Citroen C3 PICASSO 2013 1.G Manual Online

4
Access
79
















Misfuel prevention (Diesel) *


Operation

When a petrol filler nozzle is introduced into the
fuel filler neck of your Diesel vehicle, it comes
into contact with the flap. The system remainsclosed and prevents filling.Do not persist but introduce a Diesel type filler nozzle.
*
According to country of sale.
It remains possible to use a fuel can tofill the tank. In order to ensure a good flow of fuel,do not place the nozzle of the fuel can in direct contact with the flap of the misfuel prevention device and pour slowly.
Travelling abroad

As Diesel fuel pump nozzles may be different in other countries, the presence of the misfuel prevention device may make refuelling impossible.Before travelling abroad, we
recommend that you check with the CITROËN dealer network, whether your vehicle is suitable for the fuel pumps in the country in which you want to travel.
Mechanical device which prevents fillin
g the tank of a Diesel vehicle with petrol. It avoids the risk of engine damage that can result from filling with the wrong fuel.
Located in the filler neck, the misfuel prevention device appears when the filler cap is removed.

Visibility
80














Lighting controls System for selection and control of the various front and rear lamps providing the vehicle's lighting.
Main lighting
The various front and rear lamps of the vehicleare designed to adapt the driver's visibility progressively according to climatic conditions:
- sidelamps, to be seen,
- dipped beam headlamps to see without
dazzlin
g other drivers,
- main beam headlamps to see clearly when
the road is clear.

Additional lighting
Other lamps are installed to fulfil therequirements of par ticular conditions of
visibility:
- a rear foglamp to be seen from afar,
- front foglamps for even better forward
vision.
Programming
Various automatic lighting control modes are also available according to the following
options:
-
guide-me-home lighting,
- automatic illumination of headlamps.




Model without AUTO lighting




Model with AUTO li
ghting


Automatic illumination of headlamps.


Manual controls

The lighting is controlled directly by the driver
by means of the ring Aand the stalk B.
A.Main lighting mode selection ring: turn it
to position the symbol required facing themark.
Li
ghting off / daytime running lamps.
Sidelamps.
B
.Stalk for switching headlamps: pull the stalk
towards you to switch the lighting betweendipped and main beam headlamps.
In the lamps off and sidelamps modes, the driver can switch on the main beam headlamps temporarily ("headlamp flash") by maintaining a pull on the stalk.

Dipped headlamps or main
beam headlamps.

Displays

Illumination of the corresponding indicator
lamp in the instrument panel confirms that the
li
ghting selected is on.

5
Visibility
81


Model with rear foglamp only
Rear foglamp
)
To switch on the foglamp, turn the ring Cforwards.
When the lighting is switched off automatically(with AUTO model), the foglamp and the dipped
beam headlamps will remain on.
) To switch off all of the lighting, turn thering C
rearwards.





Model with front foglamps and a
rear foglamp
Front and rear foglamps
Rotate and release the rin
g C:)
forwards a first time to switch on the front
foglamps,) forwards a second time to switch on the rear foglamp,)
rearwards a first time to switch off the rear foglamp,)
rearwards a second time to switch of thefront fog lamps.
C.
Foglamp selection ring.
The foglamps operate with the dipped and main
beam headlamps. When the lighting is switched off automatically (with AUTO model) or when the dipped
headlamps are switched off manually, thefoglamps and sidelamps will remain on.
) Turn the ring rear wards to switch off
the foglamps, the sidelamps will then switch off.



In good or rainy weather, by both dayand night, the front foglamps and the rear foglamp are prohibited. In thesesituations, the power of their beamsmay dazzle other drivers.
Do not forget to switch off the front foglamps and the rear foglamp whenthey are no longer necessary.

Visibility
82
Manual guide-me-home
lighting
The temporary illumination of the dipped beam
headlamps after the vehicle's ignition has been switched off makes the driver's exit easier when
the light is poor.

Switching on
)
With the ignition off, "flash" the headlamps using the lighting stalk.)
A fur ther "headlamp flash" switches thefunction off.


Switching off
The manual guide-me-home lighting switches
off automatically after a set time.

Lighting on audible warning

When the ignition is switched off, allof the lamps switch off automatically, unless guide-me-home lighting isactivated.

If the lighting is switched on manually after switching off the ignition, there is an audible signal when a front door is opened to warn the driver that theyhave forgotten to switch off the vehicle'slighting, with the ignition off.


In some weather conditions (e.g. low temperature or humidity), the presence of misting on the internal sur face of theglass of the headlamps and rear lampsis normal; it disappears after the lamps have been on for a few minutes.

5
Visibility
83
Linked with the Guide-me-home lighting
Association with the automatic illumination
of headlamps provides the guide-me-home lighting with the following additional options:
- automatic activation of guide-me-home lighting when automatic illumination of
headlamps is switched on (in the vehicle
parameters of the multifunction screen configuration menu),
- selection of the duration of maintaining of
the lighting for 15, 30 or 60 seconds in the
vehicle parameters of the multifunction
screen configuration menu (except for monochrome screen Awhere this is
preset).



Operating fault

In the event of a malfunction of
the sunshine sensor, the lamps
come on, this warning lamp is
displayed in the instrument panel and/or a
message appears in the multifunction screen,
accompanied by an audible signal.
Contact a CITROËN dealer or a qualified
workshop.
In fog or snow, the sunshine sensor maydetect sufficient light. Therefore, the lamps will not come on automatically.
Do not cover the sunshine sensor,linked with the rain sensor and located in the centre of the windscreen behindthe rear view mirror; the associatedfunctions would no longer be controlled.

Automatic illumination of
headlamps
The sidelamps and dipped beam headlamps are switched
on automatically, without any action on the par t of the
driver, when a low level of external light is detected or incer tain cases of activation of the windscreen wipers.
As soon as the brightness returns to a sufficient level or
after the windscreen wipers are switched off, the lamps
are switched o
ff automatically.
Activation
)Turn ring Ato the A"AUTO"
position. The automatic
illumination of headlamps is accompanied by a message in the multifunction screen.


Deactivation
)Turn ring A
to a position other
than "AU TO "
. Deactivation is accompanied
b
y a message in the multifunction screen.

Visibility
84





LED lamps
On star ting the vehicle, in daylight the LED
lamps come on automatically, if the lighting stalk is in position "0"
or "AUTO"
.
If the sidelamps and headlamps are switched
on manually or automatically, the LED lamps
switch off.


Programming

For countries where exterior lighting by day is
not a legal requirement, you can activate or
deactivate the function via the multifunction
screen configuration menu.
In countries where daytime lampsare a legal requirement:

- this function is activated by default;it cannot be deactivated,

- in daylight, the sidelamps andnumber plate lamps also come on,

- If the sidelamps or headlamps are switched on manually or automatically, the LED lampsswitch off. In these countries, for versionsnot fitted with LED lamps, it is the dipped beam headlamps that come on automatically on star ting the vehicle
.
Allowing the signature of the vehicle to be identified, this daytime external lighting comprises two sets of six light emitting diodes (LEDs), located below each front foglamp.

5
Visibility
85








Cornering lighting
makes use of the beam from a front foglamp to
illuminate the inside of a bend, when the vehicle speed is below 25 mph (approximately 40 km/h)(urban driving, winding road, intersections, parking manouevres...).
with cornerin
g lighting
without cornering lighting

Switching on

This function starts:


- when the corresponding direction indicator
is switched on,
or

- from a cer tain angle of rotation of the steering wheel.


Switching off

The system does not operate:


- below a cer tain angle of rotation of thesteering wheel,

- above 25 mph (40 km/h),

- when reverse gear is engaged.

Visibility
86








Headlamp
adjustment
To avoid causing a nuisance to other road
users, the height of the halogen headlampsshould be adjusted according the load in the
vehicle.0.1 or 2 people in the front seats. -.Less than 5 people. 1. 5 people.
-.5 people + maximum authorised load. 2 - 3. Driver + maximum authorised load.
The initial setting is position "0".
Tr a v e l l i ng abroad
If using your vehicle in a country thatdrives on the other side of the road, the headlamps must be adjusted to avoiddazzling on-coming drivers. Contact a CITROËN dealer or aqualified workshop.

5
Visibility
87








Wiper controls

Manual controls
The wiper commands are issued directly by the
driver by means of the stalk Aand the ring B.
Model with intermittent wiping
Model with AUTO wiping
Fast (heavy rain).
Normal
(moderate rain).
Intermittent
(proportional to the
speed of the vehicle).

Automatic, then single wipe
(see
the corresponding section).
Off.

Sin
gle wipe (press down and release).
Programming
Various automatic wiper control modes are also
available according to the following options:


- automatic rain sensitive windscreen wipers,

- rear wiping on engaging reverse gear.



Windscreen wipers
A.Wiping speed selection stalk.
or
S
ystem for selection and control of the various
front and rear wiping modes for the elimination
of rain and cleaning.
The vehicle's front and rear wipers are
designed to improve the driver's visibility progressively according to the climaticconditions.

Visibility
88
Windscreen wash
Pull the wiper stalk towards you. The
windscreen wash, then the windscreen wipers,
operate for a pre-determined time. B
. Rear wiper selection ring:
park,
intermittent wi
pe,
wash-wipe
(set duration).


Reverse gear

When reverse gear is engaged, the rear wiper
will operate if the windscreen wipers are
operatin
g.


Programming

The function is activated or deactivated via the
multifunction screen configuration menu.
This function is activated by default.
Rear wiper
Wiping zone

The cur ved shape of the rear screen results in
a smaller wiping zone.


If a significant accumulation of snow or ice is present, or when using a tailgate bicycle carrier, deactivate the automatic rear wiper via the multifunction screenconfiguration menu.