fold seats Citroen C2 DAG 2007.5 1.G Owner's Manual
[x] Cancel search | Manufacturer: CITROEN, Model Year: 2007.5, Model line: C2 DAG, Model: Citroen C2 DAG 2007.5 1.GPages: 191, PDF Size: 6.22 MB
Page 84 of 191
1
5
4
3
2
8 4
III
F R O N T S E A T S
Manual adjustments
Head restraint
To raise or lower the head restraint, pull it forwards at the same time as sliding it.
The adjustment is correct when the top edge of the head restraint is at the same height as the top of the head.
To remove it, bring it to the high position. Lift the tab with the aid of a coin and pull.
Backrest angle
Action the control rearwards and adjust the angle of the back-rest.
I t i s p o s s i b l e t o r e c l i n e t h e b a c k r e s t t o a n a n g l e o f 4 5 ° b y t i l t -ing it until it locks. Press the control to unlock.
Heated seats
The front seats can be heated indi-vidually. Use the controls located at the side of the seats, and select one of the three heating levels:
0: Off.
1: Slight heat.
2: Medium heat.
3: Maximum heat.
The seat temperature adjusts auto-matically.Note: The heated seats only oper-ate when the engine is running.
Seat height and rake adjustment
Lift the control and use the weight of your body to move th e seat to the desired position.
Reach
Lift the control bar and adjust to the desired position.
Access to the rear seat positions
To access the rear seat positions, action the control forwards to fold the backrest and slide the front seat.
Afterwards the front seat will revert to its initial position.
Make sure that the seat is secured in place (particularly if the rear seats are folded).
Page 86 of 191
1
4
3
2
8 6
III
R E A R S E A T S
The function 3 is available on all models. The other functions are available depending on the version of your vehicl e.
Fore and aft adjustment
From the boot, it is possible to modify the loadspace by slidi ng the seats.
Push down control 2 and adjust to the desired position.
At the front of the seat, it is also possible to adjust knee room.
Raise the bar located under the seat and adjust to the de sired position (several positions).
Rear head restraints
The rear head restraints have two positions:A stowed position for when the seat is not occupied.A deployed position to provide passenger safety, by raising th em to their locking point.
To raise them, pull them upwards to their maximum height, pressin g the unlocking button.
Foldable backrest
It can be folded either totally or partially.
Lower the head restraint against the backrest, then pivot control 3 towards the rear of the vehicle.
The backrest also has a vertical position to optimise the bootsp ace.
When you reposition the backrest, make sure that it locks in place .
Folded (fully-folded position)
To facilitate this manoeuvre, slide the front seat as far forward as possible, using the fore/aft slide control.
Move the rear seat as far forward as possible using control 2, fold the backrest using control 3, then lift control 4.
The seat goes automatically to the fully-folded position.
Reposition the front seat. The rear seat in the fully-folded position will adapt automatically to the position of the front seat.
When restoring the seat to its original position, check that there is nothing obstructing the anchoring points to ensure that it latches properly.
Page 87 of 191
8 7
III
S E A T C O N F I G U R A T I O N
TRANSPORTING LONG OBJECTS
REAR SEATS
B y c o n fi g u r i n g t h e r e a r s e a t s , y o u c a n c r e a t e s p a c e f o r a v a r i e t y o f o b j e c t s .
A s a s a f e t y m e a s u r e , u s e t h e a n c h o r i n g r i n g s p o s i t i o n e d o n t h e b o o t fl o o r .
4-seater versionsVersions with folding backrestsVersions with fully-folding seats