battery Citroen C4 AIRCROSS 2014 1.G Owner's Manual
[x] Cancel search | Manufacturer: CITROEN, Model Year: 2014, Model line: C4 AIRCROSS, Model: Citroen C4 AIRCROSS 2014 1.GPages: 368, PDF Size: 20.37 MB
Page 5 of 368
Contents
Direction indicators 147
Hazard warning lamps 147
Horn 147
Braking assistance systems 148
Trajectory control systems 150
Front seat belts 152
Airbags 156
Child seats 161
Deactivating the passenger's front airbag 163
ISOFIX child seats 170
Child lock 176
Safety
Temporary puncture repair kit 177
Changing a wheel 181
Snow chains 187
Changing a bulb 188
Changing a fuse 194
12 V battery 200
Automatic power cut-off to accessories 203
Changing a wiper blade 203
Recovering the vehicle 204
Towing a trailer 207
Fitting roof bars 209
Accessories 210
Practical information
Bonnet 213
Petrol engines 214
Diesel engines 215
Fuel tank 216
Running out of fuel (Diesel) 218
Checking levels 219
Checks 222
Checks
Petrol engines 225
Petrol weights 226
Diesel engines 232
Diesel weights 233
Dimensions 239
Identifi cation markings 241
Te c h n i c a l d a t a
Bluetooth® telephone
with voice recognition 243
TOUCH SCREEN AUDIO -TELEMATIC
system 255
TOUCH SCREEN AUDIO - CD system 293
AUDIO - CD system 313
Audio and telematics
Alphabetical index
Visual search
Page 29 of 368
1
27
Monitoring
Warning lamp
is on
Cause
Action / Observations
Battery charge
*
fixed. The battery charging circuit has a
fault (dirty or loose terminals, slack or
cut alternator belt, ...). The warning lamp should go off when the engine is
started.
If it does not go off, contact a CITROËN dealer or a
qualified workshop.
Anti-lock
Braking System
(ABS)
fixed. The anti-lock braking system has a
fault. The vehicle retains conventional braking.
Drive carefully at reduced speed and contact a
CITROËN dealer or a qualified workshop without
delay.
Front seat belt
not fastened /
unfastened
fixed, then flashing,
accompanied by an
audible signal. The driver has not fastened or has
unfastened their seat belt. Pull the strap, then insert the tongue in the buckle.
*
According to destination country.
Airbags and
pretensioners
temporarily. When you switch on the ignition, this
warning lamp comes on for a few
seconds, then goes off. If it does not go off, contact a CITROËN dealer or a
qualified workshop.
fixed. Fault with one of the airbag or seat
belt pretensioner systems. Have it checked by a CITROËN dealer or a qualified
workshop.
Page 34 of 368
32
Monitoring
Screen 1
Screen 2
Cause
Solution - Action
Observations
Warning messages (ignition at "OFF")
You have forgotten to switch off the
vehicle lighting. Switch off the vehicle lighting by
placing the control at OFF. There is an intermittent audible
signal.
The alarm has been triggered.
The battery for the Keyless Entry
and Starting system is flat. Replace the battery (see "Changing
the batteries").
The electronic key that you have on
your person is not recognised. Check that you have the correct
electronic key. If the message persists, contact a
CITROËN dealer.
The electronic key is still in the
vehicle and you have tried to lock
the doors or boot from the outside. Ensure that you have the electronic
key on your person before locking
the vehicle.
One of the doors or the boot is not
properly closed when locking the
vehicle from the outside. Close the door or the boot, then
lock the vehicle.
Page 37 of 368
1
35
Monitoring
Screen 1
Screen 2
Cause
Solution - Action
Observations
Warning messages (ignition at "ON")
Fault with the electric power
steering. Stop the vehicle, wait few moments
then start the engine again. If the message remains after
restarting, contact a CITROËN
dealer or a qualified workshop.
The battery for the "Keyless Entry
and Starting" system is flat. Replace the battery (see "Changing
the batteries").
The electronic key that you have on
your person is not recognised. Check that you have the correct
electronic key. If the message persists, contact a
CITROËN dealer.
The electronic key is still in the
vehicle and you have tried to lock
the doors or boot from the outside. Ensure that you have the electronic
key on your person before locking
the vehicle.
One of the doors or the boot is not
properly closed when locking the
vehicle from the outside. Close the door or the boot, then
lock the vehicle.
Fault with the "Keyless Entry and
Starting" system. Contact a CITROËN dealer.
Page 40 of 368
38
Monitoring
Screen 1
Screen 2
Cause
Solution - Action
Observations
You have moved off with the parking
brake not fully released. Release the parking brake.
The oil pressure is too low or there
is a fault with the engine lubrication
system. Stop the vehicle and contact a
CITROËN dealer or a qualified
workshop.
Battery charge fault. Stop the vehicle and contact a
CITROËN dealer or a qualified
workshop.
Airbag or pretensioner fault. Contact a CITROËN dealer or a
qualified workshop to have the
systems checked.
Fault with automatic headlamp
adjustment system. Contact a CITROËN dealer or a
qualified workshop. Only on vehicles fitted with xenon
headlamps.
Fault with the stability control
system (ASC). Contact a CITROËN dealer or a
qualified workshop.
Fault with the four wheel drive
transmission system. Contact a CITROËN dealer or a
qualified workshop.
Page 48 of 368
46
Monitoring
When the engine is
running, this indicates the
temperature of the coolant.
Range
When the engine is
running
, this indicates
the distance which can
still be travelled with the
fuel remaining in the tank
based on the average
fuel consumption over the
last few miles/kilometres
travelled.
This value may vary following a change
in the style of driving or the relief,
resulting in a large variation in the
current fuel consumption.
If you only add a few litres, the value
displayed will be incorrect. Therefore,
you must fill the tank whenever
possible.
Coolant temperature
gauge
If the bar is close to the critical
position located
on the right, the temperature is too high.
The symbol flashes when your engine is
overheating.
You must stop your vehicle as soon as it is
safe to do so.
Wait a few minutes before switching off the
engine.
When the range is less than 30 miles (50 km)
,
dashes are displayed.
Refuel as soon as possible. The display of the
range is updated.
Wait for the engine to cool before
topping up the level. The cooling system
is pressurised.
To avoid any risk of scalding, unscrew
the cap by two turns to allow the
pressure to drop.
When the pressure has dropped,
remove the cap and top up the level,
if necessary.
Contact a CITROËN dealer or a
qualified workshop.
When you disconnect the battery,
the previous fuel consumption data
is lost and the value displayed will be
different from that displayed before the
battery was disconnected. The distance
displayed must be considered an
approximate indication.
Page 52 of 368
50
Monitoring
If the battery is disconnected, the
settings memory is cleared and
the default unit (km/L) is restored
automatically.
If the battery is disconnected, the
settings memory is cleared and
the default unit (°C) is restored
automatically.
)
press the INFO
button to scroll the units
(km/L, L/100km, mpg (US), mpg (UK) and
RETURN) in succession,
)
press and hold the INFO
button for a few
seconds to confirm your selection.
Choice of the temperature
display unit
)
press and hold the INFO
button for a few
seconds to scroll the units (°C and °F) in
succession.
The mode selected is confirmed. In the menu screen:
)
press the INFO
button to select the
temperature unit setting symbol
(thermometer):
Choice of the fuel consumption
unit
The distance, speed and quantity of fuel units
will also be changed in accordance with your
choice of fuel consumption unit.
In the menus screen:
)
press the INFO
button to select "UNIT"
.
)
press and hold the INFO
button for a
few seconds to display the "AVG U N I T "
screen.
Page 53 of 368
1
51
Monitoring
If you select the "- - -" setting, no
message will be displayed in message
display situations.
If the battery is disconnected, the
settings memory is cleared and the
default language (ENGLISH) is restored
automatically.
)
press the INFO
button to scroll the
languages (Japonais, English, Deutsch,
Français, Espanol, Italiano, Russe "- - -" and
RETURN) in succession,
)
press and hold the INFO
button for a few
seconds to confirm your selection.
Choice of the display LANGUAGE
In the menu screen:
)
press the INFO
button to select
"LANGUAGE"
:
)
press and hold the INFO
button for a few
seconds to display the "LANGUAGE"
screen:
Page 54 of 368
52
Monitoring
If the battery is disconnected, the
settings memory is cleared and
the default choice (ON) is restored
automatically.
As a safety measure, it is
recommended that you stop for a break
every two hours. You can activate or deactivate the sound
associated with the INFO
button.
Activation / deactivation of the
"INFO" button sound
In the menu screen:
)
press the INFO
button to select
the INFO
button sound activation /
deactivation symbol (located in
menu 2/3)
:
)
press and hold the INFO
button for a few
seconds to scroll the choices (ON, OFF) in
succession.
The mode selected is confirmed.
Changing the display interval of
the "REST REMINDER" message
The "REST REMINDER" function allows you to programme
an alert message reminding you to take a break.
The "REST REMINDER" message appears accompanied
by an audible signal.
You can change the display inter val of the "REST
REMINDER"
message.
In the menu screen:
)
press the INFO
button to select "A L A R M "
(located in menu 2/3)
:
)
press and hold the INFO
button for a few
seconds to display the "A L A R M "
screen,
)
press the INFO
button to select the display
inter val of the "REST REMINDER"
message,
)
press and hold the INFO
button for a
few seconds to confirm.
If the battery is disconnected, the
settings memory is cleared and
the default value (OFF) is restored
automatically.
Page 57 of 368
1
55
Monitoring
If no action is carried out within
10 seconds, the selection menu closes
automatically. To select the mode:
)
Press the " PWR/VOL
" button to switch on
the audio system.
)
Press the MENU
button.
)
Press the SEL
knob to scroll through
the menus and select " RDS setting -
CT ON - CT OFF
" (clock time).
)
Turn the SEL
knob to the left or to the right
to select "CT OFF"
(manual mode)
or "CT ON"
(automatic mode).
)
Press the SEL
knob to confirm.
The digital clock does not display
seconds.
The time setting is lost if the battery is
disconnected.
Manual adjustment
)
Press the PWR/VOL
button to switch on
the audio system.
)
Press the MENU
button.
)
Press the SEL
knob to run scroll through
the menus and select " Time Setting
Adjust
".
)
Turn the SEL
knob to select " ON
" for
access to time setting.
)
Press the SEL
knob to confirm.
)
Turn the SEL
knob to adjust the time.
)
Press the SEL
knob to confirm.