealer or a qualified workshop
without delay
, to avoid a breakdown .
Flashing, on switching
on the ignition,
associated with the
Service and engine
auto diagnosis warning
lamps, accompanied
by an audible signal
and a message. You have exceeded the authorised
driving limit following confirmation
of a fault with the emissions control
system: the engine starting inhibition
system prevents starting of the
engine.
To be able to restart the engine, you must
call on a
CITROËN dealer or a qualified workshop.
Instruments

17
ServiceTemporarily on. A minor fault has occurred for which
there is no specific warning lamp. Identify the fault by reading the message shown in
the screen, such as, for example:
-

s
aturation of the particle filter (Diesel).
-
t

he power steering,
-

a m
inor electrical fault.
For any other faults, contact a CITROËN dealer or a
qualified workshop.
Fixed. A major fault has occurred for which
there is no specific warning lamp. Identify the fault by reading the message shown in
the screen and then contact a CITROËN dealer or a
qualified workshop.
Rear foglamp Fixed. The rear foglamp has been switched
on using the ring on the lighting
control stalk. Turn the ring on the lighting control stalk rear wards to
switch off the rear foglamp.
Stop & Star t Fixed.
When the vehicle is stopped (red lights,
traffic jams, etc.), the Stop & Start system
puts the engine into STOP mode.The warning lamp goes off and the engine restarts
automatically in START mode, as soon as you want
to move off.
Flashes for a few
seconds, then goes
of f. STOP mode is temporarily
unavailable.
or
START mode has been triggered
automatically. For more information on Stop & Star t
, refer to the
corresponding section.
Warning / indicator lamp
StateCause Action / Observations
1
Instruments

18
Warning / indicator lampStateCause Action / Observations
Front foglamps Fixed. The front foglamps have been
switched on using the ring on the
lighting control stalk. Turn the ring on the lighting control stalk rear ward
once to switch off the front foglamps.
Left-hand
direction
indicator Flashing with audible
signal.
The lighting control stalk has been
moved down.
Right-hand
direction indicatorFlashing with audible
signal.The lighting control stalk has been
moved up.
Dipped beam
headlamps Fixed.
The lighting control stalk is in the
"Dipped beam headlamps" position.
Main beam
headlamps Fixed.
The lighting control stalk has been
pulled towards you. Pull the stalk to return to dipped beam headlamps.
Foot on the
clutch Fixed.
In STOP mode of Stop & Start, the
transition to START mode has been
rejected because the clutch pedal is
not fully pressed down. With a manual gearbox, you must declutch fully to
allow the change to engine START mode.
Foot on the
brake pedal Fixed.
With an automatic gearbox, you have
forgotten to press the brake pedal to
move out of position P.With the engine running, before releasing the parking
brake you must press the brake pedal to unlock the
automatic gear selector lever and move out of the P
position.
Instruments

19
Service indicator
Warning / indicator lampStateCause Actions / Comments
Service spanner Fixed, temporary
when the ignition is
switched on. Between 600
miles (1,000 km) and
1,800
miles (3,000 km) remain
before the next ser vice is due. The ser vice indicator is displayed for a few seconds
in the instrument panel. Depending on the version:
-

t
he distance recorder displays a line showing the
distance remaining (in miles or kilometres) before
the next ser vice is due.
-

a
n alert message indicates the distance remaining
(in miles or kilometres) as well as the period
before the next ser vice is due.
The service spanner disappears after a few seconds.
The alert may be triggered close to the due date.
Fixed, when the
ignition is switched
on. Less than 600
miles (1,000 km)
remain before the next ser vice is
due. The ser vice indicator is displayed for a few seconds
in the instrument panel. Depending on the version:
-

t
he distance recorder display line indicates the
distance remaining before the next ser vice is due.
-

a
n alert message indicates the distance remaining
as well as the period before the next ser vice is
due.
The ser vice spanner remains on to show that a
ser vice is required very soon.
The alert may be triggered close to the due date.
Indicators
1
Instruments

20
Warning / indicator lampStateCause Actions / Comments
Service spanner Flashing then fixed,
when the ignition is
switched on. Service overdue.
The ser vice indicator is displayed for a few seconds
in the instrument panel. Depending on the version:
-

t
he total distance recorder displays a line showing
the distance travelled since a ser vice was due.
The value is preceded by the "-" sign.
-

a
n alert message indicates that a ser vice is
overdue.
The ser vice spanner remains on until the ser vice has
been performed.
The alert is triggered when the due date has passed.
+ Flashing then fixed,
when the ignition
is switched on,
associated with the
service warning lamp.Ser vice overdue for BlueHDi Diesel
versions.
The ser vice indicator is displayed for a few seconds
in the instrument panel. Depending on the version:
-

t
he total distance recorder displays a line showing
the distance travelled since the ser vice was due.
The value is preceded by the "-" sign.
-

a
n alert message indicates that a ser vice is
overdue.
The ser vice spanner remains on until the ser vice has
been performed.
The alert is triggered when the due date has passed.
The distance indicated (in miles or
kilometres) is calculated according to the
mileage covered and the time elapsed
since the last ser vice.
Instruments

22
Remaining range between 1,500 and 350 miles (2,400 and 600 km)
When driving, this message is displayed every
180 miles (300 km) until the fluid level has been
topped up.
The reser ve level has been reached; it is
recommended that you top up as soon as
possible.
It is recommended that you do not top up by
more than 10
litres of AdBlue.
For more information on AdBlue
® and
the SCR system , and, in particular,
on topping up the AdBlue
®, refer to the
corresponding section. Range below 350
miles (600 km)
When driving, this message is displayed every
30 seconds until the AdBlue level has been
topped up.
It is essential to top up as soon as possible and
before the tank is completely empty; other wise
it will not be possible to restart the engine after
the next stop.
When switching on the ignition, this warning
lamp comes on, accompanied by an audible
signal and the display of "NO START IN" and a
distance on the instrument panel, indicating the
driving range expressed in miles or kilometres
before engine starting is prevented –
(e.g. "NO START IN 900

miles" means
"Starting will be prevented in 900 miles").
When switching on the ignition, this warning
lamp flashes and the service warning lamp
comes on, accompanied by an audible signal
and the temporary display of "NO START
IN" and a distance on the instrument panel,
indicating the remaining range expressed in
miles or kilometres before engine starting is
prevented –
(e.g. "NO START IN 180 miles" means "Starting
will be prevented in 180 miles").
For more information on AdBlue
®
(BlueHDI engines) and, in particular, on
topping up, refer to the corresponding
section. Breakdown related to a lack of AdBlue
®
The AdBlue® tank is empty: the starting
inhibition system required by regulations
prevents starting of the engine.
To be able to restart the engine, it is
essential to add at least 4
litres of AdBlue
®
to its tank.
For more information on the AdBlue
® (BlueHDi
engines) , and, in particular, on topping up,
refer to the corresponding section. When switching on the ignition, this warning
lamp flashes and the service warning lamp
comes on, accompanied by an audible signal
and the temporary display of "NO START IN"
and 0

miles or km on the instrument panel –
("NO START IN 0

miles" means "Starting
prevented").
Instruments

23
If it is a temporary fault, the alert
disappears during the next journey,
after auto diagnosis checks of the SCR
emissions control system.
During the permitted driving phase
(between 650
and 0 miles (1,100 km and
0


km))
While driving, the message is displayed every
30

seconds while the fault with the SCR
emissions control system persists.
The alert is repeated when switching on the
ignition. Starting prevented
You have exceeded the authorised driving
limit: the starting inhibition system does
not allow the engine to be started.
To be able to restart the engine, you must call
on a CITROËN dealer or a qualified workshop.In the event of a fault with
the SCR emissions control
system
An engine starting inhibition device is
activated automatically after you have
driven a further 650 miles (1,100 km)
following confirmation of a fault with the
SCR emissions control system. Have the
system checked by a CITROËN dealer or
a qualified workshop as soon as possible.
In the event of the detection of a fault
These warning lamps come on, accompanied
by an audible signal and the display of the
message "Emissions fault".
The alert is triggered while driving as soon
as the fault is detected for the first time, then
when switching on the ignition for subsequent
journeys, while the fault persists. If a fault with the SCR system is confirmed
(after 30
miles (50 km) covered with the
permanent display of the message signalling
a fault), these warning lamps come on and the
AdBlue warning lamp flashes, accompanied
by an audible signal and the temporary display
in the instrument cluster of NO START IN
and a distance, indicating the driving range
expressed in miles or kilometres before engine
starting is prevented – (e.g. "NO START IN
350
miles" means "Starting will be prevented in
350


miles").You should go to a CITROËN dealer or a
qualified workshop as soon as possible.
Other wise you will not be able to restart the
vehicle.
When switching on the ignition, these warning
lamps comes on and the AdBlue warning lamp
flashes, accompanied by an audible signal and
the temporary display of "NO START IN" and
0
miles or kilometres on the instrument panel –
("NO START IN 0
miles" means "Starting
prevented").
1
Instruments

30
Locking is confirmed by continuous lighting of
the direction indicators for approximately two
seconds.If one of the doors or the boot is still open,
the central locking does not work; the
vehicle locks, then immediately unlocks,
identifiable by the locks making a rebound
sound.
When the vehicle is locked, if it is
unlocked inadvertently, it will lock again
automatically after thirty seconds unless a
door or the boot is open.
Locating your vehicle
This function allows you to identify your vehicle
from a distance, particularly in poor light. Your
vehicle must be locked. F

P
ress the closed padlock button
on the remote control.
This will switch on the courtesy lights and the
direction indicators will flash for a few seconds.
Fault with the remote
control
In the event of a malfunction with the remote
control, you can no longer unlock, lock or
locate your vehicle.
F

F
irst of all, use the key in the door lock to
unlock or lock your vehicle.
F

T
hen reinitialise the remote control.
Reinitialisation
F Switch off the ignition and remove the key from the switch.
F

P
ress the closed padlock button for a few
seconds.
F

R
eturn the key to position 2 (ignition on ).
F

S
witch off the ignition and remove the key
from the switch.
The remote control is now fully operational
again.
Changing the battery
Battery type: CR2032 / 3 volts.
I f the battery is flat, you are informed
by lighting of this warning lamp in the
instrument panel, an audible signal
and a message in the screen. F

U
nclip the cover by inserting a small
screwdriver in the slot.
F
R
emove the cover.
F
R
emove the flat battery from its
compartment.
F
F
it the new battery into its compartment
observing the original fitting direction.
F
C
lip the cover onto the casing.
Access

33
Doors
Opening
From outside
From inside
Closing
When a door is not closed correctly:-
w
hen the engine is running ,
this warning lamp comes on,
accompanied by a message in
the multifunction screen for a few
seconds,
-

w
hen the vehicle is moving
(speed higher than 6
mph
(10
km/h)), this warning lamp
comes on, accompanied by an
audible signal and a message in
the multifunction screen for a few
seconds.
Back-up release
System for mechanically locking and unlocking
the doors in the event of a fault with the central
locking system or a battery failure.
Driver's door
Insert the key in the door lock to lock or unlock
the door.
Passenger doors
F On the rear doors, check that the child lock is not on.
F

A

fter unlocking the vehicle using the remote
control or the key, pull the door handle.
F

P

ull a door interior opening control; this
unlocks the whole vehicle. F

R
emove the black cap on the edge of the
door, using the key.
F

I
nsert the key in the socket without forcing
it, then without turning it, move the latch
sideways towards the inside of the door.
F

R
emove the key and refit the cap.
In the event of a fault with the central
locking system, it is essential to
disconnect the battery to lock the boot and
so ensure complete locking of the vehicle.
2
Access