Can Citroen C4 2005 2.G Owner's Manual

Downloaded from www.Manualslib.com manuals search engine 34
GENERAL
MIDDLE EAST
7000 15W50
7000 10W40
7000 15W50
7000 15W50 Saudi Arabia - Bahrain
Dubai
United Arab Emirates
Iran
Israel - Jordan - Kuwait - Lebanon
Oman - Qatar - Syria - Yemen
LUBRICANTS - TOTAL recommended oils
ENGINE OILS
TOTAL QUARTZ
Blended oils for all enginesOils specifically for petrol and
dual-fuel petrol / LPG enginesOils specifically for diesel
engines TOTAL QUARTZ DIESEL
9000 5W40
7000 10W40
Angl.-t2-page001-39-2005 9/01/06 10:07 Page 34

Downloaded from www.Manualslib.com manuals search engine 35
GENERAL
LUBRICANTS - TOTAL recommended oils
GEARBOX OILS
TOTAL TRANSMISSION BV
Norms S.A.E: 75W80
Part No.: 9730 A2
TOTAL FLUIDE ATX
T O TA L F L U I D E AT 4 2
Special oil distributed by
CITROËN
Part No.: 9730 A6
Special oil distributed by
CITROËN
Part No.: 9736 22 Manual and piloted manual
gearboxes
MB3 automatic gearbox
4HP20 and AL4 autoactive
automatic gearboxes
All countries
Special oil distributed by
CITROËN
Part No.: 9980 D4
TOTAL TRANSMISSION X4
Part No.: 9730 A7 AM6 autoactive automatic gearbox
Transfer box and rear axle
Angl.-t2-page001-39-2005 9/01/06 10:07 Page 35

Downloaded from www.Manualslib.com manuals search engine 36
GENERAL
LUBRICANTS - TOTAL recommended oils
POWER STEERING OILS
ENGINE COOLANT FLUID
TOTAL FLUIDE ATX
TOTAL FLUIDE LDS
Special oil distributed by CITROËN
Part No.: 9979 A3
Power steering
All countries
All countriesCITROËN fluid
Protection: -35C°2Litres
5Litres
20 Litres
210Litres9979 70
9979 71
9979 76
9979 779979 72
9979 73
9979 74
9979 75 PacksCITROËN Part No.
REVKOGEL 2000 GLYSANTIN G33TOTAL FLUIDE DA
Special oil distributed by CITROËN
Part No.: 9730 A1
Very cold countries Power steering all vehicles
(except CITROËN C4and C5)
Power steering
C4and C5
Angl.-t2-page001-39-2005 9/01/06 10:07 Page 36

Downloaded from www.Manualslib.com manuals search engine 37
GENERAL
LUBRICANTS - TOTAL recommended oils
BRAKE FLUID
Synthetic brake fluid
HYDRAULIC SYSTEM
WARNING: TOTAL FLUIDE LDS fluid cannot be blended withTOTAL LHM PLUS.
WARNING: CITROËN C5: Use exclusively TOTAL FLUIDE LDS suspension fluid.
All countriesTOTAL HYDRAURINCAGE
All countriesCITROËN fluid0,5Litre
1 Litre
5 Litres9979 05
9979 06
9979 07 PacksCITROËN Part No.
PacksCITROËN Part No.
Norm
Colour All countries
TOTAL FLUIDE LDS
TOTAL LHM PLUS
TOTAL LHM PLUS
Very cold countriesOrange 9979 A3
9979 A1
9979 A2 Green1 Litre
Angl.-t2-page001-39-2005 9/01/06 10:07 Page 37

Downloaded from www.Manualslib.com manuals search engine 38
GENERAL
SCREEN WASH FLUID
GREASING
General use
All countriesConcentrated: 250ml
Fluid ready
to use9980 33
9980 06
9980 05ZC 9875 953U
ZC 9875 784U
ZC 9885 077U9980 56
ZC 9875 279U Packs
CITROËN Part No.
LUBRICANTS - TOTAL recommended oils
1Litre
5Litres
Norms NLGI
2
TOTAL MULTIS 2
TOTAL SMALL MECHANISMS All countries
Note: NLGI= National Lubrificating Grease Institude.
Angl.-t2-page001-39-2005 9/01/06 10:07 Page 38

Downloaded from www.Manualslib.com manuals search engine 39
GENERAL
ENGINE OIL CONSUMPTION
I -Oil consumption depends on:
- the engine type.
- how run-in or worn it is.
- the type of oil used.
- the driving conditions.
II - An engine can be considered RUN-INafter:
- 3,000 miles
(5,000 km)for a PETROLengine.
- 6,000 miles (10,000 km)for a DIESELengine.
III - MAXIMUM PERMISSIBLEoil consumption for a RUN-IN engine:
- 0.5 litres per 600 miles
(1,000 km)for a PETROLengine.
- 1 litre per 600 miles (1,000 km)for a DIESELengine.
DO NOT INTERVENE BELOW THESE VALUES.
IV - OIL LEVEL:The level should NEVERbe above the MAX.mark on the dipstick after changing or topping up the oil:
- This excess oil will be used up rapidly.
- It will reduce the engine output and adversely affect the operation of the air circuits and gas recycling.
Angl.-t2-page001-39-2005 9/01/06 10:07 Page 39

Downloaded from www.Manualslib.com manuals search engine 156
ENGINE
B1BP2LSC
B1BP2LTC
AUXILIARY EQUIPMENT DRIVE BELT
Engines: KFU - NFU
Tools.
[1]Pliers for removing plastic pegs: 7504 -T
[2]Belt tension measuring instrument (SEEM) : 4122 -T
[3]Compression lever for dynamic tensioner: (-).0194.D
[4] Peg for dynamic tensioner roller of Ø 4 mm : (-) 0194.F
WARNING: (With or without air conditioning)
The auxiliaries drive belt cannot be re-used
with a manual tensioner roller.
The auxiliaries drive belt can be re-usedwith a dynamic tensioner roller.
Removing.
Raise and support the vehicle, front wheels hanging.
Disconnect the battery.
Remove the front RH wheel and the front RH splash-shield, using tool [1].
V
ehicle without air conditioning.Slacken bolts (2), screw (3)and the tensioning screw (1).
Push back the alternator towards the engine.
Remove the auxiliary equipment drive belt.
Refitting.
Refit the new auxiliary equipment drive belt.
Respect the following sequence: Crankshaft pinion, alternator pulley.
Position tool [2]on the belt.
Tighten the screw (1)to tension the belt to: 120 ± 4 SEEM units.
Tighten screw (3), bolts (2).
Remove tool [2].
Complete the refitting.
C4
Angl.-t2-page135-239-2005 9/01/06 10:14 Page 156

Downloaded from www.Manualslib.com manuals search engine 165
ENGINE
XSARA
AUXILIARY EQUIPMENT DRIVE BELT
Tools.
[1] Dynamic tensioner compression lever: (-).0188.Z
[2] Peg for dynamic tensioner roller: (-).0194.F
Removing.
IMPERATIVE: Respect the safety and cleanliness requirements specific to High pressure
Diesel injection (HDi) engine versions.
Remove:
- the front RH wheel.
- the sound insulation under the engine.
- the splash-shield.
WARNING: Mark the direction of fitting of the accessories belt if it is to be re-used.
Compress the dynamic tensioner roller (1)by acting at «a»
(clockwise), using tool [1].
Peg at «b». using tool [2].
Keep the dynamic tensioner roller (1)compressed and remove the auxiliaries drive belt.
IMPERATIVE: Check that the rollers (1) and (2) can turn freely
(without play and without
tight spots).
B1BP2VZD
Engines: 8HX - 8HZ
Angl.-t2-page135-239-2005 9/01/06 10:14 Page 165

Downloaded from www.Manualslib.com manuals search engine 169
ENGINE
B1BP2Z6D
B1BP2ZCD
AUXILIARY EQUIPMENT DRIVE BELT
Engines: 9HZ - 9HY
Tools.
[1]Dynamic tensioner compression lever: (-).0188.Z
[2]Peg for dynamic tensioner roller: (-).0194.F
Removing.
Remove the front RH wheel, the under-engine sounddeadening and the splash-shield.
V
ehicle with air conditioning.
WARNING: Mark the direction of fitting of the accessories drive belt, if it is to be re-used.
Compress the tensioner roller(1)by acting at «a»
(clockwise), using tool [1].
Peg at «b», using tool [2].
Remove the accessories drive belt.
IMPERATIVE: Check that the rollers (1) and (2) can turn freely
(without play and without tight
spots).
Refitting.
WARNING: Belt to be re-used, mark the direction of fitting of the belt.
Refit the accessories drive belt.
Compress the tensioner roller (1)by acting at «a»
(clockwise), using tool [1].
Remove tool [2].
IMPERATIVE: Make sure the belt is correctly positioned in the grooves of the various pulleys.
Complete the refitting in the opposite order to removal.
XSARA PICASSO
Angl.-t2-page135-239-2005 9/01/06 10:14 Page 169

Downloaded from www.Manualslib.com manuals search engine 174
ENGINEXSARA
AUXILIARY EQUIPMENT DRIVE BELT
Power-assisted steering, with air conditioning
Tools.
[1] Dynamic tensioner peg: (-) 0188 H
[2] Belt tension measuring instrument: 4122-T
Removal.
Peg the dynamic tensioner (1) at "a", using tool [1].
Loosen the screw (2)of the roller (3).
Turn the roller (3)backwards.
Remove the belt.
NOTE:If it can not be pegged at "a":
- Loosen the screw (2)of the roller (3).
- Using a 7 mmsquare drive, turn the roller (3)at "b".
- Peg the tensioner (1) at "a", using tool [1].
NOTE: If the belt is broken:
- Support the engine using a jack
(insert a wooden block between the housing and the jack).
- Remove the right engine support.
- Using a square drive at (b)turn the tool (3)in the direction of the arrow "a", so that it can be
pegged at "a"using the tool [1].
B1BP1SKC
Engine: WJY
Angl.-t2-page135-239-2005 9/01/06 10:14 Page 174