lock Citroen C ZERO 2012 1.G Owner's Guide

Practical information
82








Charging the main battery
)Pull lever 1
, located at the bottom of the
dashboard, driver's side, to open the
access flap for the normal charging socket(right hand side of the vehicle).

Normal charging


Before connecting, check that the electrical installation you want to usemeets standards * and is compatiblewith the current rating on the chargingcable control unit. In all cases, it is recommended that that you first have an initial checkand then regular checks on your installation by a qualified electrician.
There are two types of charging you can use:normal or fast.
Normal charging should be used in pre
ference;
it is done from a domestic mains power point.
Fast charging is done at a compatible fastcharging station.
) Apply the parking brake and put the driveselector in position P
. P)
Switch off all electrical consumers and turn
the ignition switch to the "LOCK"
position.



You must always use only a genuine CITROËN charging cable. If the ambient temperature is lower than -25° C, charging may not be possible.
*

For example, in France the standard
is NF C 15-100.

Practical information
86
Check the compatibility of the charging station and its charging cable with your vehicle.
)
Press latch 4to open the socket cover.)
Ensure that there is no foreign body on the
vehicle's charging socket.

Fast charging *

)Apply the parking brake and put the drive
selector in position P.P)Switch off all electrical consumers and turn
the ignition switch to the "LOCK"position. )Pull lever 3 , located alongside the driver's
seat, outer side, to open the access flap for
the fast char
ging socket (left hand side of
the vehicle).

Do not touch the metal end of thenormal charging socket or of thecharging cable. Risk of electrocution and/or faults.
)Connect the charging cable of the charging station to the vehicle following the
instructions on use of the station.

*
Dependin
g on equipment.

Practical information
90

Charging the battery using
a battery charger
)Star t the other vehicle and wait a fewminutes.)Turn the ignition key on your vehicle, until
the "Ready" lamp comes on.
)Disconnect the cables in the reverse order.)Refit the battery protective cover and
tighten the fixing screw.
I
f the "Ready" lamp does not come on, proceedas follows: )Leave the cables connected. )Return the ignition switch on your vehicle to
the " LOCK" position. )Put the main battery on charge, followingthe procedure for normal charging (see the"charging the main battery" section). )When the charging warning lamp in
the instrument panel comes on fixed,disconnect the cables.)Leave the battery on charge for at least one hour. )Turn the ignition key on your vehicle, until
the "Ready" lamp comes on.
If the problem persists, contact a
CITROËN dealer or a qualified workshop.

)
Remove the protective cover from thebattery.
Ensure that the electrolyte is not frozen.Check the electrolyte level and top upwith distilled water if necessary (refer tothe "checking levels" section).
)Slacken nut 1
and lift off the retaining bar.

8
Practical information
93
1.12 V compressor with integral pressure gauge, to measure and adjust the tyre
pressure.
Composition of the kit
2.Sealant car tridge for the temporary repair
of a tyre.3.Injection pipe. 4.Suction pipe, to remove the sealant product
if necessary.
5.Sachet containing a replacement valve core, a tool for removing/refitting the valve core and a speed restriction sticker.



The speed restriction sticker must beaffixed to the vehicle's steering wheel toremind you that a wheel is in temporary use.

Do not exceed a speed of 50 mph(80 km/h) when driving with a tyre repaired using this type of kit.



Refi tting the rear seat cushion
)Put the metal cover back into place. )Refit the four "butterfly" screws.)Insert the metal hooks into the seat backrest. )Fold the seat cushion down until it locks in place.



When refitting the cushion, take care not to trap the seat belt buckles.

Practical information
96











Changing a wheel


To o l s r equired



- A jack: for lifting the vehicle.

- A wheelbrace: for removin
g and refitting
the wheel bolts.

- A handle: for operating the jack.
These tools are not supplied with your vehicle.
Parking the vehicle

Immobilise the vehicle where it does notblock traffic: the ground must be level,stable and not slippery. Apply the parking brake, switch off the ignition and put the drive selector in
position Pto lock the wheels.
If necessary, place a chock under thewheel diagonally opposite the wheel to be changed.
You must ensure that the occupants get out of the vehicle and wait where they are safe. Never go underneath a vehicle raised using a jack; use an axle stand.

Wheel with wheel trim
When removing the wheel , firstremove the wheel trim using the wheelbrace, by pulling at the valve hole.When fitting the wheel, refit the wheeltrim star ting by aligning the valve hole
with the valve, and then press on theedge of the trim with the palm of your hand.

8
Practical information
103
Changing dipped beam headlamp bulbs
)Turn the bulb holder to the left and pull it out. )Remove the bulb by pressing on the tongue. )Change the bulb.
To r efit, carry out these operations in reverse order.
Changing front foglamp bulbs / daytime running lamp bulbs
) Put the front wheels onto full lock,
to facilitate access.) Remove the clips securing the protective covers on the bulb holders.)
Move the cover aside.
)
Turn the bulb holder ( Afor the front fog
lamp, B for the daytime running lamp) to
the left and pull it out.
) Pull the bulb out and change it.
To reassemble, carry out these operations in
reverse order.

8
Practical information
107











Changing a fuse
the fusebox cover in the dashboard (right hand side).
For access: )Unclip the cover and remove it completely by pulling it towards you.)Remove the tweezer.



Access to tools
Before changing a fuse, the cause of thefailure must be identified and rectified. )
Check that the ignition switch is in
the "LOCK " position.)
Identify the failed fuse by checking
the condition of its filament.
Changing a fuse
Good Failed
)
Use the special tweezer to extract the fuse from its location.)
Always replace the failed fuse with a fuse
of the same rating. ) Check that the number marked on the box,
the rating marked on the top of the fuse
and the tables below all agree.

CITROËN will not accept responsibility for the cost incurred in repairing your vehicle or for rectifying the malfunctionsresulting from the installation of accessories not supplied and not recommended by CITROËN andnot installed in accordance with itsinstructions, in par ticular when the consumption of all of the additional equipment connected exceeds 10 milliamperes.

Your vehicle's electrical system isdesigned to operate with standard or optional equipment.
Before installing other electrical equipment or accessories in your vehicle, contact a CITROËN dealer or aqualified workshop.

Practical information
108
Dashboard fuses
The fusebox is placed in the lower dashboard (right-hand side).
Fuse N°RatingFunctions
17. 5 A
Left hand front and rear sidelamps.
215 A
Accessory socket.
3-
Not used.
47. 5 A Starter.
520
A Audio system.
6
- Not used.
77.5 A
Vehicle equipment, ri
ght hand front and rear sidelamps.
87. 5 A Electric door mirrors.
97.5 A
Supervisor controller.
107.5 A
Air conditioning.
1110 A
Rear foglamp.
1215 A Door locking.
13 10 A
Courtesy lamp.

150
FREQUENTLY ASKED QUESTIONS
QUESTIONANSWERSOLUTION
The quality of receptionof the radio station
listened to gradually
deteriorates or the stored stations do not function(no sound, 87.5 MHz is
displayed...). The vehicle is too far from the transmitter used b
y the station listened
to or there is no transmitter in the geographical area through which the
vehicle is travelling. Activate the RDS function to enable the system
to check whether there is a more powerful
transmitter in the geographical area.
The environment
(hills, buildings, tunnels, basement car parks...) block reception, including in RDS mode. This phenomenon is normal and does not indicate
a failure of the audio equipment.
The aerial is absent or has been dama
ged (for example when goingthrough a car wash or into an underground car park). Have the aerial checked by a CITROËN dealer.

Sound cut-outs of 1 to2 seconds in radio mode.During this brief sound cut-out, the RDS searches for any frequency
permitting better reception of the station. Deactivate the RDS function if the phenomenon is
too frequent and always on the same route.
Tr
affi c announcementTA is displayed. I donot receive any traffi c
information.Th
e radio station does not broadcast traffi c information. Tune to a radio station which broadcasts traffi c
information.
Th
e stored stations arenot found (no sound, 87.5 MHz is displayed...). An in
correct waveband is selected. Press the SRC/TEL button to return to the
waveband (FM1 or FM2) on which the stations arestored.

.
Visual search
153
Exterior
Remote control key 31- 32- opening / closing - central locking - anti-theft protection Starting - Stopping the vehicle 53
Lighting 57-59 Headlamp height adjustment 59 Changing bulbs 99 -104- front lamps - foglamps- daytime running lamps - direction indicator repeaters
Wipers 60Changing a wiper blade 112
Door mirrors 42
Doors 35 - opening / closingElectric windows 34
Charging flaps 37 Charging the main battery 82-87- normal - fast

Accessories 113

ABS, EBFD, EBA, ASR, ESP 72-74 Tyre pressures 125Changing a wheel 96 -98
Boot 36- opening / closing


Changing bulbs 10 4 -10 6- rear lamps - 3rd brake lamp- number plate lamps - foglamp

Recovery 112