ECO mode Citroen C3 2013 2.G Owner's Manual

Your vehicle is fi tted with only some of the
equipment described in this document,
depending on the trim level, version and the
specifi cations for the country in which it is
sold.
The fi tting of electrical equipment or
accessories which are not recommended
by CITROËN may result in a failure of your
vehicle's electronic system. Please note this
specifi c warning and contact a CITROËN
dealer to be shown the recommended
equipment and accessories.
CITROËN has a presence on every continent,
a complete product range,
bringing together technology and a permanent spirit of innovation,
for a modern and creative approach to mobility.
We thank you and congratulate you on your choice.


Happy motoring!

We draw your attention to the following...


At the wheel of your new vehicle,
getting to know each system,
each control, each setting,
makes your trips, your journeys
more comfortable and more enjoyable.

refer to the page indicated Key


contributes to the protection of the environment


additional information
safety warning

.
.
Contents
Direction indicators 105
Hazard warning lamps 105
Horn 106
Emergency or assistance call 106
Braking assistance systems 107
Tr ajectory control systems 108
Front seat belts 109
Airbags 111
Safety
Parking brake 115
6-speed manual gearbox 115
Gear effi ciency indicator 116
Electronic gearbox 117
Automatic gearbox 121
Stop & Start 124
Hill start assist 127
Speed limiter 128
Cruise control 130
Rear parking sensors 132
Reversing camera 134
Driving
Emergency or assistance 195
eMyWay 197
Audio system 251
Audio and telematics
Alphabetical index
Bonnet 136
Running out of fuel (Diesel) 137
Petrol engines 138
Diesel engines 139
Checking levels 140
Checks 142
Checks
Te m p o r a ry puncture repair kit 144
Changing a wheel 149
Snow chains 156
Changing a bulb 157
Changing a fuse 164
Battery 171
Energy economy mode 174
Changing a wiper blade 175
To w i ng the vehicle 176
To w i ng a trailer 178
Audio pre-equipment 180
Accessories 182
Practical informationTechnical data
Petrol engines 184
Petrol wei
ghts 185
LPG engines 187
LPG weights 188
Diesel engines 189
Diesel weights 191
Dimensions 193
Identifi cation markings 194
Visual search

Familiarisation
14
Advice on interior settings
Digital air conditioning:
use of the fully automatic mode by pressing the "AUTO"button is recommended. I re
quire...
Heating or Manual air conditioning
Air distributionAir flowAir recirculation/ Exterior air intakeTemperatureManual A/C
HEAT
COOL
DEMISTINGDEFROSTING

Vent ilat ion

Familiarisation
18
Automatic gearbox

Starting and moving off
)Apply the parking brake. )Select position P
or N
. )Start the engine.)Apply the foot brake. )Release the parking brake. )Then select position R , D
or M . )Progressively take your foot off the brake pedal: the vehicle moves off on its own. This 4-speed
gearbox offers the choice of thecomfor t of automatic operation or the pleasure
of manual gear changing.1. Gear lever.2.
"S" (sport) switch. 3." 7" (snow) switch.

Display in the instrument panel

The driving mode selected and/or the gear engaged appear in the instrument panelscreen.
P.Park.
R. Reverse.
N.Neutral.D.Drive (Automatic operation).
S.Sportprogramme. 7Snow programme.
1 to 4. Gears engaged.-.
Invalid value in manual operation.

Driving safely
121

.Familiarisation
19

Stop & Start


Going into engine STOP mode
The "ECO"warning lamp comes
on in the instrument panel and the
engine goes into standby:
-with a manual gearbox:
at speeds below
12 mph (20 km/h), when you put the gear
lever into neutral and you release the clutch pedal,

-
with a 5 or 6-speed electronic gearbox:at speeds below 5 mph (8 km/h), when you press the brake pedal or you move the gear lever to position N.

In some circumstances, STOP mode may notbe available; the "ECO"warning lamp flashes for a few seconds, then goes off.
Going into engine START mode

The "ECO"
warning lamp goes off
and the engine restarts:
-with a manual gearbox:when youdepress the clutch pedal,
-with a 5 or 6-speed electronic gearbox:

●
with the gear lever in position A
or M ,
when you release the brake pedal,

●
or with the gear lever in position N
andthe brake pedal released, when you put
the gear lever in position Aor M ,

●
or when you engage reverse.

In certain circumstances,
START mode may beinvoked automatically; the "ECO"
warning lamp
flashes for a few seconds, then goes off.

Deactivation / Reactivation
You can deactivate the system at any time bypressing the "ECO OFF"
switch; the warninglamp in the button comes on.

Driving safely
124

125

12
5
The system is reactivated automatically every time the vehicle is star ted using the key.
Before refueling or doing anything under the bonnet, you must switch off the ignition with the key.

Familiarisation
20
Speed limiter "LIMIT"
1. Selecting / Switching off speed limiter mode.2.
Decrease the programmed value.3.
Increase the programmed value.4.
Speed limiter on / off.


Cruise control "CRUISE"
1.Selecting / Switching off cruise control mode.
2. Decrease the programmed value. 3.
Increase the programmed value. 4.Cruise control Off / Resume.
The values must be set with the engine running.
Display in the instrument panel

The cruise control or speed limiter mode
appears in the instrument panel when it is
selected.

In order to be programmed or activated, the
vehicle speed must be higher than 25 mph(40 km/h), with at least fourth gear engaged
on a manual gearbox (second gear on an electronic or automatic gearbox).
Cruise control
S
peed limiter


Driving safely
128

1
30

1
Monitoring
25

Visual indicators informing the driver that a system is in operation (operation or deactivation indicator lamps) or of the occurrence of a fault (warning lamp).


When the ignition is switched on

Certain warning lamps come on for a few seconds when the vehicle's ignition is switched on.
When the engine is star ted, these same
warning lamps should go off.
If they remain on, before moving off, refer to the
information on the warning lamp concerned.

Operation indicator lamps

If one of the following indicator lamps comes on, this confirms that the corresponding system has come into operation.

Associated warnings
The illumination of cer tain warning lamps may
be accompanied by an audible signal and a
message in the multifunction screen.The warning lamps may come on continuously (fixed) or flash.
Warning lampis onCauseAction / Observations
Left-hand direction indicator flashing with buzzer.The lighting stalk is pushed down.
Right-handdirection indicatorr

flashing with buzzer. The lighting stalk is pushed up.
Sidelamps

fixed. The lighting stalk is in the
"Sidelamps" position.
Hazard warning lamps flashing with audiblesignal.The hazard warning lamps switch,
located on the dashboard, has been
operated. The left-hand and right-hand direction indicators and
their associated indicator lamps flash simultaneously.
Certain warning lamps may come on
in one of two different modes. Only by relating the type of illumination to the operating status of the vehicle can itbe ascertained whether the situation isnormal or whether a fault has occurred.









Indicator and warning lamps

1
Monitoring
27
Stop & Start
fixed. When the vehicle stops (red lights,
traffic jams, ...) the Stop & Star t systemhas put the engine into STOP mode. The warnin
g lamp goes off and the engine restarts
automatically in START mode, as soon as you want to move off.

flashes for a few seconds, then goes off.
STOP mode is temporarily unavailable. or
START mode is invoked
automaticall
y. For more in
formation on special cases with STOP mode and STA R T m o d e , r efer to the "Stop & Start"section.
Engine coolanttemperature

fixed blue
On star ting the engine, it indicates
that the engine is cold. After a few minutes driving, it swiches off to indicate
that the engine temperature is normal.
In order to protect your engine, avoid driving too hard
until the warnin
g lamp has switched off.
Warning lampis onCauseAction / Observations

Monitoring
42
Tr ip computer, a few definitions
Range
(miles or km)The distance which can still be
travelled with the fuel remainingin the tank. Related to theaverage fuel consumption over
the last few miles (kilometres)
travelled.
Current fuel consumption
(mpg or l/100 km or km/l) Calculated over the last few seconds.


Average fuel consumption
(mpg or l/100 km or km/l)
Calculated since the last trip
computer reset.
Average speed
(mph or km/h)Calculated since the last trip computer reset.

Distance travelled
(miles or km)
Calculated since the last tripcomputer reset.

When the ran
ge falls below 20 miles (30 km),
dashes are displayed. After filling with at least 5 litres of fuel, the range is recalculated and is
displayed when it exceeds 60 miles (10 0 km).


Distance remaining to destination
(miles or km)
This is the distance remaining to be
travelled to the final destination. Itcan be entered by the user.
If the distance is not entered, dashes
are displayed in place of the digits.

Stop & Start time counter
(minutes / seconds or hours /
minutes) If your vehicle is fitted with Stop &Start, a time counter calculates the
time spent in STOP mode during ajourney. It resets to zero every time the
ignition is switched on with the key.



If dashes are displayed continuously while driving in place of the digits, contact a CITROËN dealer or a qualified workshop.


This value may vary following a changein the style of driving or the relief,resulting in a significant change in thecurrent fuel consumption.
This function is only displayed from 20 mph (30 km/h).

2
Multifunction screens
49

"Telephone" Menu
With Audio system on, once this menu is selected you can configure your Bluetooth
hands-free system (pairing), view the various
telephone directories (list of calls, ser vices...)and manage your calls (call, hang up, secondcall, secret mode...).
For more information on the "Telephone"
function, refer to the Audio system par t of the"Audio and telematics" section.
Choice of language
Once this menu has been selected, you canchange the language used by the display
(Deutsch, English, Espanol, Français, Italiano,
Nederlands, Portu
gues, Portugues-Brasil,
Türkçe * ).

For safety reasons, configuration by the
driver of the multifunction screen mustonly be done when stationary.



Display confi guration

Once this menu has been selected, you can gain access to the following settings:


- brightness-video setting,

-
date and time setting,

- selection of units.
Once the fuel consumption units havebeen changed to mpg, the informationin the screen relating to speed and distance also changes to mph and miles respectively.
*
Accordin
g to country of destination. Settin
g the date and time)Select the " Set date and time" function
using the " " or " " button. )Press "OK"
to confirm the selection. )Adjust the settings one by one using the " " or "
" button then confirm with "OK".)Then select the "OK"
box in the screenand confirm.